Grizzly Work Light H0614 User Manual

MODEL H0614/H0615  
HAND CRANK  
HOSE REEL  
INSTRUCTIONS  
Mounting  
3
Use ⁄8" hardware through the four holes of the  
hose reel base to firmly secure the assembly to a  
convenient and stable location.  
To reduce the risk of injury when using this  
tool:  
Make sure the incoming air pressure  
does not exceed the maximum rating  
of 300 PSI. Otherwise the fittings could  
crack or explode.  
Assembly  
1. Insert the handle shaft through the handle,  
then secure the assembly to the crank with  
the lock nut and flat washer, as shown in  
Figure 2.  
Protect your eyes by wearing safety  
glasses or a face shield when assem-  
bling and using this hose reel.  
Pressurized air may cause injury to  
exposed body parts. Never expose any  
part of your body to pressurized air.  
Make sure the hose reel is firmly mounted  
to a stable surface before pressurizing.  
Swivel  
Handle  
Connector  
Specifications  
Max. Incoming Air Pressure................... 300 PSI  
Max. Hose Length on Reel for H0614....... 100 ft.  
Max. Hose Length on Reel for H0615.........50 ft.  
Air Fitting Size ........................................ 38" NPT  
Reel Hose  
Connection  
Inventory  
Use the list below and Figure 1 to inventory the  
Figure 2. Assembly components (Model H0614  
shown).  
contents of the shipping box.  
Note: Use Teflon pipe tape or thread seal-  
ant on all threaded connections. Also, do not  
overtighten the connections or you may dam-  
age the threads, resulting in leaks.  
Description  
Qty  
A. Hose Reel Assembly (not shown) .............. 1  
B. Swivel Connector 38" x 38" NPT................. 1  
C. Handle........................................................ 1  
D. Handle Shaft .............................................. 1  
E. Lock Nut 516"-18.......................................... 1  
F. Flat Washer 516" ......................................... 1  
2. Install the swivel connector into the center  
axle on the opposite side from handle (see  
Figure 2), then connect the incoming air sup-  
ply to it.  
3
3. Connect the reel hose to the 8" reel hose  
C
connection shown in Figure 2.  
B
4. Turn the air pressure ON, then use soapy  
water to test for leaks. If any are found, turn  
the air pressure OFF, relieve the pressure  
from the hose, then repair the leaks before  
putting the hose reel into operation.  
D
F
E
Figure 1. Model H0614/H0615 small item  
inventory.  
 

Grizzly Trimmer H2867 User Manual
Haier Washer Dryer 0020504712K User Manual
Harbor Freight Tools Landscape Lighting 93098 User Manual
Harbor Freight Tools Welder 45689 User Manual
HP Hewlett Packard Computer Drive C5445 90906 User Manual
Humax Cable Box ND 1000C User Manual
Humax Flat Panel Television LDE 32DST User Manual
Hunter Fan Ventilation Hood 83006 User Manual
Hypertec Carrying Case N12228PHY User Manual
Image Treadmill IMTL496060 User Manual