Honeywell Thermostat 8162 User Manual

08162  
TH114-A-240D  
TL7235  
3.  
1.  
Installation  
Description  
p
n
Turn off power to the heating system at the main electrical panel  
to avoid electrical shock. The installation should be carried out  
by an electrician.  
This thermostat can be connected to an electric heater to control the  
room temperature.  
High voltage thermostats must be installed onto an electrical  
box.  
For a new installation, choose a location about 5 ft. above the  
floor and on an inside wall.  
The thermostat must be installed on an inside wall facing the  
heating system.  
Avoid locations where there are air drafts (top of staircase, air  
outlet), dead air spots (behind a door), direct sunlight or con-  
cealed chimneys or stove pipes.  
Appearswhen  
the setpoint is  
displayed  
Temperature  
display  
Temperature  
adjustment buttons  
Heating indicator *  
Backlight button  
n Connect the power base wires to the power supply and load  
Set the switch to  
Off to cut power to  
the heater  
using solderless connectors for copper wires.  
Power  
*
The thermostat indicates how much heating is required to maintain the desired  
temperature. For example,  
is displayed when heating is at 40 percent.  
Display  
% of heating  
1 to 24% 25 to 49% 50 to 74% 75 to 99%  
100%  
2.  
Configuration  
The configuration switches are located at the back of the control  
module (faceplate).  
o
Load  
o If you wish to use a remote controller such as the CT240 or  
CT241 from Aube, insert the cable (use 18 to 22 gauge flexible  
wires) into one of the two holes available below the terminal  
board and connect to terminals 1 and 2 of the base.  
2.1 Temperature Display (S1)  
The S1 switch allows you to select  
between °C and °F.  
p If you use an external sensor, insert the sensor wires through  
one of the two holes below the terminals (figure 2) and connect  
the wires to terminals 3 and 4 (no polarity).  
2.2 Model (S2)  
The S2 switch allows you to control  
the temperature using either the  
thermostat’s built-in sensor or an  
external sensor.  
q Push the excess length of the high-voltage wires back into the  
electrical box.  
r Secure the power base to the electrical box using the provided  
screws.  
AF: Use built-in sensor (external sensor not required)  
s If necessary, set the configuration switches on the control mod-  
ule (refer to the control module user guide).  
F:  
Use external sensor (option)  
08162 / TH114-A-240D / TL7235  
69-2022  
1/11/06  
1/2  
Non-programmable Thermostat - Installation and User Guide  
 

Grizzly Nail Gun T10726 User Manual
Hayter Mowers Lawn Mower 308A User Manual
Heat Controller Air Conditioner BDE 103 A User Manual
HP Hewlett Packard Camper PS3500H User Manual
HP Hewlett Packard Fax Machine HP FAX 700 User Manual
HP Hewlett Packard Network Card 600N User Manual
HP Hewlett Packard Personal Computer 23 C130 User Manual
HP Hewlett Packard Power Supply 380976 User Manual
Husqvarna Lawn Mower 220 AC User Manual
IKEA Plumbing Product AA 338654 2 User Manual