Cordless Household Scrubber
OWNER’S MANUAL
Model SB77H
3.6 V DC
EURO-PRO Operating LLC
U.S.: 94 Main Mill Street, Door 16
Plattsburgh, NY 12901
Canada: 4400 Bois-Franc
St-Laurent, QC H4S 1A7
Tel. :1 (800) 798-7398
OPERATING INSTRUCTIONS
IMPORTANT SAFEGUARDS
When using an electrical appliance, basic safety precautions should always be observed,
including the following
5. Attach the desired brush (large or
narrow brush) to the end of the power
head by pushing it on.
6. To remove the accessories, turn the
unit off and then pull them off the
power head.
7. To remove the power head from the
power wand, press the release button
and pull apart.
Note: Always let the scrubber and
brushes dry completely before storing in a
confined area.
4. Select an appropriate drill type for
the material to be drilled.
5. Carefully measure and
mark the location of all
bracket holes and then
drill holes and screw the
wall mounting bracket
onto the wall. (Fig. 6)
READ ALL INSTRUCTIONS BEFORE USING YOUR CORDLESS HOUSEHOLD
SCRUBBER.
WARNING: To reduce the risk of fire, electrical shock, or injury:
Fig. 6
1. Read and follow all label, operational
and marking instructions.
2. Do not charge this appliance
outdoors.
3. Do not use outdoors or on wet
surfaces.
4. Do not allow to be used as a toy.
Close attention is necessary when
used by or near children.
5. Use only as described in this manual.
Use only manufacturer’s
recommended attachments.
6. Do not use with damaged cord or
plug. Do not use this appliance if it
has been dropped, damaged, left
14. Do not use charger with an extension
cord. Plug charger directly into an
electrical outlet. Use charger only in a
standard (120V., 60Hz) electrical
outlet. Using improper voltage may
result in damage to the motor and
possible injury to the user.
15. This product includes rechargeable
nickel cadmium batteries. Batteries
must be recycled or disposed of
properly. Do not incinerate batteries
or expose to high temperatures, as
they may explode.
6. Insert the hanging hook into the wall
mounting bracket. (Fig. 7)
7. Insert the cordless scrubber into the
hanging hook for charging. (Fig. 8)
Do not leave the cordless
scrubber for more than 24 hours
when it is charging.
8. You can hang the cordless scrubber
from any rod to store as long as it will
not be immersed in water or any
other liquid. (Fig. 9)
To Extend Your Battery Life
•
•
•
Only recharge when the battery is
almost fully discharged.
Completely discharge and recharge
the battery at least once a month.
Do not store the cordless scrubber
with the charging adaptor attached
and plugged in.
16. Do not handle charger or appliance
with wet hands.
•
We do not recommend that the
appliance be left plugged into the
charging adaptor for more that 24
hours.
outdoors, or dropped in water. Return 17. Leaks from battery cells can occur
it to EURO-PRO Operating LLC for
examination, repair or adjustment.
7. Keep hair, loose clothing, fingers, and
all parts of body away from openings
and moving parts.
8. Do not attempt to change
accessories while unit is running.
9. Store the cordless household
scrubber indoors. Store after use to
prevent accidents.
under extreme conditions. If the liquid,
which is 20-35% solution of potassium
hydroxide, gets on the skin - wash
immediately with soap and water or
neutralize with a mild acid such as
lemon juice or vinegar. If the liquid
gets into the eyes, flush them
immediately with clean water for a
minimum of 10 minutes and seek
medical attention.
Fig. 7
Battery Disposal
The Ni-Cd batteries in your cordless
scrubber are not replaceable. When the
Ni-Cd batteries are no longer
recharging, the power wand must be
disposed of properly. Call your nearest
recycling center for information on the
recycling and disposal of Ni-Cd
batteries. Please consult your Yellow
Pages or local recycling center for more
information. Never attempt to throw the
unit into a fire or incinerate it.
Fig. 9
Fig. 8
10. Do not store the appliance near hot
ovens or heating appliances.
18. Do not use for any purpose other than
described in this user’s guide.
11. Never carry the charger by the cord
or yank to disconnect from the
electrical outlet. Always hold the
charger and pull to disconnect.
12. Keep charger cord away from heated
surfaces.
19. Do not attempt to use the charger with
any other product or attempt to charge
this product with another charger. Use
only charger model MCDC080020UA2
supplied with this appliance.
20. This appliance is not submersible. Do
Not immerse in water or any other
liquids.
To Store
To Charge
To Order Replacement Accessories
Please contact customer service at 1 (800)
798-7398 for replacement or additional
brushes or for a new power wand.
Wall Mounting Bracket
13. Turn the appliance to the “Off”
position before recharging.
1. Make sure that the intended wall
area for the wall mounting bracket to
be drilled is free from any hidden
electrical wires, water pipes and gas
lines.
2. Select an appropriate place close to
a wall power outlet (120V., 60 Hz).
3. Do not mount near direct sunlight,
near a heat source or outdoors.
SAVE THESE INSTRUCTIONS
FOR HOUSEHOLD USE ONLY
Rev. 08/05
4
1
GETTING TO KNOW YOUR CORDLESS HOUSEHOLD
SCRUBBER
OPERATING INSTRUCTIONS
Using Your Cordless Household
Assembling Your Cordless
Household Scrubber
Scrubber
Your cordless scrubber has not yet been
charged. Before first use, the power
wand must be charged for a period of 20
hours.
Warning: This appliance is not
submersible. Do not immerse in water
or any other liquids.
1. Make sure that the “On/Off” button
on the power wand is in the “Off”
position.
Your cordless scrubber can be used
with or without the extension wands.
To use without the extension wand:
1. Make sure that the On/Off button
is in the “Off” position.
2. Insert the power head onto the
power wand making sure that it locks
in place. (Fig. 2)
2. Insert the charging jack into the
charging port. (Fig. 1)
Fig. 2
3. Attach the desired brush (large or
narrow brush) to the end of the
power head by pushing it on. (Fig. 3)
Please note that the power head has a
D-shaped shaft and the brushes have a
D-shaped hole that must be properly
aligned for attachment. Do not force the
brushes onto the power head as they
may be damaged.
Fig. 1
3. The red charging light will light up while
the unit is charging.
4. Let the power wand charge for 20
hours.
Note: Your scrubber will work
approximately up to one (1) hour on a
single charge
Fig. 3
Attaching the Accessories to the
Power Head
Your cordless scrubber comes with a
large brush, a narrow brush and two
extension wands.
4. To remove the
accessories, turn
Release
the unit off and
then pull them off
the power head.
Button
1. Power Wand
2. On/Off Button
3. Charging Port
4. Charging Indicator Light
5. Extension Wand
Release Button
5. To remove the power
head from the power
wand, press the
release button
and pull apart. (Fig. 4)
To use the accessories with
one or both extension wands:
1. Make sure that the On/Off button is
in the “Off” position.
2. Insert one of the extension wands
onto the power wand. (Fig. 5) Make
sure that the two pieces lock in place.
Large Brush
Can be used to clean:
Household: tiles, tubs, shower
doors, walls, fiberglass, hard
plastic surfaces, countertops,
backsplashes, patio furniture,
walls and windows.
7. Power Head
8. Narrow Brush
9. Large Brush
10. Wall Mount (screws included)
11. Hanging Hook
Fig. 4
12. Charging Adapter (not shown)
6. Extension Wands (x2)
Automotive: tires, hubcaps, lined truck
beds, vinyl doors.
Illustrations may differ from actual product.
Narrow Brush
Can be used to clean:
Household: bathroom fixtures,
drains, narrow spaces such
as between appliances or hard to reach
corners.
NOTE: The Cordless Household Scrubber is shipped with the
battery uncharged. Charging of the unit for 20 hours prior
to first use is required.
Fig. 5
3. If you want to add the other extension
wand, just attach it to the end of the
first one. Again make sure that the two
extension wands are locked together.
4. Insert the power head onto the
extension wand making sure that it
locks in place.
Extension Wand
Use one or both of the extension wands
to reach high places.
Technical Specifications
Voltage:
3.6 V DC
Power:
20 Watts
2
3
|