VISION
glass
kettle
y
22400RDA_IM.indd
1
2013/08/21 12:03:02 PM
19. This appliance is intended to be used in
households or other similar environments
such as:
• Staff kitchen areas in shops, offices and
other working environments
• By clients in hotels, motels and other
residential type environments
• Farm houses
rated, the safety cut out will automatically
switch off the heating element.
8. If point (7) occurs remove the plug from the
wall socket immediately and refill the kettle
after an adequate cooling down period,
about 15 to 20 seconds.
Warning:
• Bed and breakfast type environments
1. DO NOT SUBMERSE IN WATER.
2. Only use the base provided with this kettle.
3. If the supply cord is damaged it must be
replaced by the manufacturer or its service
agent or a similarly qualified person in or-
der to avoid a hazard.
Operating guidelines for first use:
1. Prior to initial use, clean the appliance by
going through several boiling cycles, using
clean water with each cycle and filling the
kettle (4) to its upper marking. The water
will reach boiling point after approximately
5 minutes and will then switch off auto-
matically.
Descaling:
1. Should the appliance switch off before
reaching boiling point this is a sign that
descaling is necessary.
Operation:
(Please refer to Figure 1)
1. Place the cordless base (7) on a firm and
level surface.
2. Pour the desired amount of clean water into
the kettle (4). Do not touch any part of the
2. A regular descaling agent may be used.
Ensure that the instructions for use are
adhered to. In order to avoid spillage do
not fill the kettle up to the max mark as the
descaling agent may cause the water to
foam.
kettle except the handle while the appliance 3. To clean the kettle thoroughly of any decal-
is in use. Ensure that the lid (1) is prop-
erly closed. The amount of water can be
measured by the level mark on the outside
of the kettle. Always pay attention to the
minimum and maximum levels and ensure
that the lid (1) is properly and firmly closed.
3. Position the kettle in such a way on the sub
base (6) so that the underside of the kettle
fits precisely into the contact on the base.
Insert the plug into a wall socket.
cification residues, boil the kettle several
times using clean water with each cycle.
Rinse the kettle with clean water afterwards.
Cleaning and care:
1. Before cleaning the appliance, ensure that
it is disconnected from the power supply
and has cooled down completely.
2. Do not use abrasives or harsh cleaning
solutions.
4. Put the on/off switch (3) to the ‘1’ position
to start the boiling process. The indicator
lamp will light up.
3. Do not immerse the base or the kettle
in any liquid. To clean the exterior use a
slightly damp, lint–free cloth.
5. As soon as the water reaches boiling point,
the on/off switch (3) will return automati-
cally to the “0” position. The indicator lamp
will go out. The kettle can also be switched
off manually by putting the on/off switch to
the “0” position.
4. It is advisable to remove lime deposits from
the kettle at regular intervals.
Specifications:
Supply voltage: 220-240V~ 50Hz
Power consumption: 1850-2200W
Volume: 1.7L
6. The hot water may now be poured safely
through the spout.
7. This kettle is equipped with a safety cut–out
feature to protect the appliance from dam-
age in case of inappropriate use. Should
the appliance be accidentally switched on
without water or if all the water has evapo-
22400RDA_IM.indd
3
2013/08/21 12:03:02 PM
22400RDA_IM.indd
4
2013/08/21 12:03:02 PM
|