Eureka Vacuum Cleaner 1040 Series User Manual

Vacuum Cleaner  
Owner’s Guide  
1040 SHeoursehioeldTyspe  
®
IMPORTANT  
Do not return this product to the  
store.  
For assembly problems or  
questions contact: Eureka’s  
Customer Service Division toll free at  
1-800-282-2886*, 8 a.m. to 7:30 p.m.,  
(CST), Monday - Friday and 10 a.m.  
to 6:30 p.m.Saturday.  
For replacement of broken or  
missing items to be shipped direct to  
you, call 1-800-438-7352*, 8 a.m. to  
4:45 p.m., (CST), Monday - Friday.  
To order replacement parts and  
accessories call 1-800-438-7352*, 8  
a.m. to 4:45 p.m., (CST), Monday -  
Friday or visit our web site,  
*En Mexico llame al 5670-6169.  
Please Retain  
Index  
Important Information ............... 2-3  
HowTo Use............................... 3-4  
Routine Maintenance  
We suggest you record the model, type and serial numbers  
below.They are located on the silver rating plate on your cleaner.  
For prompt and complete service information, always refer to  
these numbers when inquiring about service.  
Dust Bag ................................... 5  
Pre-Motor Filter .......................... 5  
Storage...................................... 5  
Problem Solving  
Guide ......................................... 5  
Warranty ...................................... 5  
Model &Type__________________________________  
Serial No. _____________________________________  
It is also important to keep your receipt as proof of date of  
purchase.  
©2002 White Consolidated, Ltd.  
Printed in U.S.A.  
Part No. 72580A (06/03)  
 
GENERAL INFORMATION  
The cleaner is designed to pick up dirt and dust particles. Avoid picking up hard or sharp objects with the cleaner to prevent  
hose clogs.  
If an extension cord is used it must be 3 wire, grounded type and marked SJTW (suitable for outdoor use) 16 AWG  
minimum.  
Service Information  
The instructions in this booklet serve as a guide to routine maintenance. For additional service information telephone our toll  
free number for the nearest Eureka Authorized Warranty Station. You should know the model, type and serial numbers  
when you call:  
USA: 1-800-282-2886  
Mexico: 5670-6169  
Canada: 1-800-282-2886  
If you prefer, you can write toThe Eureka Company, Service Division, 807 North Main Street, Bloomington, Illinois 61701, USA.  
In Canada write toThe Eureka Company, 866 Langs Drive, Cambridge, Ontario N3H 2N7.Refer toThe Eureka LimitedWarranty  
for complete service information.  
DO NOT OIL the motor at any time.The bearings are permanently lubricated and sealed.  
Thermal Cut Off  
This vacuum cleaner has a special thermostat that protects the cleaner in case of motor overheating. If the cleaner suddenly  
shuts off, push the on/off switch off (0) and unplug the cleaner.Check the cleaner for a possible source of overheating such as  
a full dust bag, a blocked hose or clogged filter. If these conditions are found, fix them and wait at least 30 minutes before  
attempting to use the cleaner.After the 30 minute period, plug the cleaner back in and push the on/off switch on (l).If the cleaner  
still does not run, then take it to a Eureka Authorized Service Center for repair.  
HOW TO USE  
5
1
2
3
8
4
7
6
4
Tool Box Lid Latchs (2). Lift up on latch to release the  
4
tool box lid.  
Carrying Handle. Use this handle to carry unit from one  
place to another.The handle can also be used for electrical  
cord storage.  
1
5
6
7
Suction Inlet. Insert the end of the hose in the inlet to  
use vacuum function.  
Quick Cord Release Button. Press in on button for quick  
access to electrical cord.  
2
3
On/Off Switch. International symbol I means On,  
International symbol O means Off.  
Electrical Cord. The electrical cord can be stored  
wrapped around the handle or inside the tool box  
compartment.  
Electrical Socket. The large end of the electrical cord  
plugs into this socket, the other end into a wall outlet.  
8
Blower Port. Insert the end of the hose into the blower  
port to use the blower function.  
DANGER: Electrical cords can be hazardous. Please  
read safety instructions on electrical cord.  
3
 
HOW TO USE (continued)  
Electrical Cord - For shipping purposes, the electrical  
cord is stored inside the tool box . Open lid latches, lift tool  
tray up, to remove electrical cord.  
Blower Port. Insert larger end of hose into the blower port  
to use as a blower.  
NOTE: Always wear safety goggles  
(not provided). Never point  
blower toward people,  
animals or objects that may  
be injured/damaged by  
flying debris. These units  
must NOT be used to power  
a paint sprayer or to supply  
LiftToolTray  
air to any other sprayer.  
Blower Port  
Suction Inlet. Insert larger end of hose into  
suction inlet to use as a vacuum.  
Suction  
Inlet  
Outlet  
Cover  
Accessories - The accessories are stored on the inside  
of the tool box lid. There are diagrams on the inside of the lid  
to help with placing them back in the correct location.  
Plug round end of electrical cord into the tool box, as shown  
above. Plug the other end of electrical cord into electric  
socket.  
The electrical plug has been designed so an electric tool or  
appliance can be plugged directly into it.  
1. To use accessories remove  
hose from top of the lid by  
lifting up.  
2. Place desired accessory onto  
end of hose or crevice wand.  
Cover unused receptacle when not in use with outlet cover  
(attached to cord as shown).  
Extension Cords  
NOTE: If an extension cord is used, make sure the plug  
connection does not come into contact with any  
liquid. Use a grounded extension cord with 3-prong  
plug and 3-pole receptacle; 16 gauge, SJTW type.  
Loop the cords to prevent unplugging. Suitable for  
outdoor use.  
Dusting/  
Upholstery  
Brush  
Crevice  
Wand  
ON/OFF Switch. International symbol I means On,  
International symbol O means Off.  
Hose or  
Wand  
Dusting/Upholstery Brush is for furniture, blinds,  
books, lamp shades, shelves, curtains, draperies, cushions  
and fabrics.  
ON/OFF  
Switch  
Crevice Wand cleans corners, stairs, baseboards, and  
between cushions.  
Helpful Information:  
Listen to your cleaner.If you notice a change in the sound of the motor or a change in performance, it could simply indicate  
a common usage or maintenance issue.Such as, possible blockage in hose , dirty filter or full dust bag .These are all easy  
to fix and the instructions are included in this owner’s guide. Becoming familiar with the information in this guide will help  
you to get the best possible performance from your new cleaner for many years to come.  
4
 
ROUTINE MAINTENANCE  
NOTE: Turn off the switch and unplug the electrical cord  
before servicing.  
Emptying the Dust Bag and Installing or  
Cleaning the Pre-Motor Filter:  
PROBLEM  
SOLUTION  
The instructions in this booklet serve as a guide to routine  
maintenance.To avoid unnecessary service calls, check the  
dust Bag and filter often.We suggest emptying the dust bag  
after every use.  
Motor will not  
start.  
• Push plug securely into outlet, at each end.  
Try another outlet.  
Check circuit breaker.  
Motor suddenly • Page 5.  
stops.  
NOTE: When vacuuming carpet fresheners or cleaners,  
powder, plaster dust, or similar fine substances,  
the dust bag and filter will require more frequent  
maintenance.  
CAUTION: Turn off the switch and unplug the electrical  
cord before changing the dust bag or filter.  
Never operate the vacuum cleaner without the  
dust bag or filter in place.  
Does not pick • Clean or replace the filters. Hint: If picking up fine  
up debris.  
dust, the filters may not look dirty but a fine  
substance tends to reduce suction when it blocks  
the air flow through the filter(s).  
• Empty dust bag.  
• Be sure hose is secure in suction inlet.  
• Remove any blockages from the hose that restrict  
the airflow.  
Missing parts. • Call 1-800-438-7352 between 8:00 a.m. and 4:45  
p.m., (CST), Monday - Friday. Know the model and  
serial numbers when you call.  
Open the tool box. Lift up on the dust bag compartment  
lid.  
1
Questions?  
• Call 1-800-282-2886 between 8 a.m. to 7:30 p.m.,  
(CST), Monday - Friday and 10 a.m. - 6:30 p.m.  
(CST) Saturday. Know the model and serial  
numbers when you call.  
Bag Compartment Lid  
THE EUREKA LIMITED WARRANTY  
hat This Warranty Covers  
W
Your Eureka cleaner is warranted to be free from all defects in material and workmanship in  
normal household use for a period of one year. The warranty is granted only to the  
original purchaser and members of his or her immediate household. The warranty is subject  
to the following provisions.  
Lift the dust bag out of compartment.While the dust bag  
is out of the cleaner, check the pre-motor filter to see if it  
needs to be cleaned. Pull it up out of the two brackets  
holding it in place.  
2
hat This Warranty Does Not Cover  
W
Parts of the cleaner that require replacement under normal use, such as disposable dust  
bags, filters, drive belts, light bulbs, brush roll bristles, impellers and cleaning.  
Damages or malfunctions caused by negligence, abuse, or use not in accordance with the  
Owner’s Guide.  
Defects or damages caused by unauthorized service or the use of other than Genuine Eureka parts.  
hat The Eureka Company Will Do  
W
The Eureka Company will, at its option, repair or replace a defective cleaner or cleaner part  
that is covered by this warranty. As a matter of warranty policy, the Eureka Company  
will not refund the consumer’s purchase price.  
Dust Bag  
arranty Registration  
W
Please fill out and return the warranty registration card accompanying your cleaner.  
btaining Warranty Service  
O
To obtain warranty service you must return the defective cleaner or cleaner part along with  
proof of purchase to any Eureka Authorized Warranty Station.  
Pre-Motor Filter  
You will find the nearest location in theYellow Pages, under “Vacuum Cleaners–Service and  
Repair.” Be certain that the Warranty Station is “Eureka Authorized.”  
Two  
For the location of the nearest EurekaAuthorizedWarranty Station or for service information  
6169, Canada: 1-800-282-2886.  
If you prefer, you can write to The Eureka Company, Service Division, 807 North Main Street,  
Bloomington, Illinois 61701, USA. In Canada write to The Eureka Company, 866 Langs  
Drive, Cambridge, Ontario N3H 2N7.  
If it is necessary to ship the cleaner outside your community to obtain warranty repair, you  
must pay the shipping charges to the Eureka Authorized Warranty Station.  
Return shipping charges will be paid by the Warranty Station. When returning parts for repair,  
please include the model, type, and serial number from the data plate on the cleaner.  
Brackets  
To clean the pre-motor filter, you can vacuum it with another  
vacuum or wash it under running water. The filter must  
be completely dry before reinstalling in the cleaner.  
3
4
To empty cloth dust bag, hold dust  
bag over a waste container and  
slide the bottom clamp off the dust  
bag. Shake debris into waste con-  
tainer.Reposition plastic clamp at  
base of dust bag.  
urther Limitations and Exclusions  
F
Any warranty that may be implied in connection with your purchase or use of the cleaner,  
including any warranty of Merchantability or any warranty for Fitness For A Particular  
Purpose is limited to the duration of this warranty. Some states do not allow limitations  
on how long an implied warranty lasts, so the above limitations may not apply to you.  
Your relief for the breach of this warranty is limited to the relief expressly provided above.  
In no event shall Eureka be liable for any consequential or incidental damages you  
may incur in connection with your purchase or use of the cleaner. Some states do not allow  
the exclusion or limitation of incidental or consequential damages, so the above  
limitation or exclusion may not apply to you.  
Reinstalling the Pre-Motor Filter and Dust  
Bag:  
This warranty gives you specific legal rights.You may also have other rights which vary by state.  
uestions & Answers about Genuine Eureka Products  
Q
1
To replace the pre-motor filter, slide it down between the  
two brackets in the dust bag compartment. Make sure  
the filter is pushed all the way down to the bottom of the  
brackets.  
Put the dust bag back in the bag compartment and close  
the bag compartment lid.  
Q: Why should I use only Genuine Eureka paper bags, belts, and parts in my Eureka  
vacuum cleaner?  
A: Using Genuine Eureka Products, which are made to our exacting specifications and engineered  
withemphasisonquality,performance,andcustomersatisfaction,ensuresthelonglifeandcleaning  
efficiency of your vacuum cleaner.  
Q: How can I be sure I am using only genuine Eureka products in my vacuum cleaner?  
A: Typically,packaged products and paper bags are labeledGenuine Eureka Product”.  
2
For Genuine Eureka Value, Accept No Imitations!  
Storage:  
THE EUREKA COMPANY  
Store indoors in a cool, dry place. Do not expose to rain.  
Bloomington, Illinois 61701  
5
 

Euro Pro Convection Oven JO287 User Manual
Flymo Lawn Mower Turbo 400 User Manual
Focal Car Speaker 130 KR User Manual
Fostex Stereo System RM 2 User Manual
Franke Consumer Products Ventilation Hood FDF 364 W User Manual
Furuno Stepper Machine LS 6000 User Manual
Gaggia Printer M1005 MFP User Manual
GE Espresso Maker 681131691086 User Manual
GE Network Router IS200ADIIH_A_ _ User Manual
Gianni Industries Switch BTS 400 ANSI User Manual