iLive Clock Radio ICP200B User Manual

USER’S GUIDE  
V:1036-0209-10  
ICP200B  
Clock Radio for iPhone/iPod  
For the most up-to-date version of this Users Guide, go to www.ilive.net  
 
fcc Warnings  
NOTE: This equipment has been tested and found to comply with  
the limits for a Class B digital device, pursuant to Part 15 of the FCC  
Rules. These limits are designed to provide reasonable protection  
against harmful interference in a residential installation. This equip-  
ment generates, uses, and can radiate radio frequency energy and, if  
not installed and used in accordance with the instructions, may cause  
harmful interference to radio communications. However, there is no  
guarantee that interference will not occur in a particular installation.  
If this equipment does cause harmful interference to radio or televi-  
sion reception, which can be determined by turning the equipment  
off and on, the user is encouraged to try to correct the interference  
by one or more of the following measures:  
Reorient or relocate the receiving antenna.  
Increase the separation between the equipment and receiver.  
Connect the equipment into an outlet on a circuit different from  
that to which the receiver is connected.  
Consult the dealer or an experienced radio/TV technician for  
help.  
additional Warnings  
The apparatus shall not be exposed to dripping or splashing and  
that no objects filled with liquids, such as vases, shall be placed  
on apparatus.  
L’appareil ne doit pas être exposé aux écoulements ou aux écla-  
boussures et aucun objet ne contenant de liquide, tel qu’un vase,  
ne doit être placé sur l’objet.  
Main plug is used as disconnect device and it should remain  
readily operable during intended use. In order to disconnect the  
apparatus from the mains completely, the mains plug should be  
disconnected form the mains socket outlet completely.  
La prise du secteur ne doit pas être obstruée ou doit être facile-  
ment accessible pendant son utilisation. Pour être complètement  
déconnecté de l’alimentation d’entrée, la prise doit être débran-  
chée du secteur.  
Battery shall not be exposed to excessive heat such as sunshine,  
fire or the like.  
Les piles ne doivent pas être exposées à de forte chaleur, tel qu’à  
la lumière du soleil, au feu ou autres choses de semblable.  
The marking information is located on the bottom of apparatus.  
Les précautions d’emploi sont inscrites en bas de l’appareil.  
CUstOmeR HeLPLINe | 1-314-621-2881  
iLive | ICP200B  
3
 
clock radio With dock for iPod and iPhone  
features  
• Works with iPhone  
• Made for iPod  
• FM radio  
• Station memory presets (20 FM)  
• Dual alarms  
• Digital clock  
• Snooze  
• Sleep timer  
• Wake to iPhone/iPod, radio, or buzzer  
• Gradual wake  
• Line input (3.5mm)  
• Video output  
• Basic iPhone/iPod controls  
• Built-in speakers  
• White dot-matrix display  
• Supports Universal docking brackets  
• DC power input: requires an AC/DC power adapter (included)  
• Battery backup  
included  
• ICP200B  
• Docking brackets for iPhone/iPod (5)  
• AC/DC power adapter  
4
iLive | ICP200B  
 
taBle of contents  
introduction  
6
setuP  
8
iPod/iPhone and radio  
9
clock and alarms  
other  
10  
11  
12  
comPany information  
CUstOmeR HeLPLINe | 1-314-621-2881  
iLive | ICP200B  
5
 
introduction  
Play/Pause  
Press to play or pause a  
docked iPhone or iPod.  
clock/alarm set  
In off mode, press to set  
the clock. In on mode,  
press to set the alarm.  
sleeP  
Press repeatedly to set  
the sleep timer.  
mem  
Press and hold to save  
the current radio station  
as a preset. Press to  
cycle through current  
radio presets.  
PoWer/source  
Press to power the clock  
radio on. Press and hold  
to power the clock radio  
off. While on, press to  
switch between Radio,  
iPod, and AUX modes.  
dock for iPod/iPhone  
Plays and charges a  
docked iPhone or iPod.  
alarm  
Press to activate alarm 1  
or alarm 2.  
POWER/  
SOURCE  
CLOCK/ALARM  
SET  
SLEEP  
PLAY/PAUSE  
MEM  
ALARM  
– TUNE/HR +  
VOLUME/MIN  
SNOOZE/DIM  
skiP/search/  
tuning/hr  
snooZe/dim  
After the alarm sounds,  
press to delay the alarm  
for an additional 10  
minutes.  
Volume/min (+/-)  
Press to adjust the  
volume. Press to adjust  
the minute when  
setting the time or  
alarm time.  
Press to skip between  
tracks on a docked  
iPhone or iPod. Press  
and hold to search  
through an individual  
track on a docked  
iPhone or iPod.  
Press to tune the FM  
radio. Press to adjust  
the hour when setting  
the time or alarm time.  
6
iLive | ICP200B  
 
reset  
Video outPut  
Use to output video  
form a docked iPhone  
or iPod to a connected  
television.  
fm antenna  
Press to reset the clock  
radio to it’s original  
settings.  
dc PoWer inPut  
auXiliary inPut  
Use to connect an MP3  
player to the clock  
radio.  
CUstOmeR HeLPLINe | 1-314-621-2881  
iLive | ICP200B  
7
 
setuP  
PoWer  
Plug the included AC/DC power  
adapter into the DC POWER  
INPUT on the clock radio and an  
AC power outlet to power the  
clock radio  
BackuP Battery  
Requires 2 AAA batteries (not  
included)  
The backup battery is meant for  
short-term power outages.  
The clock radio cannot run off of  
the backup alone.  
8
iLive | ICP200B  
 
iPod/iPhone and radio  
tuning the fm radio  
docking an iPhone or iPod  
1
2
3
Press the PoWer/source button  
to power on the clock radio.  
1 Locate the numbered bracket  
that fits the iPod/iPhone  
model that will be docked.  
Each included bracket has a  
number on it, indicating which  
iPod/iPhone model that bracket  
is compatible with. See the  
Press the PoWer/source button  
to switch to RADIO mode.  
Press the skiP/search/tuning/  
hr buttons to tune the FM radio.  
saVing a Preset  
separate bracket chart page to  
identify which bracket is needed.  
1
Follow the instructions for TUNING  
THE FM RADIO.  
2 Snap the bracket into  
place over the iPod/iPhone  
connector in the dock for iPod/  
iPhone.  
3 Connect the iPhone or iPod to  
the connector inside the Dock  
for iPod.  
When the speaker is plugged  
in, using AC power, the docked  
iPod/iPhone will charge.  
2
Tune to the desired station, and  
press and hold the mem button.  
The preset channel number will begin  
to blink.  
3
4
Press the mem button to select a  
preset channel to save the current  
radio station to.  
Press and hold the mem button to  
save the current radio station to the  
selected preset channel.  
listening to a Preset  
Playing an iPhone or iPod  
1
Follow the instructions for SAVING  
A PRESET.  
1 Follow the instructions for  
DOCKING AN iPod.  
2
Press the mem button to cycle  
through FM radio presets.  
2 Press the PoWer/source  
button to switch to iPod mode.  
3 Press the Play/Pause button  
to begin playing music from  
the docked iPhone or iPod.  
CUstOmeR HeLPLINe | 1-314-621-2881  
iLive | ICP200B  
9
 
clock and alarms  
setting the clock  
setting the alarms  
1
Press and hold the  
PoWer/source  
button to power the  
clock radio off.  
1
Press the PoWer/source button to power the  
clock radio on.  
2
Press the clock/alarm set button.  
The time on the display will begin to blink and AL1  
will appear to indicate you are setting alarm 1.  
2
3
Press the clock/  
alarm set button.  
3
4
Press the PoWer/source button to switch  
between waking to iPod, Radio, or Buzzer.  
Press the skiP/  
search/tuning/  
hr buttons to adjust  
the hour. Press  
the Volume/min  
buttons to adjust the  
minute.  
Press the skiP/search/tuning/hr buttons to  
adjust the hour. Press the Volume/min buttons  
to adjust the minute.  
5
Press the clock/alarm set button.  
The time on the display will begin to blink and AL2  
will appear to indicate you are setting alarm 2.  
4
Press the clock/  
alarm set button  
to finish setting the  
clock and alarms.  
6
7
Press the PoWer/source button to switch  
between waking to iPod, Radio, or Buzzer.  
Press the skiP/search/tuning/hr buttons to  
adjust the hour. Press the Volume/min buttons  
to adjust the minute.  
8
9
Press the clock/alarm set button to set the  
volume.  
The volume indicator on the display will begin  
flashing.  
Press the clock/alarm set button to finish  
setting the alarms.  
actiVating the alarms  
1
2
3
Follow the instructions for SETTING THE CLOCK  
AND ALARMS.  
Press the PoWer/source button to turn the  
clock radio off.  
Press the alarm button repeatedly to activate  
alarm 1, alarm 2, or both alarms.  
When the AL1 or AL2 indicator appears on the  
display, that alarm is active and will sound at the set  
alarm time.  
10 iLive | ICP200B  
 
other  
using the auX inPut  
sleeP timer  
1
With the clock radio powered  
on and playing, press the sleeP  
button repeatedly to set the sleep  
timer.  
1
Connect an MP3 player or other  
audio source to the auXiliary  
inPut using a 3.5mm line input  
cable (not included).  
2
After the set amount of time  
has expired, the clock radio will  
automatically power off.  
2
3
Press the PoWer/source button  
to switch to AUX mode.  
Use the connected MP3 player  
or other audio source’s native  
controls to play music through the  
boombox.  
setting the dimmer  
1
Press the snooZe/dim button  
repeatedly to adjust the brightness  
of the display.  
using the Video outPut  
1
Connect a television to the Video  
outPut using a RCA video cable  
(not included).  
2
Adjust the connected television  
to the input setting used when  
connecting the television to the  
clock radio.  
3
4
Adjust the settings on your iPod or  
iPhone to allow TV OUT.  
Video played from a docked iPhone  
or iPod will now play through the  
connected television.  
CUstOmeR HeLPLINe | 1-314-621-2881  
iLive | ICP200B 11  
 
comPany information  
green initiatiVe  
environmental Commitment to ‘Protect for  
today and sustain for tomorrow’  
2009 marked the official launch of DPI, Inc.’s  
corporate campaign for a greener and cleaner  
world. DPI is building upon environmental  
initiatives introduced at all of their facilities to help  
formulate and sustain significant and important  
conservation efforts within its manufacturing and  
marketing communities. In addition to targeting  
and selecting energy efficient product features, and  
structuring ‘green office’ procedures, other initial  
program efforts include:  
Reduction of all packaging sizes  
Recyclable plastics for clamshell packages,  
with a plan to eventually replace plastic with  
recyclable paper  
Recycled fiber board in place of the polyfoam in  
packing boxes  
Recycled plastics in place of the virgin material  
in product construction  
international suPPort  
To download this User’s Guide in English,  
Spanish, or French, visit the support section at  
Para transferir esta guía de usuario en inglés,  
español, o francés, visite la sección de la ayuda en  
Pour télécharger ce guide de l’utilisateur en  
anglais, espagnol, ou français, visitez la section de  
contact information  
Address: 2116 Carr Street, St. Louis MO, 63106  
Phone: 1-314-621-2881  
Fax: 1-314-588-1805  
Parts Email: [email protected]  
© 2009 Digital Products International (DPI, Inc.) | All other trademarks appearing herein are the property of their respective owners.  
Specifications are subject to change without notice  
 

Hans Grohe Plumbing Product 28573XX0 User Manual
Hasbro Games 20176 User Manual
Healthrider Home Gym HREL11900 User Manual
Hearth and Home Technologies Range be 36 c User Manual
Honeywell Boiler RVGP User Manual
HP Hewlett Packard Power Screwdriver 403606 10 User Manual
HP Hewlett Packard Scanner 3770 User Manual
Humax DVR iCord HD User Manual
Impex Home Gym PT 70 User Manual
i Tech Dynamic Headphones Clip II User Manual