Model CD-1A
(CD-RW drive for the VF160)
Installation Manual
<Notes on care of disc>
• If there is a dust, dirt or fingerprints on the
• Do not use a cleaner for analog discs or
antistatic spray, as well as volatile solvents
such as benzine, which may damage the disc
surface.
disc, which may cause error in playback or
recording, wipe the disc with a soft, dry cloth
or alcohol from the center out.
Never wipe from the outside to center.
• Do not expose any disc to direct sunlight, or
leave it in hot, moist or cold places.
• Read the attached manual packed with the
disc before using it.
How to install the CD-1A
<Notes on installing the CD-RW drive>
• The CD-RW drive is made of precision parts.
Do not apply a mechanical shock or use excessive force when installing it.
• Before installing the drive, make sure that the power of the VF-160 is off and the power cord is
disconnected.
• Install the drive correctly according to this manual.
Note that damage to the drive caused by inappropriate installation is not covered by the guarantee.
Place the VF160 upside down on a material such
as a soft cloth, and unscrew the screw that fixes
Turn the VF160 over and insert the CD-1A into
the slot on the front panel.
1
2
the blank panel.
Push the CD-1A firmly, without forcing, so
that the connector of the CD-1A fits into its
companion in the slot.
Be careful not to drop the VF160 or give a
strong shock to the VF160, which may dam-
age the hard-disk drive built into it.
connector
Keep the blank panel for future use in case
you unmount the CD-1A.
Unfasten the screw that fixes the blank panel.
CD-1A
Blank panel
Remove the blank
panel.
Keep the screw mentioned above, which
will be used in step 4 below after install-
ing the CD-RW drive.
3
Use two screws supplied with the CD-1A to fix
the CD-1A to the VF160 from the front panel.
Tighten the screws with a screwdriver.
3
Opening/closing the tray
• To open the tray, press the eject switch lightly.
Pressing the switch will open the tray slightly.
Then pull out the tray gently by hand to fully open
it.
screw position
screw position
Eject switch
Use the screw you removed in step 1 to fix the
blank panel supplied with the CD-1A to the front
panel.
4
Slant the panel slightly when inserting the
panel inside the unit.
The tray slightly opens.
lens
Pull out the tray to fully open it.
Use the screw you re-
moved in step 1 to fix
the blank panel.
<Caution!>
Do not touch the lens when pulling out
the tray, doing so may damage it and may
cause a malfunction.
• To close the tray, push the tray inside by hand until
locked.
Connect the power cord of the VF160 and turn
on the power.
5
Make sure that the VF160 starts up, and the
LED indicator on the front panel of the CD-
1A blinks for a few seconds then turns off.
Wait until the VF160 display changes to the
Normal display from the start-up display,
and then you are ready to operate the CD-
1A.
Push until it is locked.
4
Placing/removing a disc
The following are some notes on placing and/
or removing a disc.
<IMPORTANT!>
When placing a disc on the tray, support the
tray from the bottom by your hand. If you push
the disc to fit into the pivot on the tray without
supporting the tray, the tray/drive may be dam-
aged or broken. Also note that the disc must be
pushed until it clicks so that it is locked into
the pivot securely. Closing the tray without lock-
ing the disc may damage the disc.
<Note for removing a disc from the tray>
When removing a disc from the tray, also sup-
port the tray from the bottom by your hand.
Also be careful not to unlock the disc from the
pivot forcibly, which may damage the tray.
• Place the disc with the label side up.
When placing the disc, support the tray from the
bottom by your hand as shown in the illustration
below, and push the disc gently until it clicks so
that the disc is locked into the pivot.
Push the disc until it clicks so that the disc is locked
into the pivot.
disc
Support the tray from the
bottom by your hand.
<Caution!>
Do not touch the lens when placing a disc
or removing a disc, doing so may dam-
aged may cause a malfunction.
5
Declaration of EC Directive
This equipment is compatible with the EMC Directive (89/336/EEC) - Directive on approximation of
member nation's ordinance concerning the electromagnetic compatibility. This equipment is compatible
only when connected to fostex specified product.
The Affect of Immunity on This Equipment
The affect of the European Specification EN50082-1 (coexistence of electromagnetic waves - common immunity
specification) on this equipment are as shown below.
In the electrical fast transient/burst requirements, surge, conducted disturbances by radio-frequency fields,
power frequency magnetic field, radiate electromagnetic field requirements and static electricity discharging
environment, this could be affected by generation of noise.
FOSTEX DISTRIBUTORS LIST IN EUROPE
* Including non-EU countries.
* underlined: contracted distributors (as of August, 2000)
<AUSTRIA>
<ITALY>
NAME: ATEC Audio-u. Videogeraete VertriebsgesmbH.
ADD: Im Winkel 5, A-2325 Velm, Austria
TEL: (+43) 2234-74004, FAX: (+43) 2234-74074
NAME: General Music S.p.A.
ADD: Via delle Rose, 12 S. Giovanni M. (RN), Italy
TEL: (+39) 0541-959511, FAX: (+39) 0541-957404
<THE NETHERLANDS>
<BELGIUM>
NAME: IEMKE ROOS AUDIO B. V.
ADD: Kuiperbergweg 20, 1101 AG Amsterdam, The
Netherlands
NAME: EML Sound Industries NV
ADD: Bijvennestraat 1A, B3500 Hasselt, Belgium
TEL: (+32) 11-232355, FAX: (+32) 11-232172
TEL: (+31) 20-697-2121, FAX: (+31) 20-697-4201
<DENMARK>
NAME: SC Sound ApS
<NORWAY>
NAME: Siv. Ing. Benum A/S
ADD: P. O. Box 145 Vinderen, 0319 Oslo 3, Norway
TEL: (+47) 22-139900, FAX: (+47) 22-148259
ADD: Malervej 2, DK-2630 Taastrup, Denmark
TEL: (+45) 4399-8877, FAX: (+45) 4399-8077
<FINLAND>
NAME: Noretron Oy Audio
<PORTUGAL>
NAME: Caius - Tecnologias Audio e Musica, Lda.
ADD: Rua de Santa Catarina, 131 4000 Porto, Portugal
TEL: (+351) 2-2086009/2001394,
FAX: (+351) 2-2054760/2087488
ADD: P. O. Box 22, FIN-02631 Espoo, Finland
TEL: (+358) 9-5259330, FAX: (+358) 9-52593352
<FRANCE>
NAME: Musikengro
ADD: ZAC de Folliouses, B. P. 609, 01706 Les Echets,
France
<SPAIN>
NAME: Multitracker, S. A.
ADD: C/Garcilaso No.9, Madrid 28010, Spain
TEL: (+34) 91-4470700, 91-4470898, FAX: (+34) 91-
5930716
TEL: (+33) 472 26 27 00, FAX: (+33) 472 26 27 01
<GERMANY>
NAME: Studio sound & Music GmbH
ADD: Industriestrasse 20, D-35041 Marburg, F. R.
Germany
<SWEDEN>
NAME: Professional Television AB
ADD: Kavallerivagen 24, 172 48 Sundbyberg, Sweden
TEL: (+46) 8-59798000, FAX: (+46) 8-59798001
TEL: (+49) 6421-92510, FAX: (+49) 6421-925119
<GREECE>
NAME: Bon Studio S. A.
<SWITZERLAND>
NAME: Audio Bauer Pro AG
ADD: Bernerstrasse-Nord 182, CH-8064 Zurich,
Switzerland
ADD: 6 Zaimi Street, Exarchia, 106.83 Athens, Greece
TEL: (+30) 1-3809605-8, 3302059, FAX: (+30) 1-
3845755
TEL: (+41) 1-4323230, FAX: (+41) 1-4326558
<ICELAND>
<UK>
NAME: SCV London
ADD: 3A 6-24 Southgate Road, London N1 3JJ,
England, UK
NAME: I. D. elrf. electronic Ltd.
ADD: ARMULA 38 108 REYKJAVIK, ICELAND
TEL: (+354) 588 5010, FAX: (+354) 588 5011
TEL: (+44) 171-923-1892, FAX: (+44) 171-241-3644
6
|