MODEL T10048
COLLET/TOOLING CART
FOR NT40
INSTRUCTIONS
Introduction
the Model t10048 is a specialized cart to keep
your nt40 collets and tooling organized, pro-
tected, and close at hand. the top and middle
shelves hold a total of 48 collets with additional
space for storing tooling on the lower and two end
shelves. Collet holders are non-marring and can
be marked for quick identification—ideal for CnC
machines. the heavy-duty rubber casters provide
easy movement of the cart and can lock the cart
in place.
Figure 1. Model t10048 collet/tooling cart.
Specifications
number of Collet holders................................ 48
overall dimensions ........39"L x 181⁄4"W x 347⁄8"h
end shelf dimensions.................... 18"W x 93⁄4"L
Weight .......................................................70 lbs.
If you need help with your new item, call our Tech
Support at: (570) 546-9663.
This cart is designed to ONLy hold metal-
working collets and tooling. DO NOT stand
or sit on any part of this cart. DO NOT use or
modify this cart for any other purpose than
what it was designed for. Failure to heed
these instructions could lead to serious per-
sonal injury or property damage.
Figure 2. example of use.
Copyright © ApriL, 2008 By grizzLy industriAL, inC.
WARNING: NO pORTION OF ThIS MANUAL MAy bE REpRODUCED IN ANy ShApE
OR FORM WIThOUT ThE WRITTEN AppROvAL OF GRIzzLy INDUSTRIAL, INC.
#ts10611 printed in ChinA
3. slide the middle shelf onto the mounting
flanges of the side panels and secure it in
place with 12 hex bolts and lock nuts, as
shown in Figure 7.
5. Attach the side shelf supports to the side
shelves with 8 hex bolts and lock nuts, as
shown in Figure 9. Fully tighten these fasten-
ers.
Note: There are two possible mounting
positions for the middle shelf, as shown in
Figure 6.
Note: Take special note of the orientation of
the shelf and supports to one another.
side panel
Middle shelf
side
shelf
supports
Lower Mounting
position
Figure 9. side shelf supports installed.
Figure 7. Middle shelf installed onto the side
panels.
6. Attach the side shelf assemblies to the side of
the cart opposite the handle with 8 hex bolts
and lock nuts, as shown in Figure 10. Fully
tighten these fasteners.
4. slide the top shelf over the top of the side
panels, position the handle on one side, as
shown in Figure 8, then secure the top shelf
and handle in place with 12 hex bolts and
lock nuts.
Note: There are two possible mounting posi-
tions for the bottom side shelf assembly.
handle
top shelf
Figure 8. top shelf and handle installed.
Figure 10. side shelf assemblies installed.
-3-
t10048 Collet/tooling Cart for nt40
7. square up the sides of the cart with the top
and middle shelves, then fully tighten all fas-
teners.
9. With assistance, tip the cart upright, then
check for stability and use. if necessary,
loosen fasteners, readjust the panels and
shelves, then re-tighten the fasteners.
8. With assistance, turn the cart upside down
and install the casters with 16 hex bolts and
lock nuts, as shown in Figure 11.
Note: To better move the cart, we recom-
mend installing the swivel casters on the
same side as the handle.
Fixed Casters
swivel Casters
Figure 11. Casters installed.
-4-
t10048 Collet/tooling Cart for nt40
|