HAIR CLIPPER
TITAN
MC 4540
ENGLISH
SAFETY_______________________________________________
Please note the following
information when using the
appliance:
7
7
7
The appliance is designed for
domestic use only.
Do not immerse the appliance in
water completely.
7
To prevent damage and danger
from improper use, please
observe the operating instructions
and keep them in a safe place.
The appliance may only come
into contact with water when it is
disconnected from the mains
adapter and this is not plugged
in.
7
Never use the appliance in the
bath, shower or over a wash-
basin filled with water when it is
connected to the mains plug; nor
should it be operated with wet
hands in this case.
7
7
Do not drop the appliance.
Keep the appliance away from
children.
7
Do not open the appliance under
any circumstances. No warranty
claims are accepted for damage
caused by incorrect handling.
7
When the appliance is being
charged or operated via a mains
plug it must not come into contact
with water or any other liquid.
Even the proximity to water is a
hazard.
7
Always pull out the mains
adapter after charging.
ENGLISH
15
OVERVIEW__________________________________________
Fold out page 2 so that you have
the illustrations in front of you.
Controls
Accessories
A
Ceramic blade of the cutting
head.
1
2
3
4
Mains adapter.
Charging unit.
Storage case.
B
C
Steel blade of the cutting head.
Switch for switching on and
off.
Eight comb attachment for dif-
ferent trim lengths and for
making hair thinner.
D
E
Charge indicator.
Socket for plugging in the
mains adapter plug or con-
necting to the charging unit.
5
6
7
Oil.
Scissors.
Cleaning brush.
F
Mains adapter cable in the
socket of the charging unit.
G
H
Charging unit.
Attached comb attachment.
ENGLISH
16
POWER SUPPLY___________________________________
Operation with
rechargeable batteries
7
When using the built-in recharge-
able nickel metal hydride batteries,
use the mains adapter supplied as a
charger.
When fully charged, the
appliance works for around
45 minutes. It is not advisable to
charge the batteries after every
use, especially if you do not use
the appliance for the full 45 min-
utes. Only charge the batteries
when they are completely dis-
charged. This increases their life.
Do not charge them every day.
1 Plug the mains adapter into the
E
socket, and plug the mains
adapter into the mains socket.
D
– The display
»Charge«.
lights up on
– Once loading is complete, the
display changes to »Full«.
Using the charging unit
E
1 Plug the socket
of the
Notes
appliance into the plug in the
charging unit.
7
Completely charge up the batter-
ies (12 hours) before you first use
them or if you have not used
them for a long time.
2 Plug the mains adapter cable
into the socket of the charging
unit.
7
The charging time is 12 hours
when the appliance is switched
off. If you switch on the appliance
while it is charging, charging will
stop.
3 Insert the mains adapter plug in
the socket.
Note
7
Ensure that the appliance and the
charging station are completely
dry before charging.
7
The ambient temperature should
be between 5 °C and 40 °C.
ENGLISH
17
POWER SUPPLY___________________________________
Mains operation
(with mains adapter)
Environmental note
This appliance contains nickel
Check if the mains voltage on the
supplied mains adapter type plate
corresponds to your local mains
supply. The only way to disconnect
the device from the mains supply is
to unplug the adapter.
7
metal hydride batteries. Do not
dispose of it with your household
waste at the end of its service life.
Open the housing. Take the used
batteries out and make sure to
dispose of them in an environ-
mentally sound manner, for
example using public recycling
sites. Find out about the legal
regulations which apply in your
area.
1 Plug the mains adapter cable
E
into the
socket.
2 Insert the mains adapter plug in
the socket.
– The built-in batteries are
switched off.
Note
7
Only use the appliance in battery
mode when in the bathroom or
beside a water connection; never
run it from the mains.
ENGLISH
18
OPERATION ________________________________________
Special features
The appliance has a ceramic/stain-
A
B
less steel ( and
cutting head.
)
Trimming hair
2
2
1 Put on a comb for the cutting
grade you need (see the table
below).
3 Place a towel around the neck
and shoulder of the person
1
whose hair you are trimming.
Make sure the person is seated
so that their head is roughly at
your eye level. Before trimming,
comb the hair so that it falls nat-
urally and you can see the direc-
tion in which it grows.
1
2 To do this, latch the holders
4 Switch on the appliance using
of the comb attachment into the
pins on the right and left side of
the appliance . First, push the
left holder over the left pin, then
the right holder over the right
pin. Ensure that the holder you
fixed first does not spring off the
pin while you are doing this.
C
the switch
and start trimming.
2
C
5 Turn off the appliance using the
switch when you have finished
trimming.
6 Take off the comb.
ENGLISH
19
OPERATION ________________________________________
Comb attachment grades
Useful tips
7
Hold the appliance with a
Comb #1
Comb #2
Comb #3
Comb #4
Comb #5
Comb #6
Comb #7
Comb #8*
2 mm
3 mm
6 mm
relaxed and comfortable grip.
7
Always cut against the natural
direction of the hair.
9 mm
7
As you cut, take a break at regu-
12 mm
16 mm
20 mm
lar intervals. You can always
make a correction, but not once
the hair has been cut.
7
Only cut a small amount the first
time you use the trimmer. This is
the only way to get used to the
variable grades.
* is designed for thinning out hair.
Note
7
The stated trim lengths describe
7
Do not force the comb through
the hair. Let it guide you.
the remaining hair length. All the
lengths here are approximate.
7
Keep combing the hair. Only look
for hair which is too long and
comb out clippings.
Note
7
Without the mains adapter, the
charged appliance can be used
for wet hair in the bathroom.
Never immerse the appliance in
water and never let the charging
station, mains adapter and cable
come into contact with water.
ENGLISH
20
CLEANING AND CARE___________________________
Cleaning and care
1 Switch off the appliance and
unplug it if you are running it
from the mains.
5 Do not use cleaning agents.
6 Put the comb back on again.
Notes
2 Take off the comb.
7
Remove any clippings after each
3 Clean the housing, the cutting
head and the comb attachment
with a soft damp cloth or the
supplied brush.
use.
7
Normally the cutting head of your
appliance does not need to be
oiled. If you want to maintain the
original condition of the cutting
head for as long as possible, it is
worth oiling it at regular intervals
(with the oil provided).
Note
7
The cutting head and the
appliance can be cleaned under
running water. However, you
must never completely immerse
the appliance in water.
4 Before using the appliance
again, dry all parts completely
using a towel.
ENGLISH
21
CLEANING AND CARE___________________________
Storage
Environmental note
If you do not want to use the
This product has been made from
appliance for a long period of time, high-quality parts and materials
please store it carefully.
which can be re-used and recycled.
1 Ensure that it is unplugged and
Therefore, do not throw the product
away with normal household waste
at the end of its life. Take it to a col-
lection point for recycling electrical
and electronic devices. This is indi-
cated by this symbol on the product,
in the operating manual and on the
packaging.
completely dry.
2 Store the parts in the original
packaging in a cool, dry place.
3 Make sure the appliance is kept
out of reach of children.
Please find out about collection
points operated by your local
authority.
Help protect the environment by
recycling used products.
ENGLISH
22
INFORMATION ____________________________________
Guarantee
Technical data
The guarantee does not cover the
cutting head or defects which do
not significantly impair the value or
function of the appliance. The guar-
antee is invalidated if the appliance
is damaged, opened or improperly
used.
This product fulfils the
European directives
89/336/EEC and
73/23/EEC.
Power supply
Batteries: Nickel metal hydride
Mains adapter
Ni-MH
Technical and design modifications reserved.
ENGLISH
23
________________________________
INFORMATIONEN
Service und Ersatzteile
Unsere Geräte werden nach den neuesten technischen
Erkenntnissen entwickelt, produziert und geprüft. Sollte
trotzdem eine Störung auftreten, so bitten wir Sie, sich mit
Ihrem Fachhändler bzw. mit der Verkaufsstelle in Verbindung
zu setzen. Sollte dies nicht möglich sein, wenden Sie sich
bitte an das GRUNDIG-Service-Center unter folgenden
Kontaktdaten:
Telefon: 0180/5231852*
(Montag bis Freitag von 08.00 bis 18.00 Uhr)
Telefax: 0180/5231846*
E-Mail: [email protected]
*12 Cent/Min. aus dem deutschen Festnetz. Änderungen vorbehalten.
Unter den obengenannten Kontaktdaten erhalten Sie
ebenfalls Auskunft über den Bezug möglicher Ersatz- und
Zubehörteile.
24
________________________________
INFORMATIONEN
GRUNDIG Kundenberatungszentrum
Montag bis Freitag von 8.00 bis 19.00 Uhr
Deutschland:
Österreich:
0180 / 523 18 80 *
0820 / 220 33 22 **
* gebührenpflichtig (0,12 €/Min. aus dem Festnetz)
** gebührenpflichtig (0,145 €/Min. aus dem Festnetz)
Haben Sie Fragen?
Unser Kundenberatungszentrum steht Ihnen werktags stets von
8.00 – 19.00 Uhr zur Verfügung.
25
Grundig Multimedia B.V.
72011 900 7000
|