INSTALLATION INSTRUCTIONS MODEL WGI-C14
INTERIOR WINDOW GUARDS
2000-2004 CHEVY TAHOE & GMC YUKON
TOOLS REQUIRED:
Safety goggles
Power drill
Phillips screwdriver
1/8” drill bit
HARDWARE REQUIRED:
QTY
24
36
DESCRIPTION
#10 x ½” Phillips flat head sheet metal screw
#10 x 3/4” Phillips pan head sheet metal screws
PART #
GSM33150
GSM33195
INSTALLATION PROCEDURE:
1. Determine the proper cage for each window. Each guard has part number on lower left corner.
2. Side Passenger Door Windows – Hold the screen up to the window frame. Make sure you have an
even fit. Mark mounting holes and drill out with the 1/8” drill bit. Use #10 x ½” flat head sheet
metal screws to attach screens to door window frame. Note: Do not over tighten screws. After the
1/8” holes are drilled, it is helpful to indent the holes inward with a punch. This will enable the
mounting screws to grab better.
3. Side Cargo Area Windows – Carefully remove interior plastic trim that surrounds windows.
Position window guard into window frame. (Guard will be approximately ½” from glass). Drill
mount holes in window frame with 1/8” drill bit and attach guard with #10 x ¾” sheet metal screws.
Install interior trim back to original location.
Note: Trim should fit back on without modification, although plastic sometimes needs to be shaved
to allow clips to go on properly.
4. Rear Door Windows – These guards are mounted the same way as the side cargo windows.
WGI-C14-INST-1-04
|