Harbor Freight Tools Tool Storage 94582 User Manual

TOOL CHEST  
AND ROLLER CABINET  
94582  
ASSEMBLY & OPERATING INSTRUCTIONS  
Due to continuing improvement, actual product may differ slightly from the product described herein.  
®
3491 Mission Oaks Blvd., Camarillo, CA 93011  
Copyright© 2006 by Harbor Freight Tools®. All rights reserved. No portion of this manual or  
any artwork contained herein may be reproduced in any shape or form without the  
express written consent of Harbor Freight Tools.  
For technical questions and replacement parts please call 1-800-444-3353.  
 
10. Do not use or assemble the Tool Chest and Roller Cabinet if under the influence of  
alcohol or drugs. Read warning labels on prescriptions to determine if your judgement or  
reflexes are impaired while taking drugs. If there is any doubt, do not assemble or use the  
Chest and Cabinet.  
11. Improper use can cause the Tool Chest and Roller Cabinet to tip over, causing personal  
injury or death. Load the chest evenly from the bottom up.  
12. Do not exceed the Tool Chest and Roller Cabinet’s maximum weight capacity of 114 Lbs.  
The weight capacity for each Tray and Drawer is 11 Lbs.; Shelf capacity is 22 Lbs.  
13. Always load the Tool Chest and Roller Cabinet evenly. If the Tool Chest is top-heavy, it may  
tip over when moved.  
14. Use the Tool Chest and Roller Cabinet on a flat and level surface. This will lessen the  
chance of it rolling away and possibly causing injury.  
WARNING: The warnings, cautions, and instructions discussed in this instruction manual cannot  
cover all possible conditions and situations that may occur. It must be understood by  
the operator that common sense and caution are factors which cannot be built into  
this product, but must be supplied by the operator.  
Roller Cabinet  
Screw  
(2B)  
Caster (1B)  
Handle (9)  
Figure 2  
Figure 1  
Assembly/Operation  
Your Tool Chest and Roller Cabinet will require complete assembly. It is important that you read the  
entire manual to become familiar with the product BEFORE you assemble and use the Tool Chest  
and Roller Cabinet. Before assembling the Chest and Cabinet be sure that you have all parts  
described in the Parts List located on page 4 of this manual.  
1.  
2.  
Insert each of the Caster (1B) shafts into the holes in the bottom of the Tool Chest and Roller  
Cabinet-see Figure 1.  
Attach the Handle (9) to the side of the Roller Cabinet with two Screws (2B) and  
Nuts (3B)-see Figure 2.  
3.  
4.  
5.  
6.  
Set each Shelf (8) down onto the lips built into the sides of the Roller Cabinet.  
Set each of the Hooks (6B) in place on the Door.  
Place the Tool Chest onto the top of the Roller Cabinet to have it stand as one unit.  
If the Non-Slip Mats (4, 5) are not in place in the face drawers, place the Non-Slip Mats (4, 5)  
into each of the Drawers.  
7.  
Make certain that the Tool Chest drawers lock when the top tray is closed.  
SKU 94582  
For technical questions please call 1-800-444-3353.  
Page 3  
 
Parts List for Tool Chest (A)  
Description  
Part #  
1A  
2A  
3A  
4A  
5A  
Drawer with plastic liner  
Plastic Liner  
B Type  
Sponge  
Sponge  
Parts for Cabinet (B)  
Part #  
1B  
Description  
Caster  
Part #  
6B  
Description  
Hook  
2B  
3B  
Screw M6 X 12  
Nut  
7B  
8B  
Spring  
Shelf  
4B  
5B  
Pin for Door  
Door  
9B  
10B  
Handle  
Hook Lock  
Note: Some parts are listed and shown for illustration purposes only and are not available  
individually as replacement parts.  
PLEASE READ THE FOLLOWING CAREFULLY  
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A  
REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR  
WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT  
OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/  
OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY  
CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY  
ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING  
OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.  
SKU 94582  
For technical questions please call 1-800-444-3353.  
Page 4  
 

Grizzly Automobile Parts G8724 User Manual
Guardian Technologies Air Cleaner EV9102 User Manual
Haier Dishwasher DW12 CFE SS User Manual
Hamilton Beach Humidifier 840117800 User Manual
Hotpoint Microwave Oven MWH211 User Manual
Hotpoint Video Game Controller CIB6441 CE User Manual
Hotpoint Washer AQ73F49E User Manual
Hotpoint Washer WMYL 661 User Manual
HP Hewlett Packard Network Router HP 37722A User Manual
Humax Satellite TV System IR FOX C User Manual