Haier Washer HWM80 35 User Manual

HWM80-35  
Single-tub Washing Machine with Pump  
Contents  
Before using  
Names of the parts........... the 2nd cover  
Safety precautions ...........................  
1
Installation and adjustment ..................3  
Using process  
Preparation before washing .............. 5  
Put in the laundries ............................ 6  
Put in the detergent ............................ 7  
Select the wash selector...................... 7  
Select the wash time .......................... 7  
Close the top cover ............................. 8  
Finish washing .................................... 8  
Disposal after washing .........................8  
Trouble shooting.................................9  
Packing list...........................................9  
Specification................the back cover  
Please read thismanual carefully beforeusing.  
Retain it forfuture reference  
Please check if the power receptacle has good earthing  
condition before using to guarantee your safety.  
The manufacturer willnot bear theresponsibility for  
those risks occurredfrom not obeyingthis manual.  
 
Before Using  
Safety precautions  
Please insert the power cord into special  
When the machine is normally using, please  
put the power plug at the location easily to  
be inserted and extracted by hand. Be sure  
to pull the plug off when there'spower failure,  
or the machine is being moved, cleaned or  
when it is idle.  
receptacle with rated voltage.Be sure to  
use single-phase three pins receptacle.  
The earthing terminal of the receptacle  
must be earthed reliably.If possible,please  
adopt electric leakage protector.  
Earth  
If the power cord is bad, to avoid risk it is required to replace it by the technicians of  
our special shop or the after-sale service department. Keep the pin of the power  
plug clean.  
Do not use water hotter than 50 C .  
In case the washing machine is installed  
on ground with carpet , do not block the  
ventilation hole with carpet.  
Ventilation hole at  
the bottom of the  
washing machine  
Do not put the machine at damp place Do not wash water-proof laundries such  
like the bathroom . Never wash it with  
water. Do not place wet laundries on the  
control panel.  
as the raincoat, bicycle shelter etc. To  
avoid abnormal vibration during spinning.  
Do not share one receptacle with other  
electric appliances. Do not use it in  
case that the power plug is damaged  
or the inserting into the receptacle is  
loose.  
 
Before Using  
Safety precautions  
Do not decompose, repair or alter the  
machine by yourself.  
Do not stretch hands into the working  
machine. It is dangerous even if the  
rotation is slow. Take special care of  
the children.  
Do not put any hot or heavy items  
( such as the kettle with hot water )  
on the washing machine.  
Do not wash laundries with volatile  
materials (such as thinner, petrol etc.).  
r
Petrol  
nne  
Thi  
Handicapped or children without care  
shall not use the machine.  
Keep the machine away from direct  
sunlight and heat source like the  
heater.  
To protect your laundries and washing  
machine, please take out all of the coins,  
buttons, sand, hairpin and other foreign  
materials before washing.  
Please check if the water faucet is open, and if  
the connection of the water inlet pipe is proper.  
It is suggested to use foamless washing powder.  
 
Before Using  
Installation and adjustment  
Please install and adjust the machine according to the requirement of the manual.  
It is very important to your security and correct operating the machine.  
Usage of the drain hose  
The drainage shall be smooth with the drain hose.  
1.Put the drain hose up to suitable position  
<1.2m  
2.Do not step on or press the drain hose  
Install the lint filter  
After opening the package,please take out the lint filter  
from the document bag,install it to the filter cap of the  
cabinet.See to the figure  
Filter cap  
Lint filter  
 
Before Using  
Adjust the installation position  
The largest permittedslope of thebearing surface ofthe washing machineis 2.  
Slanting or unevenground will causeunstable operation ofthe machine. Please  
check with followingmethods:  
Hang a becketwith weight toconfirm if thewashing machine ishorizontal.  
Install the water inlet hose ; Select the water level  
Water inlet hose  
Water level  
indicator  
Insert the water inlet hose into the water-inlet  
on the control panel directly. ( pull it out to  
dismantle it)  
Water inlet  
MAX  
Maximum  
about 83L  
Fill the water to the water level selected  
according to the quantity of the laundries.  
MED  
Medium  
about 68L  
Minimum  
about 49L  
MIN  
Attention:  
Do not exceed the " Maximum" water  
level , otherwise the water may  
overflow out of the machine.  
MA
MED  
MIN  
Use the quick water inlet  
Insert the water-filling jointer into water inlet hose,  
then push the water-filling jointer into the water  
inlet on the control panel. (To dismantle the water  
inlet hose, just push the control handle as  
indicated in the figure and pull it out)  
Water-filling jointer  
Water inlet hose  
Fill water into the wash tub directly through  
quick water inlet. It can reduce the humidity  
inside the control panel significantly and  
prolong the operating life of the components.  
Push  
Control handle  
Quick water inlet  
 
Using process  
1 Preparation before washing  
Preparation before washing  
1.Connect the water inlet hose.  
2.Confirm that the washing machine is  
earthed reliably . Then insert the power  
plug into the receptacle. Do not connect  
the earth terminal to the gas pipe and  
tap water pipe.  
3.Hang the drain hose up.  
Pay attention to followings before washing the laundries  
Check  
if C l e a r t h e Tie the long The quantity of  
When the pulsator  
the laundries pocket. Take strips; fasten the laundries is running , the  
has special out the coins, the buttons; shall not be too buttons of the  
requirement sand, hairpins close zippers. large. Stretch laundries may  
on washing etc.  
and loosen the cause noise. For  
laundries before t h e s a k e o f  
putting them in discretion, please  
the tub.  
put the laundries  
with buttons into  
other laundries.  
a. Check if the laundries are applicable for washing with machine.  
b. Divide the laundries that are not colorfast from other laundries.  
c. Put those laundries difficult to absorb water into water with hand.  
d. For those laundries with heavy soil, please first remove the dirt like mud or dust.  
For the parts with heavy soil, please apply detergent on them in advance, which  
can make it easier to remove the soil.  
e. For those laundries that may get lint ball and those with long fur, turn it over before  
putting in.  
f. Do not put those laundries polluted by chemicals into the washing machine directly.  
 
Using process  
2 Put in the laundries  
The capacity of washing of the machine  
refer to the largest weight of the standard  
laundries under dry condition that can be  
washed in one time. Laundries quantity  
in one washing cycle shall be lower  
than the rated capacity.  
The thickness ,size , type of the cloth will  
influence the actual washing capacity. It  
is suitable to put in reasonable amount of  
laundries and the laundries can be turned  
round in washing for one time washing.  
Do not select " Maximum " water level  
for laundries less than 2.4kg, so as to  
avoid splashing of water.  
Reference weight of the laundries:  
working suit up,down  
cotton,about 1120g  
jeans about 800g  
blanket  
cotton,about 900g  
blending coat  
about 800g  
pajamas  
jacket  
cotton,about  
800g  
shirt  
cotton,about  
300g  
single bed sheet  
cotton,about 600g  
undershirt  
cotton,about 180g  
socking  
blending,about 50g  
underpants  
cotton,about 70g  
 
Using process  
3 Put in the detergent  
How to use the whitener  
Fill water to decided level. Dilute the whitener with container. Pour it slowly into the  
washing tub.  
Avoid using whitener on laundries with color or pattern as they are prone to lose color.  
The whitener shall not touch the laundries directly.  
Refer to the user's manual for the usage and quantity of the whitener.  
For powder whitener,please dissolve it before using.  
How to use the washing powder  
Direct dissolved in the machine:  
1.Fill small quantity of water.  
2.Add the powder . Run for 30 seconds to  
dissolve it completely.  
3.Put it in the laundries. Select suitable  
water level.  
The powder is more prone to pollute the  
laundries than the detergent. Therefore  
please use it with proper quantity.  
It is suggested not to use high sudsing  
detergent.  
The instant dissolving of the washing powder:  
1.Prepare warm water of 30 C and a container.  
2.Add the powder while stirring to fully  
dissolve it.  
Dosage of different washing powder is  
different. Please refer to the instruction  
of the washing powder for the detail  
dosage.  
Selection of the quantity of the washing powder  
Standard dosage  
Water level  
Concentrated washing  
powder  
Common washing  
powder  
Water quantity  
Maximum (about83L)  
Medium (about68L)  
Minimum (about49L)  
About  
About  
About  
About  
83g  
75g  
61g  
43g  
About  
68g  
About  
49g  
4 select the wash selector  
STANDARD  
Please select water current according to the laundries.  
GENTLE  
DRAIN  
WASH SELECTOR  
5 select the wash time  
Please select wash time according to the laundries.  
Laundries  
Wash time minutes  
About2~4  
Silk(thin laundries)  
Knitwear/chemical fiber  
Bed sheet  
About3~6  
About7~13  
About8~10  
Cotton,blending,linen  
Very dirty and thick laundries  
About10~13  
 
Using process  
6 Close the top lid  
7 Finish washing  
STANDARD  
GENTLE  
The pulsator stops rotating set the "WASH  
SELECTOR" at "DRAIN".  
DRAIN  
WASH SELECTOR  
8 Disposal after washing  
After using, please clean the lint and foreign materials of the lint filter and lint frame in time.  
Otherwise it may influence your using the machine.  
Please first pull off the power plug from the receptacle before cleaning.  
Cleaning the lint filter  
The lint filter must be used during washing.  
It must be cleaned in time after each using.  
1. Take off the lint filter  
Put hand at the indicated position.  
Push down to take it off. (See to  
Figure 1)  
Figure 1  
2. Clean the lint  
Put it in water and clean while it is still  
wet.(See to Figure 2)  
3. Install the lint filter  
After cleaning, insert the bottom of  
the lint filter (marked with "down side")  
Figure 2  
into the filter frame, then push the  
upper part of the filter in (marked with  
"up side"). (See to Figure 3)  
Figure 3  
Attention: be sure not to confuse the direction.  
After washing, dismount the water inlet hose.  
Pull off the power plug and hang up the  
power cord.  
Do not store water in the tub for long period.  
Discharge the water immediately after each  
using.  
Wipe the complete unit with soft cloth  
twisted dry.  
Wipe with neutral detergent if too dirty.  
Do not wash it directly by water.  
Wipe off the water drops on the surface and  
inside the tub with clean soft cloth. Open the  
cover of the wash tub for some time (about  
one hour), then close it.  
Thinner  
Petrol  
Alcohol  
Hang up the drain hose.  
 
Trouble-shooting  
The following phenomena are not breakdowns sometimes. Please confirm again before  
sending it to repair.  
Phenomena  
How to check  
The washing machine  
does not act  
Is there power failure?  
Is the power plug inserted tightly?  
There's abnormal sound  
inside the machine.  
Is the machine slanting?  
Is there metal item inside the tub?  
Is the drain hose frozen?  
Is the front end of the drain hose blocked?  
The drainage does not work.  
Packing list  
User's manual  
1 piece  
1 piece  
Water inlet hose  
Water-filling jointer  
Lint filter  
1 piece  
1 piece  
1 set  
Washing machine  
 
Specification  
Type  
Single-tub washing machine with pump  
Model  
HWM80-35  
Rated voltage Frequency  
Water level Water quantity about  
220V~ 50Hz  
Maximum/83L Medium/68L Minimum/49L  
Rated input power for washing  
Rated input power for draining  
Dimensions(mm)  
W
W
320  
35  
L520 W490 H916  
17  
Weight kg  
Injection pressure  
0.02MPa~0.2MPa  
 

Grizzly Camper G0555 User Manual
Hamilton Beach Oven 840151000 User Manual
Harbor Freight Tools Camera Accessories 94555 User Manual
Harbor Freight Tools Vacuum Cleaner 3794 User Manual
Harrington Hoists Personal Lift ER User Manual
Hasbro Games 07148 User Manual
Hotpoint Oven SE103PGX User Manual
Hotpoint Refrigerator FFB6200AP User Manual
Hustler Turf Mobility Aid Z User Manual
IBM Switch S05L 1270 01 User Manual