®
POWERSHRED 63Cb
Please read these instructions before use.
Do not discard: keep for future reference.
Quality Office Products Since 1917
ADvANCED PRODUCT FEATURES
SafeSense® Technology
Stops shredding immediately when
hands touch the paper opening
Energy Savings System
Optimal energy efficiency 100% of
the time – in use and out of use
Jam BlockerTM
Blocks jams before
they start
JAM BLOCKERTM
If Remove Paper icon illuminates during the shredding process
(due to paper misfeed or wrinkle) follow the procedures below.
Blocks jams before they start
3
1
2
1
2
If Remove Paper icon ( ) is
illuminated, there is too much paper
for the shredder to power through
Shredder pauses for
3 seconds
Reduce paper quantity to
an acceptable amount and
refeed into paper entry
Set to Auto On ( ) and
refeed into paper entry
Set to Reverse (
and remove paper
)
ENERGY SAvINGS SYSTEM
SAFESENSE® TECHNOLOGY
Optimal energy efficiency 100% of the time –
in use and out of use.
Stops shredding immediately when hands touch the paper opening.
• Saves energy in four ways: energy-efficient electronics, jam prevention,
standby mode and sleep mode.
SET-UP AND TESTING
• Sleep Mode shuts down shredder after 2 minutes of inactivity.
1
2
3
4
WHEN IN SLEEP MODE
1
2
3
or
®
®
Set to Auto On (
)
Touch test area and
look for the SafeSense
indicator to illuminate
SafeSense is active and If hand is held on SafeSense
®
working properly
area more than 3 seconds
shredder will shut off
To get out of sleep mode set to
OFF ( ), then Auto On (
In sleep mode
Insert paper
)
PRODUCT MAINTENANCE
OILING SHREDDER
CLEANING AUTO-START INFRARED SENSORS
All cross-cut shredders require oil for peak performance. If not oiled, a
machine may experience diminished sheet capacity, intrusive noise when
shredding and could ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty your waste bin.
Paper detection sensors are designed for maintenance free operation. However, on rare occasions, the
sensors may become blocked by paper dust causing the motor to run even if there is no paper present.
(Note: two paper detection sensors are located in the center of the paper entry).
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
TO CLEAN THE SENSORS
2
1
3
2
3
4
1
Press and hold Reverse
Set to Off (
)
*Apply oil across entry
Turn off ( ) and
unplug shredder
Locate Auto-start
infrared sensor
Dip cotton swab in
rubbing alcohol
Using cotton swab, wipe
away any contamination
from the paper sensors
(
) 2-3 seconds
*Only use a non-aerosol vegetable oil in long
nozzle container such as Fellowes 35250
TROUBLESHOOTING
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This
indicator will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about
the continuous operation and recovery time for this shredder.
Bin Open: The shredder will not run if the bin is open. When illuminated, close the bin to resume shredding.
Remove Paper: When illuminated, press reverse (
) and remove paper. Reduce paper quantity to an acceptable amount and refeed into paper entry.
SafeSense® Indicator: If hands are too close to the paper entry, the SafeSense® indicator will illuminate and the shredder will stop shredding. If SafeSense®
is active for 3 seconds, the shredder will automatically turn off and the user must set the switch to OFF ( ), then Auto On ( to resume shredding.
)
3
®
POWERSHRED 63Cb
Declaration of Conformity
Fellowes Manufacturing Company
Yorkshire Way, West Moor Park, Doncaster, South Yorkshire, DN3 3FB, England declares that the product Model 63Cb conforms with the requirements of the Restriction of Hazardous Substances
Directive (2011/65/EU), the Low Voltage Directive (2006/95/EC), the Electromagnetic Compatibility Directive (2004/108/EC), the WEEE directive (2002/96/EC), and below harmonized European
EN Standards.
Safety: EN 60950-1
EMC Standard: EN55014-1
Year Affixed: 12
EN55014-2
EN61000-3-2
EN61000-3-3
Itasca, Illinois, USA
January 1, 2013
James Fellowes
W.E.E.E.
This product is classified as Electrical and Electronic Equipment. Should the time come for you to dispose of this product please ensure that you do so in accordance with the European Waste of Electrical
and Electronic Equipment (WEEE) Directive and in compliance with local laws relating to this directive.
For more information on the WEEE Directive please visit www.fellowesinternational.com/WEEE
LIMITED PRODUCT WARRANTY
Limited Warranty: Fellowes, Inc. (“Fellowes”) warrants the parts of the machine to be free of additional costs incurred by Fellowes to provide parts or services outside of the country where the
defects in material and workmanship and provides service and support for 2 years from the date shredder is initially sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF
of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION
be free from defects in material and workmanship for 5 years from the date of purchase by the TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable
original consumer. If any part is found to be defective during the warranty period, your sole and for any consequential or incidental damages attributable to this product. This warranty gives you
exclusive remedy will be repair or replacement, at Fellowes’ option and expense, of the defective specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide,
part. This warranty does not apply in cases of abuse, mishandling, failure to comply with product except where different limitations, restrictions, or conditions may be required by local law. For
usage standards, shredder operation using an improper power supply (other than listed on more details or to obtain service under this warranty, please contact us or your dealer.
label), or unauthorized repair. Fellowes reserves the right to charge the consumers for any
Australia Residents Only:
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other
reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
The benefits under Fellowes’ Warranty are in addition to other rights and remedies under a law in relation to the shredder.
Questions or Concerns?
Customer Service & Support
Troubleshooting
Troubleshooting
Registration
Replacement parts
General questions
Manuals
Australia
Europe
+61-1-800-33-11-77
00-800-1810-1810
+44-(0)-1302-836800
+1-800-955-0959
United Kingdom
United States
©2013 Fellowes, Inc. Part No. 406870 Rev B
|