Grizzly Grinder H6193 User Manual

MODEL H6193  
1
4" INDUSTRIAL  
DIE GRINDER  
INSTRUCTION SHEET  
EyE/EAR INJURy HAzARD!  
Wear safety glasses and  
hearing protection during  
use of this tool!  
INJURy HAzARD!  
Always disconnect tool from  
air to prevent unexpected  
operation during service!  
EXpLOSION HAzARD!  
Never exceed 90 pSI! Always  
use accessories with correct  
speed rating.  
Figure 1. Model H6193.  
RESpIRATORy HAzARD!  
Grinding produces fine  
dust. Wear the appropriate  
protection during use!  
Die Grinder MUSt have 3-4 drops of oil directly  
dropped into the air fitting before each use as  
shown in Figure 2.  
Introduction  
No load speed is 22,000 RPM and collet size is 14".  
Requires a maximum of 90 PSI with a minimum of  
4 CFM compressor capacity. Air inlet is 14" and air  
exhaust is in the front. Weighs 1.2 lbs.  
Inventory  
A. Die Grinder................................................. 1  
B. Wrenches ................................................... 2  
Figure 2. lubricating directly into air fitting.  
If you need help with your new pneumatic tool, call  
our Tech Support at: (570) 546-9663.  
Operation  
Insert your 14" shank tool into the collet. Using the  
two wrenches, secure tool by tightening the collet  
against the spindle.  
CoPyRIGHt © FebRUARy, 2006 by GRIzzly INDUStRIAl, INC. RevISeD SePteMbeR, 2009 (bl)  
WARNING: NO pORTION OF THIS MANUAL MAy BE REpRODUCED IN ANy SHApE  
OR FORM WITHOUT THE WRITTEN AppROvAL OF GRIzzLy INDUSTRIAL, INC.  
#PC8031 PRINteD IN tAIWAN  
 

Graco Crib 1757431 User Manual
Grizzly Sander G1183 G1276 User Manual
Harman Kardon Stereo Receiver AVR 630 User Manual
Havis Shields Automobile Accessories C MCB CV User Manual
Hotpoint Dishwasher FDD 914 User Manual
Hotpoint Refrigerator HTS18BCM User Manual
HP Hewlett Packard Camera Accessories YTH 2242 T User Manual
HP Hewlett Packard Car Video System L1725 User Manual
HP Hewlett Packard Network Card U522 User Manual
HSM Power Supply CMN3000R User Manual