Transmitters
Turns On / Off Porch Light
(Can be Programmed to
Press Simultaneously to
Turn On / Off Porch Light
Unlock Cargo Doors)
Locks All Doors
(Including Cargo)
Unlocks Entry
Doors
Locks All Doors
(Including Cargo)
Unlocks Entry
Doors
Unlocks Cargo Doors
(Can be Programmed to
Turn On / Off Porch Light)
Locks All
Cargo Doors
Unlocks All
Cargo Doors
User's Manual
Keypad Keyless
Entry System
Housing
Program
Button
LED
Antenna
Programming
A. 3-Button Transmitter Programming
B. 4-Button Transmitter Programming
Note: This mode will only retain the last 4 remote
transmitters programmed. If the transmitter memory
is exceeded, the security system will start deleting
transmitters from memory in chronological order.
1. Turn the ignition switch to the "ON" position.
2. Within 15 seconds, push the Program Button
(located on back of the housing) 3 times. The
onboard LED will be flashing and the beeper will
emit a long chirp to indicate the system is in
Transmitter Programming mode.
Note: This mode will only retain the last 4 remote
transmitters programmed. If the transmitter memory
is exceeded, the security system will start deleting
transmitters from memory in chronological order.
1. Turn the ignition switch to the "ON" position
within 15 seconds.
Models:
MKE-300A / MKE-400A
2. Push the Program Button (located on back of
the housing) 5 times. The onboard LED will be
flashing and the beeper will emit a long chirp to
indicate the system is in Transmitter
Programming mode.
3. Press and hold any button on the transmitter
until the onboard LED turns on for 2 seconds and
the beeper responds with a confirming chirp, indi-
cating the signal has been stored into memory.
4. If you have additional transmitters (up to 4)
that need to be programmed, repeat step 3 for
each transmitter.
3. Press and hold any button on the transmitter
until the onboard LED turns on for 2 seconds and
the beeper responds with a confirming chirp, indi-
cating the signal has been stored into memory.
4. If you have additional transmitters (up to 4)
that need to be programmed, repeat step 3 for
each transmitter.
Exit: Turn the ignition switch to the "OFF" position, or
leave it for 15 seconds. The onboard LED turns off
and the beeper will emit 3 long chirps to confirm exit.
Exit: Turn the ignition switch to the "OFF" posi-
tion, or leave it for 15 seconds. The onboard LED
turns off and the beeper will emit 3 long chirps to
confirm exit.
|