iHome Portable Speaker iHM1 User Manual

Limited 90-Day Warranty  
Model iHM1  
the speaker system  
for your iPod nano  
iHome Products, a division of SDI Technologies Inc. (hereafter referred  
to as SDI Technologies), warrants this product to be free from defects  
in workmanship and materials, under normal use and conditions, for a  
period of 90 days from the date of original purchase.  
Should this product fail to function in a satisfactory manner, it is best to  
first return it to the store where it was originally purchased. Should this  
fail to resolve the matter and service still be required by reason of any  
defect or malfunction during the warranty period, SDI Technologies will  
repair or, at its discretion, replace this product without charge (except  
for a $7.00 charge for handling, packing, return UPS/postage, and  
insurance). This decision is subject to verification of the defect or  
malfunction upon delivery of this product to the Factory Service Center  
listed below. The product must include proof of purchase, including  
date of purchase. The fee for service without proof of purchase is  
$15.00.  
Before returning this product for service, please first replace the batteries  
(if applicable) with fresh ones, as exhausted or defective batteries are  
the most common cause of problems encountered.  
If service is still required:  
1. Remove the batteries (if applicable) and pack the unit in a well padded,  
heavy corrugated box.  
2. Enclose a photocopy of your sales receipt, credit card statement, or  
other proof of the date of purchase, if within the warranty period.  
3. Enclose a check or money order payable to the order of SDI Technologies,  
for the sum of $7.00 ($15.00 without proof of purchase).  
4. Send the unit prepaid and insured, to the Factory Service Center  
listed below.  
Consumer Repair Department  
SDI Technologies Inc.  
1330 Goodyear Drive  
El Paso, TX 79936-6420  
Disclaimer of Warranty  
NOTE: This warranty is valid only if the product is used for the purpose  
for which it was designed. It does not cover (i) products which have  
been damaged by negligence or willful actions, misuse or accident, or  
which have been modified or repaired by unauthorized persons; (ii)  
cracked or broken cabinets, or units damaged by excessive heat; (iii)  
damage to digital media players, CDs or tape cassettes (if applicable);  
(iv) the cost of shipping this product to the Factory Service Center and  
its return to the owner.  
This warranty is valid only in the United States of America and does not  
extend to owners of the product other than to the original purchaser.  
In no event will SDI Technologies or any of its affiliates, contractors,  
resellers, their officers, directors, shareholders, members or agents be  
liable to you or any third party for any consequential or incidental  
damages, any lost profits, actual, exemplary or punitive damages. (Some  
states do not allow limitations on implied warranties or exclusion of  
consequential damages, so these restrictions may not apply to you.)  
This warranty gives you specific legal rights, and you may also have  
other rights which vary from state to state.  
Your acknowledgement and agreement to fully and completely abide  
by the above mentioned disclaimer of warranty is contractually binding  
to you upon your transfer of currency (money order, cashier's check,  
or credit card) for purchase of your SDI Technologies product.  
For any other questions: 1-800-288-2792 Toll Free  
©2006 SDI Technologies, Inc. All Rights Reserved.  
SRS® is a registered trademark of SRS Labs, Inc.  
TruBass technology is incorporated under  
license from SRS Labs, Inc.  
IMPORTANT  
Read before proceeding  
If you have any questions regarding the operation or use of this product, please visit  
www.ihomeaudio.com to view answers to frequently asked questions.  
To learn more about this and other iHome products, please visit us online at www.ihomeaudio.com  
Printed in China  
iHM1-101206-1  
 
Using the iHM1  
Thank you for purchasing the iHM1, the speaker system for  
your iPod nano. Designed specifically to work with your iPod  
nano, this system provides high quality audio and that invites  
your music to come out and play.  
Please read the instructions carefully before operating the  
unit and keep for future reference.  
Installing/Replacing Batteries  
1. Open the battery compartment cover located on the back  
of the unit.  
2. Insert 3 “AA” (LR6) batteries, checking that the + and –  
ends of the batteries match the drawing inside the battery  
compartment. We recommend the use of alkaline  
batteries for longer life.  
3. Close the compartment cover.  
Battery information:  
Battery Installation  
New 2g iPod nano  
• Do not mix old and new batteries.  
• Do not mix alkaline, standard (carbon-zinc) or  
rechargeable batteries.  
• Make sure you dispose of batteries properly (see your  
local regulations).  
iPod nano switch (located on bottom of unit):  
• Default setting is for the new 2g iPod nano.  
• If you have an original 1g iPod nano, slide the switch to  
the left position.  
NOTE:  
Inserting/Removing iPod nano from the unit  
1. Slide your iPod nano into the unit as shown. Please make  
sure the iPod nano is fully docked into the unit before  
turning on power on the unit.  
2. To remove your iPod nano, push the “Release” button  
down. The iPod nano will pop up and you can tilt it into  
the palm of your hand.  
FOR BEST SOUND,  
turn Sound Check ON  
in your iPod Settings  
menu  
Listening to your iHM1  
1. Turn on your iPod nano and set desired volume.  
2. Switch the mode button located on the right side of the  
unit to On or to SRS TruBass if you want more bass.  
3. Because audio tracks are mastered differently, you may  
notice discrepancies in volume from song to song.  
For best sound, turn Sound Check ON in your nanos  
Settings menu.  
4. Remember to turn unit OFF when not in use to save  
batteries. To extend battery life, play unit without SRS  
TruBass feature.  
NOTE: ADJUST iPod  
VOLUME TO AVOID  
DISTORTION  
Mode Button  
Release Button  
iPod nano switch  
Maintenance  
• Place the unit away from sources of direct sunlight or  
excessive heat.  
Power Indicator  
• Protect your furniture when placing your unit on a natural  
wood and lacquered finish.  
• Clean your unit with a soft cloth moistened only with mild  
NOTE: UNIT DOES NOT CHARGE iPod nano  
soap and water. Stronger cleaning agents, such as  
Benzine, thinner or similar materials can mar the surface  
 
of the case.  

Graco Baby Accessories PD261467A User Manual
Grizzly Staple Gun H7947 User Manual
Haan Carpet Cleaner SI 3b User Manual
Hotpoint Dishwasher HDA460 User Manual
HP Hewlett Packard Network Card YELLOWJACKET PLUS User Manual
HP Hewlett Packard Projector vp6100 Series User Manual
HP Hewlett Packard Scanner 815MFP User Manual
HP Hewlett Packard Server BL495c User Manual
Husqvarna Tiller 650RTT User Manual
Husqvarna Welder K3000 User Manual