ALKALINE
BATTERIES
REQUIRED
x2
AGES 3+
1.5VAA/LR6 size
™
NOT INCLUDED
78377/78374 Asst.
Phillips/cross head screwdriver (not
included) needed to insert batteries.
IMPORTANT: BATTERY INFORMATION
Zoom N’ Go HULK™ Chopper Trike
Please retain this information for future reference. Batteries should be replaced by an adult.
To install batteries:
CAUTION: TO AVOID BATTERY LEAKAGE
1. Be sure to insert the batteries correctly and always follow the toy and battery
manufacturers’ instructions;
1. Using a Phillips/cross head screwdriver
(not included), unscrew battery cover.
2. Insert 2 fresh 1.5 V “AA” or LR6
batteries. See diagram for polarity.
3. Replace battery cover and tighten screw.
2. Do not mix old and new batteries or alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries;
3. Always remove weak or dead batteries from the product.
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified and be sure
to insert item correctly by matching the + and – polarity markings.
2. Do not mix old and new batteries or standard (carbon-zinc) with alkaline
batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short-circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical interference, move
it away from other electrical equipment. Reset (switching off and back on again or
removing and reinserting batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types of
batteries. Always remove from the product before recharging. Recharge batteries
under adult supervision. DO NOT RECHARGE OTHER TYPES OF BATTERIES.
|