This Development Kit may be used with either the
N56XX or 5X80 Series imaging scan engines.
Connect the Development Engine to a
PC
N56XX engine
5X80 engine
The image engine can connect to a PC for evaluation.
Note: The development board and the kit
components are not intended for integration
and should ONLY be used for evaluation of the
image engine.
N56XX and 5X80
USB Connection
ESD Precautions
Imaging Scan Engine Development Kit
1. Download and install the appropriate USB driver
Image engines are susceptible to ESD damage. Use
care when handling an engine outside its ESD safe
packaging. Grounding wrist straps and properly
grounded work areas must be used.
2. Turn off power to the PC.
Quick Start Guide
ISEDevKit-QS Rev A
6/11
3. Connect the interface cable included in the kit to
the engine and to the matching USB port on the
back of the computer.
Warning for N56XXX-XXX-XX5 engine only:
3. Connect the power supply connector to the serial
interface cable. Plug in the power supply.
Connecting power to both the micro-B
!
connector and the 10 pin RJ45 connector
simultaneously could damage the PC and/or the
engine.
4. Turn the PC back on. The engine beeps.
RS232 Connection
USB Full
Speed
1. Turn off power to the PC.
2. Connect the serial interface cable to the
development board and to the matching port on
the back of the PC.
USB High
Speed
4. Turn the PC back on. The engine beeps.
|