Instruction Manual
2/ 4/ 8 Port VGA Video Splitter - Wall Mountable
ST122W / ST124W / ST128W
Top View (ST124W shown)
DE: Bedienungsanleitung - de.startech.com
FR: Guide de l’utilisateur - fr.startech.com
ES: Guía del usuario - es.startech.com
IT: Guida per l’uso - it.startech.com
Power Indicator
Video IN port
NL: Gebruiksaanwijzing - nl.startech.com
PT: Guia do usuário - pt.startech.com
Video OUT ports
Features
• Max. supported resolutions up to 1600 x 1200
• Cascadable up to 3 levels
*actual product may vary from photos
• Supports transmission distances up to 65m /200’
Rear View (ST124W shown)
System Requirements
• A computer with a VGA Card installed
• DE-15 VGA male/female video cable
• DE-15 VGA male/male video cable(s)
Power Port
Installation
Cascaded Installation
In a Single Unit Installation, only one video splitter is used, in turn
limiting the number of displays to which the split signal can be
broadcast; a Cascaded configuration on the other hand, utilizes
multiple splitters connected to one another to providing numerous
additional video connections (i.e. ST122W can be cascaded to
provide up to 8 video outputs, ST124W up to 64 and ST128W up
to 512.
To cascade multiple splitters, use a high density DE-15 male/female
VGA cable to connect any available Video OUT port on the“higher
level”video splitter to the Video IN port of the lower level video
splitter. You can cascade as many video splitters as there are ports
available, however the signal will deteriorate as distance between
the monitor and source increases.
Please see reverse for a diagram depicting a cascaded
configuration.
Single Unit Installation
1.With the video source computer powered down, use a high
density DE-15 male/female VGA cable to connect the computer
Video Out port to the Video IN port on the splitter.
2.Using a high density DE-15 male/male VGA cable for each
connection, connect the monitors to the Video OUT ports
provided by the splitter.
3.Connect the Power Port on the video splitter to an available
power outlet, using the provided adapter.
4.Power up the source computer and newly connected monitors.
Manual Revision: 02/01/2012
|