BATTERY CUT-OFF SWITCH
92688
ASSEMBLY AND OPERATING INSTRUCTIONS
3491 Mission Oaks Blvd., Camarillo, CA 93011
t©
®
Copyrigh 2005 by Harbor Freight Tools . All rights reserved.No portion of this
manual or any artwork contained herein may be reproduced in any shape or
form without the express written consent of Harbor Freight Tools.
For technical questions and replacement parts, please call 1-800-444-3353
10. Stay alert. Watch what you are doing, use common sense. Do not install or use the
Battery Cut-Off Switch when you are tired.
11. Check for damaged parts. Before using any product, any part that appears
damaged should be carefully checked to determine that it will operate properly and
perform its intended function. Check for alignment and binding of moving parts; any
broken parts or mounting fixtures; and any other condition that may affect proper
operation. Any part that is damaged should be properly repaired or replaced by a
qualified technician. Do not use the Battery Cut-Off Switch if the Key does not turn On
and Off properly.
12. Replacement parts and accessories. When servicing, replace a damaged key only
with an approved replacement key. Use of any other parts will void the warranty.
Approved keys are available from Harbor Freight Tools.
13. Do not operate or install product if under the influence of alcohol or drugs.
Read warning labels if taking prescription medicine to determine if your judgment or
reflexes are impaired while taking drugs. If there is any doubt, do not operate the
product.
14. Maintenance. For your safety, service and maintenance should be performed
regularly by a qualified technician.
WARNING: The brass components of this product contain lead, a chemical known to
the State of California to cause birth defects (or other reproductive harm).
(California Health & Safety code § 25249.5, et seq.)
Warning:The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be under-
stood by the operator that common sense and caution are factors which cannot be
built into this product, but must be supplied by the operator.
IMPORTANT
This device, like any other antitheft device, is not undefeatable.
Harbor Freight Tools cannot be held responsible for any loss of or
damage to the vehicle that this unit is installed in due to theft.
Unpacking
When unpacking, check to make sure the Switch and two keys are included. If any parts
are missing or broken, please call Harbor Freight Tools at the number on the cover of this
manual as soon as possible.
SKU 92688
For technical questions, please call 1-800-444-3353
Page 3
Operation
Harbor Freight Tools recommends that the Battery Cut-Off Switch be
installed by a professional technician.
Mounting
1.
The Battery Cut-Off Switch (1) must be securely mounted using both mounting holes
before use.
2.
It must be mounted in a location where:
a. it will be accessible.
b. it will have ample clearance for the key.
c. it will be away from any hot or metallic parts of the engine.
d. it will not encounter interference from nearby objects.
e. the positive cable (for negative ground vehicles), or negative cable (for rare
positive ground vehicles) can be safely routed to.
3.
Only install this unit when the negative clamp is disconnected and insulated from the
battery terminal.
Warning!! If the terminal on the Battery Cut-Off Switch comes in contact with a
grounded piece of metal, serious damage (including explosion and fire) to the
vehicle/battery may occur.
Usage
1.
To allow the battery to start and run your vehicle, insert the Key (2) and turn it, as
shown in Assembly Drawing below.
2.
When you want to cut off the battery and keep the vehicle from starting, remove the
Key (2). This enables the Cut-Off Switch.
Note: When you enable the Cut-Off Switch by removing the Key (2), your battery will disconnect
and most clocks will stop operating and other preset functions may be erased.
Check that the battery is truly disconnected (try to start the engine) every time
BEFORE leaving the vehicle. It is the responsibility of the vehicle’s owner to
verify that this unit is disconnecting the battery properly.
Assembly Drawing
Key (2)
Cut-Off Switch (1)
Note: Second Key not shown.
NOTE: Some parts are listed and shown for illustration purposes only and are not available
individually as replacement parts.
SKU 92688
For technical questions, please call 1-800-444-3353
Page 4
|