Operating Instructions
SDI Card
Model No.
AW-HHD870N
Before operating this product, please read the instructions carefully and save this manual for future use.
VQTB0353
D
F0109S0
For CANADA
This Class A digital apparatus complies with Canadian
ICES-003.
Cet appareil numérique de la class A est conforme à
la norme NMB-003 du Canada.
FCC Note:
This equipment has been tested and found to comply
with the limits for a class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference when the equipment is operated in a
commercial environment. This equipment generates,
uses, and can radiate radio frequency energy, and if
not installed and used in accordance with the
instruction manual, may cause harmful interference
to radio communications. Operation of this equipment
in a residential area is likely to cause harmful
interference in which case the user will be required to
correct the interference at his own expense.
Warning:
To assure continued FCC emission limit compliance,
the user must use only shielded interface cables when
connecting to external units. Also, any unauthorized
changes or modifications to this equipment could void
the user’s authority to operate it.
indicates safety information.
- 3 -
IMPORTANT SAFETY INSTRUCTIONS
Read these operating instructions carefully before using the unit. Follow the safety instructions on the unit and the
applicable safety instructions listed below. Keep these operating instructions handy for future reference.
1) Read these instructions.
ꢀ) Keep these instructions.
3) Heed all warnings.
10) Protect the power cord form being walked on or
pinched particularly at plugs, convenience
receptacles, and the point where they exit from
the apparatus.
11) Only use attachments/accessories specified by
the manufacturer.
ꢁ) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
1ꢀ) Use only with the cart, stand, tripod,
bracket, or table specified by the
manufacturer, or sold with the
apparatus. When a cart is used, use
7) Do not block any ventilation openings. Install in
accordance with the manufacturer’s instructions.
caution
when
moving
the
8) Do not install near any heat sources such
as radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce heat.
cart/apparatus combination to avoid
injury from tip-over.
13) Unplug this apparatus during lightning storms or
when unused for long periods of time.
9) Do not defeat the safety purpose of the polarized
or grounding-type plug. A polarized plug has two
blades with one wider than the other. A grounding-
type plug has two blades and a third grounding
prong. The wide blade or the third prong are
provided for your safety. If the provided plug does
not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.
1ꢁ) Refer all servicing to qualified service personnel.
Servicing is required when the apparatus has
been damaged in any way, such as power-supply
cord or plug is damaged, liquid has been spilled or
objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture,
does not operate normally, or has been dropped.
indicates safety information.
- ꢁ -
Contents
Preface ............................................................................... 5
Standard accessories ......................................................... 5
Warning/caution for safety .................................................. 6
Precautions ......................................................................... 7
Major operating controls and their functions ....................... 8
Mounting ............................................................................. 9
Connection ....................................................................... 11
Appearance ...................................................................... 1ꢀ
Specifications ................................................................... 13
Preface
This product is an option card which can be installed in
Zoom focus control of lenses equipped with a remote
control function possible from a AW-CBꢁ00 (or similar)
remote operation panel.
the option slot of the AW-HE870 HD convertible camera.
It is made for HD-SDI/SD-SDI signal output and is
equipped with two BNC output jacks (dual channel).
Caution
The AW-HHD870 can be installed only to the
AW-HE870 settings can be used to switch between
AW-HE870.
HD-SDI and SD-SDI output.
Standard accessories
Screw (6 mm long) ............... ꢀ pcs
Screw (Black, 8 mm long) ..... ꢁ pcs
- 5 -
Warning/Caution for safety
WARNING
CAUTION
Refer all servicing to qualified personnel
To reduce the risk of electric shock, don’t remove cover
or back, unless you are a qualified personnel. Refer all
mountings, connections, servicing to qualified service
personnel.
Do not drop the product, do not expose it to strong shock,
or do not step on it, to prevent a fire and injuries.
Do not install the product at a place full of moisture and
dust, which may cause a fire and electric shock.
No water or moisture inside
Do not let water or moisture into the product, or expose it
to moisture, to prevent a fire and electric shock.
If you see smoke or smell an odor from the product, if
water or other foreign matter gets inside, if it is damaged
by dropping, or if you find anything wrong with it,
immediately stop using it.
Do not disassemble or modify the product to prevent
a fire and electric shock.
- 6 -
Precautions
Power off before connecting or disconnecting cables
Before plugging or unplugging the cables, be sure to
switch power off.
Operating temperature range
Avoid using the product at a cold place below 1ꢁ °F
(–10 °C) or at a hot place above 113 °F (+ꢁ5 °C) because
extremely low or high temperature will adversely affect
the parts inside.
Handle carefully.
Do not drop the product, or subject it to strong shock or
vibration. This is important to prevent trouble.
Caution
When the SDI card is to be discarded at the end of its
service life, ask a specialized contractor to dispose of
it properly in order to protect the environment.
Avoid humidity and dust.
Avoid using the product at a humid, dusty place because
much humidity and dust will cause damage to the parts
inside.
- 7 -
Major operating controls and their functions
ZOOM/FOCUS connector
SDI output connector [SDI OUT1, 2]
This is the standard input connector for the lenses
equipped with a remote control function for zoom focus.
When using a Panasonic pan-tilt head (such as the
AW-PH360, AW-PHꢁ00, AW-PHꢁ05 or AW-PH650), use
the LENS I/F connector on the pan-tilt head instead of
this connector.
Serial digital component signal can be output.
- 8 -
Mounting
1 Switch the camera off, and disconnect the power
Caution
connector and other cables from the camera.
Be sure to ask your store, where you purchased the
product, for mounting.
Disconnect the camera power connector before
mounting.
2 Loosen the four screws on the rear of the camera and
remove the rear panel.
Before handling the card, touch a metal part of the
camera to discharge the static from the human body.
An anti-static wrist strap is recommended for added
safety.
If you touch the card while you are still charged with
static, it may cause trouble.
Keep the metal parts of the card free of contact with
other metal parts.
3 Loosen the two screws for the option card slot and
remove the cover.
4 Insert the SDI card along the guide rail at the bottom of
the camera and the tab above. Insert it securely all the
way.
5 Tighten the two card setscrews securely.
If you have lost the screws, use the screws (6 mm long)
supplied as accessories.
6 Fasten the rear panel with the four screws.
If you have lost the screws, use the screws (Black, 8 mm
long) supplied as accessories.
7 Plug the cables back as necessary, connect the power
connector, then switch power on.
- 9 -
Rear panel
Option card slot
cover
Card setscrews
(6 mm)
Rear panel
setscrews
(8 mm)
SDI card
- 10 -
Connection
Before cable connection, switch power off.
Use the AC adapter AW-PS510A for power supply. Use the power cable supplied with AW-HE870.
For details on connecting individual devices, refer to the respective operating instructions.
For details on operating individual devices, refer to the respective operating instructions.
In case of using a remote operation panel AW-CB400
Zoom lens
Camera
Video monitor,
VIDEO IN
VTR etc.
Rear view of camera
G/L OUT
Sync generator
Remote cable
(for zoom/focus control)
CONTROL
IN/OUT
Camera cable
AW-CA50T8 or AW-CA50T9 +
RS-232C/RS-422 converter
VTR etc.
Coaxial cable
(BELDEN 8281
or equivalent)
DC Power Cable
Remote operation panel
AW-CB400
HD-SDI: Max. 328 ft. (100 m)
(BELDEN 1694)
Unit with SDI input
SD-SDI: Max. 656 ft. (200 m)
(BELDEN 8281)
AC adapter
AW-PS510A
AC adapter
AW-PS510A
- 11 -
Appearance
Unit: inch (mm)
4-5/16 (109)
3-3/4 (95)
27/32
(21.5)
- 1ꢀ -
Specifications
Power requirements: 1ꢀ V DC (supplied from camera)
Power consumption: Approx. ꢀ.ꢀ W
indicates safety information.
Allowable temperature ranges: For storage:
–ꢁ °F to 1ꢁ0 °F (–ꢀ0 °C to +60 °C)
For guaranteeing operation: 1ꢁ °F to +113 °F (–10 °C to +ꢁ5 °C)
Operating humidity:
Dimensions:
30 % to 90 % (without condensation)
ꢀ7/3ꢀ˝ ꢀ-3/ꢁ˝ ꢁ-5/16˝ [ꢀ1.5 (W) 70 (H) 109 (D) mm]
Approx. 0.ꢀꢀ lbs. (0.1 kg)
Weight:
I/O connectors:
SDI OUT1, SDI OUTꢀ connector (BNC)
HD: Compliant with the SMPTEꢀ9ꢀM
SD: Compliant with the SMPTEꢀ59M
ZOOM/FOCUS connector 1ꢀ-pin; round
Weight and dimensions indicated are approximate.
Specifications are subject to change without notice.
- 13 -
PANASONIC BROADCAST & TELEVISION SYSTEMS COMPANY
UNIT COMPANY OF PANASONIC CORPORATION OF NORTH AMERICA
Headquarters:
3 Panasonic Way 4E-7, Secaucus, NJ 07094 (201) 348-5300
EASTERN ZONE:
3 Panasonic Way 4E-7, Secaucus, NJ 07094 (201) 348-7196
WESTERN ZONE:
3330 Cahuenga Blvd. West, Los Angeles, CA 90068 (323) 438-3608
Government office:
(201) 348-7587
Broadcast PARTS INFORMATION & ORDERING:
9:00 a.m. – 5:00 p.m. (PST) (800) 334-4881/24 Hr. Fax (800) 334-4880
Emergency after hour parts orders (800) 334-4881
TECHNICAL SUPPORT:
Emergency 24 Hour Service (800) 222-0741
Panasonic Canada Inc.
5770 Ambler Drive, Mississauga, Ontario L4W 2T3 (905) 624-5010
Corporativo Panasonic de México
Moras No. 313, Col. Tlacoquemecatl del Valle, Del. Benito Juárez, México, Distrito Federal, C.P. 03200. 01 (55) 54 88 10 00
Panasonic Puerto Rico, Inc.
AVE 65de Inf, Km 9.5 Carolina, PR 00985 (787) 750-4300
© Panasonic Corporation 2009
Printed in Japan
|