NETGEAR Switch FS105 V2 User Manual

Technical Support  
PLEASE REFER TO THE SUPPORT INFORMATION CARD THAT SHIPPED WITH  
YOUR PRODUCT.  
expert technical support and timely notices of product and software upgrades.  
Fast Ethernet Switch  
10/ 100 Mbps FS105 v2/ FS108 v2  
NETGEAR, INC.  
Support Information  
Phone: 1-888-NETGEAR (For US & Canada only) - 24 x7 phone support  
See Support Information card for other countries.  
E-mail: [email protected] (24 x 7 online support)  
© 2003 NETGEAR, Inc. NETGEAR, the Netgear logo, The Gear Guy, Auto Uplink and  
Everybody's Connecting are trademarks or registered trademarks of Netgear, Inc. in the  
United States and/or other countries. Microsoft and Windows are registered trademarks of  
Microsoft Corporation in the United States and/or other countries. Other brand and product  
names are trademarks or registered trademarks of their respective holders. Information is  
subject to change without notice. All rights reserved  
Installation Guide  
July 2004  
2 0 1 - 1 0 2 4 9 - 0 1  
 
Unpack the Box and Verify the  
Contents  
Prepare to Install the Switch  
1
2
Decide where you want to place the switch. Find a flat horizontal surface — such as a table,  
desk or shelf. The switch comes with wall-mounting screws. You’re welcome to use the screws if  
you want to hang the switch in an open space on a wall.  
Fast Ethernet Switch FS105 v2/FS108 v2  
Make sure the selected location is:  
Not in direct sunlight or near a heater or heating vent.  
FA  
ST  
ET  
HE  
RN  
ET  
SW  
ITC  
H
F
S1  
08  
Auto  
1
0/100  
M
bps  
On  
Blin  
=L  
k=  
ink  
Ac  
100M  
10M  
t
Not cluttered or crowded. There should be at least 2 inches (5 cm) of clear space on all  
sides of the switch.  
PW  
R
1
2
3
4
5
6
7
8
Well ventilated (especially if it is in a closet).  
Wall-mount  
hardware  
Also, you’ll need one Category 5 (Cat 5) Ethernet cable with RJ-45 connectors for each device  
you want to connect to the switch. Each Ethernet cable must be less than 328 feet (100 meters).  
Installation guide,  
warranty/registration card  
and support  
Power adapter  
information card  
When you open the box, verify that you received everything. The package includes:  
5/8-Port Fast Ethernet Switch FS105 v2/FS108 v2  
AC power adapter  
Wall-mounting screws  
FS105 v2/FS108 v2 Installation Guide (this document)  
Warranty and support information card  
If you don’t have everything listed above, see the support information card for contact  
information. If you’re missing the Technical Support information card itself, get contact  
 
Install the Switch and Connect the Other  
Devices  
Troubleshooting  
The Power light is not lit  
The switch has no power.  
3
Make sure the power cord is properly connected to the switch.  
Make sure the power adapter is properly connected to a functioning power outlet. If it’s in  
a power strip, make sure the power strip is turned on. If the socket is controlled by a light  
switch, make sure the switch is in the on position.  
Make sure you are using the NETGEAR power adapter supplied with your switch.  
The Link/Activity is not lit for a connected device or stays  
on continuously  
There’s a hardware connection problem.  
Make sure the cable connectors are securely plugged in at the switch and the device.  
Make sure the connected device is turned on.  
If the Ethernet cable is connected to a NIC or other Ethernet adapter, make sure the card  
or adapter is installed correctly and is working.  
Make sure the cable is less than 328 feet (100 meters).  
Technical Specifications  
Standards Compatibility:  
Data Rate:  
IEEE 802.3i 10BASE-T Ethernet, IEEE 802.3u,100BASE-TX Fast Ethernet  
1. Place the switch on a flat surface or hook onto the screws.  
IEEE 802.3x Flow Control; compatible with Windows®, Mac® OS, NetWare®, Linux®  
2. For each device, insert one end of an Ethernet cable into the port in the device and insert  
the other end into one of the Ethernet ports on the switch.  
100 Mbps with 4B/5B encoding and MLT-3 physical interface for 100BASE-TX  
10 or 100 Mbps half-duplex  
Network Interface:  
DC Power:  
RJ-45 connector for 10BASE-T or 100BASE-TX Ethernet interface  
7.5W max and 7.5V @ 1A DC input  
Note: If you have more than 5 or 8 devices to connect to this switch, you must  
connect them to a hub or other switch and then connect that hub or switch to this  
switch.  
Physical Dimensions:  
FS105 v2 - W: 94.8 mm (3.73") D: 101 mm (3.98") H: 27 mm (1.06")  
FS108 v2 - W: 158 mm (6.22") D: 101 mm (3.98") H: 27 mm (1.06")  
FS105 v2 - 0.275 kg (0.6 lbs); FS108 v2 - 0.49 kg (1.08 lbs)  
0 to 40˚ C (32 to 104˚ F)  
Weight:  
Operating Temperature:  
Operating Humidity:  
3. Connect the power adapter’s cord into the back of the switch and then plug the adapter  
into a power source (such as a wall socket or power strip).  
10% t0 90% relative humidity, non-condensing  
Electromagnetic Compliance: CE mark, Commercial; FCC Part 15, Class B; EN 55 022 (CISPR 22) Class B,  
C-Tick  
The Power light should light up.  
Safety Agency Approvals for  
the Power Adapter:  
CE mark, Commercial UL listed (UL 1950), TUV licensed (EN 60950), C-Tick  
The corresponding port number for each connected and powered device should light  
when link (connection), and flash when activity occurs.  
Performance Specifications  
Frame Filter Rate:  
Frame Forward Rate:  
Network Latency:  
(using 64-byte packets)  
14,800 frames/sec max for 10M port / 148,800 frames/sec max for 100M port  
14,800 frames/sec max for 10M port / 148,800 frames/sec max for 100M port  
100 Mbps to 100 Mbps: 20 µs max  
Note: If any light doesn’t operate as indicated, go to the Troubleshooting section.  
Address Database Size:  
Addressing:  
1024 MAC addresses  
48-bit MAC address  
Queue Buffer:  
FS105 v2 - 64 kilobytes; FS108 v2 - 96 kilobytes  
 

Miele Washer W 3364 WPS User Manual
Miller Electric Welder S 74DX User Manual
Milwaukee Power Hammer 0756 20 User Manual
Murphy Network Card MDDM User Manual
NEC Projector MultiSync MT600 User Manual
Nikon Cell Phone Accessories 6MWA0711 01 User Manual
Oregon Scientific Games Junior Laptop User Manual
Oricom Cordless Telephone eco5100 Series User Manual
Outlaw Audio Stereo Amplifier 200 M Block User Manual
ParaBody Home Gym 801101 User Manual