Owner’s / Instruction Manual
1
CHOOSING AN AMPLIFIER:
LX-18EV2 CONNECTION DIAGRAMS
1) It is important to choose an amplifier that matches the power
rating of the LX-18EV2 (see specifications on back page).
2) When using TWO (2) LX-18EV2 subwoofers in you system you
may choose an amplifier that delivers up to 750 watts @ 8 ohm
stereo or an amplifier that delivers up to 1500 watts @ 4-ohm
bridge (when connecting two LX-18EV2 in parallel). Other
combinations are possible––consult your authorized dealer or
call B-52 for additional details. See Connection Diagram (right).
3) Use caution when using large amplifiers. All amplifiers are
capable of putting out much more power than they rated for.
The amplifiers rating is specified as undistorted output (low
THD––total harmonic distortion). Amplifiers are capable of
producing much greater power that they are rated for when
driven into clipping.
STEREO CONNECTION
MIXER
L
R
ELECTRONIC CROSSOVER
LOW PASS OUTPUTS
R
L
4) Under powering the LX-18EV2 may also damage the
subwoofer. Using a small amplifier and clipping its high output
signal could damage the subwoofer. Clipping the amplifier may
distort the signal and cause over heating of the voice coil.
L
R
AMPLIFIER
STEREO OUTPUT
USING AN ELECTRONIC CROSSOVER
For optimal performance, it is extremely important that an
electronic crossover be used in the audio system. An electronic
crossover will provide a low-pass output allowing the LX-18EV2 to
only play low frequencies. B-52 recommends setting your
low-pass crossover filter between 80 to 120 Hz, depending upon
the venue and sound desired. In case of doubt, set the low-pass
crossover to 100 Hz.
LX-18EV2
LX-18EV2
It is highly recommended to use an electronic crossover with
24 dB per octave slopes or higher. If your amplifier or electronic
crossover provides a 30 Hz subsonic filter, make sure this filter is
turned ON. The subsonic filter will prevent the subwoofer from
reproducing frequencies below 30 Hz. At high SPL, frequencies
lower than 30 Hz can damage to the subwoofer.
BRIDGED CONNECTION
MIXER
L
R
CONNECTORS:
ELECTRONIC CROSSOVER
The LX-18EV2 includes (2) 1/4” phone
jacks and one Neutrik NL4 Speakon
LOW PASS OUTPUTS
2
1
input terminals. All three terminals are
internally connected in parallel. Each of
the three connections can be used as
an input or as an output.
L or R Out
AMPLIFIER
BRIDGED OUTPUT
(Amp must be stable at 4
ohms in the BRIDGE mode)
1. Neutrik NL4 Terminal
2. 1/4” Phone Jacks
1/4” Phone Jack Wiring
LX-18EV2
LX-18EV2
NEUTRIK CONNECTOR
Pin 1 +............Subwoofer + (input or output)
Pin 1 - ............Subwoofer - (input or output)
Pin 2 +............Subwoofer + (input or output)
Pin 2 - ............Subwoofer - (input or output)
Connecting two LX-18EV2 subwoofers in
parallel results in a 4 ohm load.
There are numerous other configurations available.
Please consult your Authorized B-52 Dealer or
contact B-52’s Customer Service.
Important: When connecting a speaker to an amplifier or when connecting two speakers together, it
is important to match the polarity (+/-). Connect positive-to-positive and negative-to negative.
3
WARRANTY
Thank you for choosing this B-52 Pro-Audio sound
product. B-52 manufactures some of the world’s best
sounding and most reliable professional speaker
systems and components. E.T.I. Sound Systems, Inc.,
manufacturers of B-52, takes great pride in thoroughly
testing each B-52 product prior to shipment. Please read
the warranty terms and conditions below and carefully
read the provided Limited Warranty Card for additional
terms and conditions.
SPECIFICATIONS
Frequency Response:
Nominal Impedance:
Power Handling:
Nominal Dispersion:
SPL (1watt/1meter):
Peak SPL:
30-160 Hz
8 Ohms
1000 Watts
Omni Directional
106 dB
B-52 CABINETS: E.T.I. Sound Systems, Inc. offers a
LIFETIME warranty to the original purchaser that B-52
cabinet’s construction will be free from defects in materi-
al and workmanship. A dated sales receipt will establish
coverage under this warranty. The warranty does not
cover service or parts to repair damage caused by neg-
lect, abuse, normal wear & tear and cosmetic appear-
ance of the cabinetry not directly attributed to defects in
material or workmanship, or service & repair, modifica-
tions to the cabinet which has not be authorized or
approved by E.T.I. Sound Systems, Inc. If this product is
defective in materials or workmanship as warranted
above, your sole remedy shall be repair or replacement
as provided above. See provided Limited Warranty card
for additional terms and conditions.
136 dB
Components:
(1) B-52 18-200L subwoofer. 4” diameter,
dual-aluminum former voice. Cast
aluminum frame. 200-oz magnet
structure.
Connections:
(2) 1/4” Phone Jacks
(1) Neutrik Speakon NL-4 (4-Pin)
Connector
Enclosure:
Features:
3/4”, void-free plywood cabinet finished
with impact-forgiving black carpet.
Metal bar handles, metal corners, rubber
feet, 4” casters & front-panel heat sink.
24” x 36” x 25”
LOUDSPEAKER AND MID-RANGE COMPONENTS:
E.T.I. Sound Systems, Inc. warrants the original purchas-
er that B-52 loudspeakers and/or midrange components
will be free from defects in material and workmanship for
a period of (5) FIVE YEARS from the original purchase
date. A dated sales receipt will establish coverage under
this warranty. This warranty will automatically terminate
(5) years after the original retail sales date. This (5) five-
year warranty does not cover service or parts to repair
damage caused by accident, disaster, misuse, abuse,
burnt voice-coils, over-powering, negligence, inadequate
packing or shipping procedures and service, repair or
modifications of the component which has not been
authorized or approved by E.T.I.. This warranty is in lieu
of all other expressed warranties. If this product is defec-
tive in materials or workmanship as warranted above,
your sole remedy shall be repair or replacement as pro-
vided above.
Dimensions (W x H x D):
Weight:
126 Lbs.
TECHNICAL SUPPORT
For technical support, please call 800-344-4384 from 9:00 AM to 4:00 PM (Pacific
Standard Time). A B-52 representative will be happy to provide you with the
assistance you need.
INCIDENTAL OR CONSEQUENTIAL DAMAGE: In no
event E.T.I. Sound Systems, Inc. be liable for any inci-
dental or consequential damages arising out of the use
or inability to use of any B-52 product, even if, E.T.I.
Sound Systems, Inc. or a B-52 dealer has been advised
of the possibility of such damages, or any other claim by
any other party. Some States do not allow the exclusion
or limitation of consequential damages, so the above lim-
itation and exclusion may not apply to you. This warran-
ty gives you specific legal rights and you may also have
other rights that may vary from State to State. See pro-
vided Limited Warranty card for additional terms and con-
ditions.
E.T.I. Sound Systems is dedicated to product excellence and therefore continuously
attempts to improve each and every model we manufacture. This ongoing process
includes refinements in design, materials and workmanship, which may result in prod-
ucts that differ than those described in our literature. All features, specifications, and
prices are therefore subject to change without notice.
RETURN PROCEDURES: In the unlikely event that a
defect should occur, follow the procedure outlined below.
Defective products must be shipped together with a proof
of purchase, freight prepaid and insured to the
Authorized B-52 Dealer from whom you purchased the
product or directly E.T.I. Sound Systems, Inc. If a product
must be returned directly to E.T.I. Sound Systems, Inc.
for warranty replacement/repair, a Return Authorization
Number (RAN) must be obtained from our Customer
Service Department prior to shipping the product. You
may obtain RAN by calling 800-344-4ETI.
E.T.I. SOUND SYSTEMS, INC.
FOR YOUR PROTECTION: Please complete and mail
the Purchase Information Card within (10) ten days of the
date of purchase so that we may contact you directly in
the event a safety notification is issued in accordance
with the 1972 Consumer Product Safety Act. In addition,
we ask that you complete the brief questionnaire so me
may analyze your answers and in this way, help us eval-
uate our customer needs. See provided Limited Warranty
card for additional terms and conditions.
3383 Gage Avenue, Huntington Park, CA, 90255
Phone: 323-277-4100 Fax: 323-277-4108
National: 1-800-344-4ETI
E-mail: [email protected]
PRINTED IN THE U.S.A.
4
|