Graco Cordless Drill 233725 User Manual

OPERATION –  
UTILIZAÇÃO –  
FONCTIONNEMENT –  
FUNCIONAMIENTO  
309402  
Rev. C  
Line Drivert  
Model 233725  
10 mph (16 kph) Maximum Operating Speed / de vitesse de fonctionnement maximum / de  
velocidade operando se máxima / de la velocidad de funcionamiento máxima  
Related manuals  
Manuais associados  
Manuels afférents  
Manuales relacionados  
All models not available in all countries.  
Nem todos os modelos existem à disposição em todos os países.  
Tous les modèles ne sont pas disponibles dans tous les pays.  
Hay modelos que no se distribuyen en todos los países.  
How To Perform:  
S Component Identification . . . . . . . . . . . . . . . . 4  
S Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6  
S Startup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9  
S Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9  
GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440–1441  
ECOPYRIGHT 2001, GRACO INC.  
Graco Inc. is registered to I.S. EN ISO 9001  
 
WARNING  
MOVING VEHICLE HAZARD  
MOVING VEHICLE HAZARD  
Careless and reckless behavior causes  
accidents. Falling from vehicle, running into  
people or objects, or being struck by other  
vehicles may result in serious injury or  
death.  
Careless and reckless behavior causes  
accidents. Falling from vehicle, running into  
people or objects, or being struck by other  
vehicles may result in serious injury or  
death.  
D
Use appropriate traffic control in all traffic  
areas  
D
Use appropriate traffic control in all traffic  
areas  
D
D
D
D
D
D
Do not step on forward/reverse pedals  
Make turns slowly  
D
D
D
D
D
D
Do not step on forward/reverse pedals  
Make turns slowly  
Do not carry passengers  
Do not carry passengers  
Do not operate on slopes greater than 15_  
Loss of traction may occur going downhill  
Do not operate on slopes greater than 15_  
Loss of traction may occur going downhill  
Reference Manual on Uniform Traffic  
Control Devices (MUTCD), U.S. Depart-  
ment of Transportation, Federal Highway  
Administration or local highway and trans-  
portation regulations for proper traffic  
control.  
Reference Manual on Uniform Traffic  
Control Devices (MUTCD), U.S. Depart-  
ment of Transportation, Federal Highway  
Administration or local highway and trans-  
portation regulations for proper traffic  
control.  
D
D
D
Do not make turns greater than 45_  
Do not tow  
D
D
D
Do not make turns greater than 45_  
Do not tow  
Use with line striping equipment only  
Use with line striping equipment only  
FIRE AND EXPLOSION HAZARD  
Fuel spilled on a hot surface can  
cause a fire or explosion and serious  
bodily injury or death. Shut off engine  
and let engine cool before filling tank.  
FIRE AND EXPLOSION HAZARD  
Fuel spilled on a hot surface can  
cause a fire or explosion and serious  
bodily injury or death. Shut off engine  
and let engine cool before filling tank.  
HOT SURFACE HAZARD  
Engine and drive housing may be very  
hot during operation and could burn skin  
if touched.  
HOT SURFACE HAZARD  
Engine and drive housing may be very  
hot during operation and could burn skin  
if touched.  
TOXIC FUMES HAZARD  
TOXIC FUMES HAZARD  
Engine produces carbon monoxide which is a  
deadly gas. Do not operate in an enclosed  
area. Breathing carbon monoxide may result  
in serious injury or death.  
Engine produces carbon monoxide which is a  
deadly gas. Do not operate in an enclosed  
area. Breathing carbon monoxide may result  
in serious injury or death.  
309402  
3
 
Component Identification  
T
L
S
A
K
J
M
R
B
P
N
C
D
Adjust coupler pressure  
on 1–7/8 in. receiver ball  
before use  
H
E
F
G
A
B
C
D
E
Wheel Release  
Engine  
Engine ON/OFF  
Light  
Tires: inflate to equal and  
Rated Pressure  
F
G
H
J
Direction/Speed Pedals  
Step Plate  
Coupler  
Hitch  
K
L
Safety Pin Location  
Handle Open  
Handle Locked  
Parking Brake  
Storage  
M
N
P
R
S
T
Seat Adjustment  
Operator Seat  
Hydraulic Fill Cap  
4
309402  
 
Setup  
Unpack Line Driver  
1. Remove Line Driver from packing.  
2. Disengage drive wheels. This makes  
it easier to roll the Line Driver.  
Release  
Engage  
3. Hand tighten after use.  
Connect Hitch Receiver to Line Striper – Hitch Receiver Kit 245321 Manual 309405  
Connect Line Driver to Line Striper  
1. Install Line Driver hitch coupler to LineLazer hitch receiver ball.  
(M)  
2. Latch coupler to locked position (M)  
3. Insert safety pin in latch  
309402  
5
 
Setup  
Individual Operator Adjustments  
Seat  
Adjust seat forward/backward with lever (R) below seat  
Pedals  
Suggestion: Adjust one pedal for full motion forward  
and one for full motion in reverse. This reduces fatigue.  
1. Loosen two bolts (C) at  
underside of pedals  
Example:  
Reverse  
Forward  
2. Rotate pedal to desired position  
3. Tighten bolts.  
C
Striper Handle  
Bars  
Refer to your striper manual  
6
309402  
 
Startup  
1. Check engine oil level. Add SAE 10W–30  
(summer) or 5W–20 (winter), if necessary.  
Note: Keep engine oil at full level to avoid  
nuisance stalls because Oil Alert may sense  
low oil levels during change of direction of  
Line Driver  
(cold)  
2. Fill fuel tank.  
3. Check hydraulic oil level. Add only Mobil 1 (15W–50)  
synthetic oil. Hydraulic system capacity is 2 quarts.  
Fill to baffle top  
309402  
7
 
Startup  
4. Start engine  
a. Engage parking brake  
b. Move fuel valve to open  
c. Move choke to closed  
d. Set throttle to fast  
a.  
b.  
d.  
e. Set engine switch ON  
f. Pull starter cord  
c.  
g. After engine starts, move  
choke to open  
h. Set throttle to desired speed for  
striping.  
e.  
g.  
f.  
h.  
8
309402  
 
Operation  
Note: Line Driver motion is forward  
and reverse. Turns are made with the  
striper.  
1. Squeeze hand control and  
release caster wheel.  
2. Push striper handle bars to  
begin desired turn.  
309402  
9
 
Operation  
Note: Line Driver stops when both  
feet are removed from pedals  
1. Move pedal(s) forward to  
drive Line Driver forward  
2. Move pedal(s) reverse to  
drive Line Driver reverse  
3. Switching from forward to re-  
verse creates a braking action  
Reverse  
Forward  
4. Set parking brake when not  
operating Line Driver  
Note: The Line Driver can not be  
started if the parking brake is not set.  
The operator must be seated when  
the parking brake is released or the  
Line Driver will stop running.  
RELEASE  
ENGAGE  
10  
309402  
 
Troubleshooting  
PROBLEM  
CAUSE  
SOLUTION  
Engine does not start  
Parking brake not engaged. Engine  
switch OFF, no gasoline or low oil  
Set Brake. Consult engine manual, supplied  
Engine races to high rpm – stalls  
during operation  
Worn governor  
Consult engine manual, supplied  
Engine operates, Line Driver does  
not move forward or reverse  
Low hydraulic oil  
Fill with Mobil 1 (15W–50) synthetic oil  
Engine operates, Line Driver moves Low hydraulic oil. Parking brake is set Fill with Mobil 1 (15W–50) synthetic oil. Release  
slowly in forward and reverse  
parking brake.  
Wheel release is open.  
Safety switch  
Close; hand tight.  
Engine shuts off when operator ex-  
its Line Driver  
Set parking brake  
Engine continues to run when oper- Safety switch  
ator exits Line Driver and parking  
brake is not set  
Adjust and set parking brake. Replace safety  
switch and/or any connecting wires.  
Engine misses during turns and for- Engine oil low  
ward and reverse changes  
Consult engine manual for proper oil  
Adjust brake. Manual 309404.  
Parking brake does not keep Line  
Driver from moving  
Parking brake needs adjustment  
Line Driver creeps in forward or re-  
verse direction  
Control linkage needs adjustment  
Adjust control linkage. Manual 309404.  
309402  
11  
 
Graco Warranty  
Graco warrants all equipment listed in this manual which is manufactured by Graco and bearing its name to be free from defects in  
material and workmanship on the date of sale to the original purchaser for use. With the exception of any special extended or limited  
warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment  
determined by Graco to be defective. This warranty applies only when the equipment is installed, operated and maintained in  
accordance with Graco’s written recommendations.  
This warranty does not cover, and Graco shall not be liable for general wear and tear, or any malfunction, damage or wear caused by  
faulty installation, misapplication, abrasion, corrosion, inadequate or improper maintenance, negligence, accident, tampering, or  
substitution of non-Graco component parts. Nor shall Graco be liable for malfunction, damage or wear caused by the incompatibility of  
Graco equipment with structures, accessories, equipment or materials not supplied by Graco, or the improper design, manufacture,  
installation, operation or maintenance or structures, accessories, equipment or materials not supplied by Graco.  
This warranty is conditioned upon the prepaid return of the equipment claimed to be defective to an authorized Graco distributor for  
verification of the claimed defect. If the claimed defect is verified, Graco will repair or replace free of charge any defective parts. The  
equipment will be returned to the original purchaser transportation prepaid. If inspection of the equipment does not disclose any defect  
in material or workmanship, repairs will be made at a reasonable charge, which charges may include the costs of parts, labor, and  
transportation.  
Graco’s sole obligation and buyer’s sole remedy for any breach of warranty shall be as set forth above. The buyer agrees that no other  
remedy (including, but not limited to, incidental or consequential damages for lost profits, lost sales, injury to person or property, or any  
other incidental or consequential loss) shall be available. Any action for breach of warranty must be brought within two (2) years of the  
date of sale.  
GRACO MAKES NO WARRANTY, AND DISCLAIMS ALL IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR  
A PARTICULAR PURPOSE IN CONNECTION WITH ACCESSORIES, EQUIPMENT, MATERIALS OR COMPONENTS SOLD BUT  
NOT MANUFACTURED BY GRACO. These items sold, but not manufactured by Graco (such as electric motors, gas engines,  
switches, hose, etc.), are subject to the warranty, if any, of their manufacturer. Graco will provide purchaser with reasonable assistance  
in making any claim for breach of these warranties.  
In no event will Graco be liable for indirect, incidental, special or consequential damages resulting from Graco supplying equipment  
hereunder, or the furnishing, performance, or use of any products or other goods sold hereto, whether due to a breach of contract,  
breach of warranty, the negligence of Graco, or otherwise.  
FOR GRACO CANADA CUSTOMERS  
The parties acknowledge that they have required that the present document, as well as all documents, notices and legal proceedings  
entered into, given or instituted pursuant hereto or relating directly or indirectly hereto, be drawn up in English. Les parties  
reconnaissent avoir convenu que la rédaction du présente document sera en Anglais, ainsi que tous documents, avis et procédures  
judiciaires exécutés, donnés ou intentés à la suite de ou en rapport, directement ou indirectement, avec les procédures concernées.  
ADDITIONAL WARRANTY COVERAGE  
Graco does provide extended warranty and wear warranty for products described in the “Graco Contractor Equipment Warranty  
Program”.  
Graco Phone Number  
TO PLACE AN ORDER, contact your Graco distributor, or call this number to identify the distributor closest to you:  
1–800–690–2894 Toll Free.  
All written and visual data contained in this document reflects the latest product information available at the time of publication.  
Graco reserves the right to make changes at any time without notice.  
mm 309402  
This manaul contains English, Portuguese, French, Spanish  
Graco Headquarters: Minneapolis  
International Offices: Belgium, Korea, China, Japan  
GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440–1441  
10/2001, Revised 8/2006  
12  
309402  
 

Graco Swing Sets ISPS035AB User Manual
Haier Microwave Oven MWG7036RW User Manual
Harbor Freight Tools Battery Charger 03418 User Manual
Heat Glo LifeStyle Stove WS 150 User Manual
Honeywell Clock PCR11ELW User Manual
Honeywell Home Security System MIP 2 User Manual
Humminbird Two Way Radio VHF55S User Manual
IBM Carpet Cleaner SC23 8765 00 User Manual
Ice O Matic Ice Maker MFI0500 User Manual
Impex Home Gym IGS 09 User Manual