TR2 RX 700W
TR2 RX 700W
ATX 12V 2.3 & EPS 12V 2.91 Version
ATX 12V 2.3 & EPS 12V 2.91 Version
1. Warnings and Caution
2. Components Check
1. Do not unplug the AC power cord when the power supply is in
use. Doing so may cause damage to your components.
2. Do not place the power supply in a high humidity and/or
temperature environment.
TR2 RX power supply unit
3. High voltages exist in the power supply. Do not open the
power supply case unless you are an authorized service
technician or electrician. Doing so will void the warranty.
4. PSU should be powered by the source indicated on the rating
label.
User manual
AC power cord
Mounting screw x 4
5. All warrantees and guarantees will be voided, if failure to
comply with any of the warnings and cautions covered in this
manual.
01
02
TR2 RX 700W
TR2 RX 700W
ATX 12V 2.3 & EPS 12V 2.91 Version
ATX 12V 2.3 & EPS 12V 2.91 Version
3. Power Connector Introduction
4. Installation Steps
Cable
Note: Make sure that your system is turned off and unplugged. Disconnect
the AC power cord from your old power supply.
Main
PCI-E
8Pin
ATX 12V EPS 12V
PCI-E
(8Pin)
PCI-E
(6Pin)
SATA
(5Pin)
FDD
(4Pin)
Peripheral
(4Pin)
CPU 4Pin
to 4Pin
Power
Connector
(20+4Pin)
(4Pin)
(8Pin)
to 6Pin
Model
1. Open your computer case; please refer to the direction in your
case manual.
W0366
700W
1
1
1
1
2
6
6
1
1
1
2. Install the PSU into the case with the four screws provided.
3. Connect the 24 pin Main Power Connector to your
motherboard and peripheral. If your motherboard uses a 20-
pin connector, detach the 4-pin attachment on the 24-pin
connector.
Note: The detachable 4-pin section cannot be used in place of
a 4-pin +12V connector.
Connector Type
Connectors & Cable length
MODEL
1 x 20+4pin Main connector
(500mm)
20+4pin
4.1 For motherboard that
requires a single 4pin
auxiliary (CPU) power
connector, please use the
4pin ATX connector from
the power supply.
1 x EPS 12V 8 pin + ATX 12V 4pin connector
(500mm+150mm)
EPS 12V 8 pin + ATX 12V 4pin
Molex & FDD
3 x Peripheral & 1 x FDD connectors
(500mm + 150mm + 150mm + 150mm)
3 x Peripheral connectors
(500mm + 150mm + 150mm)
3 x S-ATA connectors
(500mm + 150mm + 150mm)
SATA
700W
4.2 For motherboard that requires a single 8pin EPS connector,
please use the 8pin EPS connector from the power supply.
3 x S-ATA connectors
(500mm + 150mm + 150mm)
1 x 8pin PCI-E connector
(500mm)
PCI-E 8pin
5. Connect other peripheral power connectors to devices such as
hard drives, optical drives, etc.
2 x 6pin PCI-E connectors
(500mm+150mm)
PCI-E 6pin
1 x 8pin to 6pin adapter
(150mm)
6. Close your computer case and connect the AC power cord to
the power supply AC inlet.
PCI-E 8pin to 6pin adapter
CPU 4pin to 4pin adapter
1 x 4pin to 4pin adapter
(150mm)
03
04
TR2 RX 700W
TR2 RX 700W
ATX 12V 2.3 & EPS 12V 2.91 Version
ATX 12V 2.3 & EPS 12V 2.91 Version
5. Product Features
6. Output Specification
Model
700W
AC INPUT
DC OUTPUT
100V-240V 10A-5A 50Hz-60Hz
+3.3V
24A
+5V
15A
+12V1 +12V2
-12V
0.3A
0A
+5Vsb
2.5A
- Fully complies with latest Intel ATX 12V V2.3 for utmost stable
and robust power delivery system.
Max Output Current
Min Output Current
30A
22A
0.5A
0.5A
0.5A
0.5A
0.05A
- Universal Input & Active PFC:100-240VAC input with automatic
adjustment and active PFC for global usage.
The +5V and +3.3V Max-combined power is 130W.
- Dedicated dual +12V rails ensures efficient power delivery to
critical components within the PC.
- Modularized cable management dramatically improves internal
airflow to enable quieter running computer system and
computing experience.
- Oversized & ultra-quiet 140mm ball bearing fan accelerates heat
removal and decreases overall noise output.
7. Total Protection
- Latest 6pin and 8pin PCI-Express power connectors to support
advanced graphic cards in Nvidia SLI or ATI CrossFire X
technology.
* Over Current Protection
- Supports all Intel & AMD processors.
- High reliability: MTBF>100,000 hours.
The power supply should provide OCP and should shutdown
before 240VA of each output power (included +5V, +3.3V).
- Protections: Over Current, Over Voltage and Short Circuit
Protection.
* Over Voltage Protection
- Safety / EMI Approvals: UL, TUV, FCC, CE, BSMI and GOST
certified.
Voltage Source
+3.3V
Protection Point
+4.5V Max.
- Dimension (W/H/D): 150mm x 86mm x 160mm.
+5V
+7.0V Max.
+12V
+15.6V Max.
* Short Circuit Protection
Activated when any DC rails short circuited.
05
06
TR2 RX 700W
TR2 RX 700W
ATX 12V 2.3 & EPS 12V 2.91 Version
ATX 12V 2.3 & EPS 12V 2.91 Version
10. Trouble-Shooting
8. EMI & SAFETY
EMI Regulatory & SAFETY Standards
UL, TUV, FCC, CE, BSMI and GOST.
W0366 TR2 RX 700W
If the power supply fails to function properly, please follow the
troubleshooting guide before application for service:
1. Is the power cord plugged properly into electrical outlet and
into the power supply AC inlet?
2. Please make sure the "I/O" switch on the power supply is
switched to "I" position.
3. Please make sure all power connectors are properly
connected to all the devices.
9. Environments
4. If connected to a UPS unit, is the UPS on and plugged in?
If the power supply is still unable to function properly after
following the above instruction, please contact you local store
or Thermaltake branch office for after sales service. You may
also refer to Thermaltake's website for more technical
support:
10 oC to + 25 oC
Operating temperature
Operating humidity
MTBF
20% to 85%, relative humidity
> 100,000 hours
07
08
|