Troubleshooting Guide
U N I N T E R R U P T I B L E
System
Probable Cause
Recommended Solution
Connect power cord
GN
Power switch to “I” Power cord disconnected
Position & LED and
Alarm are OFF
Power Supply
675VA
City power failure
Turn the power switch to “O”
position. When the city power has
resumed, turn the power to “I.”
GN-675VA
AC fuse blown
Remove the load from the GN-
675VA. Check the fuse near outlet,
replace the fuse if it is blown.
USER GUIDE
GN-675VA
Control PCM error
Call Dealer for Service
Power switch to “I” GN-675VA input voltage
Make sure the voltage of city
power is correct.
position & LED is
blinking YELLOW
over HI transfer voltage or
under low transfer voltage
Control PCB error
Call Dealer for Service
Red LED Light on
Battery under or GN-675VA
as been shutdown
Charge battery, shut down,
condition will release automatically.
Internet Protection
LINE MODEM
GN-675VA
Back Panel
Functions
STATUS
LAN
To Modem
Interface
From
Telephone
Line
Outlet
Socket
Main
Switch
Outlet
Socket
Overview:
The GN-675VA protects your sensitive electronic equipment from power disturbances. A power
outage can occur when you least expect it – threatening the loss of critical data. The Genica
GN-675VA Uninterruptible Power Supply works as a battery back up to protect your
equipment and data in the event of a power loss. In addition, the ARV (automatic voltage
regulator) and built-in line conditioner provides stable voltage when power fluctuates.
AC Input
Socket
Outlet
Socket
Fuse &
Spare
Fuse
Also includes modem protection! By routing your modem cable through the GN-675 your
modem will also be protected from damage by occurrences such as a lightning strike.
|