Installation
Instructions
¨
TM
Models:
TS345
Square Termination Cap
This chimney termination cap has been tested for use with specific Hearth & Home Technologies Inc. fireplaces. Check with
your local building code agency before you begin installation to ensure compliance with local codes, including the need for
permits and follow-up inspections. If you encounter any problems regarding code approvals, or if you need clarification of
any of the instructions contained here, contact your Hearth & Home Technologies Inc. dealer. For the dealer nearest you,
Note: An arrow (¨) found in the text signifies change in content.
¨
CAUTION
WARNING
Sharp Edges
Fire Risk
•
Wear protective gloves and safety
glasses during installation.
•
Intended for use with a metal chase
top.
Use of combustible materials will cause a
fire hazard.
16"
Minimum
13-1/4 in.
(337 mm)
Open
Top
Field
Constructed
Shroud
Only
16-1/4 in.
(413 mm)
Maximum
Height of 16"
22 in.
(559 mm)
23-1/8 in.
(587 mm)
3" air space
from bottom of
shroud to top
of chase
Roof Chase
18 in.
(457 mm)
18¾"
Minimum
Dimensions for a Field Constructed Shroud
Figure 1
¨
Figure 2
HeatilHearth & Home Technologies Inc. • TS345 Square Termination Cap • 31446 Rev E • 04/07
1
|