PRE-INSTALLATION
Thank you for purchasing a quality, stainless steel canopy hood.
We have a high standard of quality control and each canopy hood is tested and approved before it
leaves the factory.
Designer Series Island Canopy
IMPORTANT
•
•
•
Always switch the power off prior to installation, servicing or cleaning the canopy hood.
Never use the canopy hood without the filters.
Stainless steel is very easily damaged during installation if abraded or knocked by tools.
Protect the top of the canopy with cardboard or polystyrene during installation.
Please read the entire instructions before installing the canopy hood.
80327 EC120DXV1 (SS NZ/AUS)
80328 EC120DMV1 (IR NZ/AUS)
88388 EC120DXV1 (EU)
•
•
88833 EC120DXV2 (UK)
A power outlet should be within 750mm from the motor assembly and can be either on the
wall, behind the chimney or in the ceiling. An extension lead may be necessary on some
installations.
•
To comply to electrical safety regulations this canopy must be plugged into a socket near the
appliance. The socket must be accessible and enable the end user to isolate the canopy from
the power for the purpose of internal cleaning or maintenance.
Ducting accessories are not supplied. All ducting must comply with local requirements and
building codes.
All electrical work must be done in accordance with local and/or national electrical
codes as applicable. For safety this product must be earthed. If you are unfamiliar with
methods of installing electrical wiring, employ the services of a qualified electrician.
Turn off power at service entrance before installing wiring or servicing this product.
The canopy hood is heavy please ensure adequate care when installing the canopy hood
to prevent personal injury. The canopy hood must be installed onto a solid wall or solid
lbs
stud. Weight of product 43.2 kg.
HEIGHT OF CANOPY HOOD
•
•
The canopy is designed for 2440mm high ceilings.
The chimney is telescopic and is designed for hood installations
between 600 to 750mm above the cooking surface.
Ascertain the desired installation height of the canopy hood.
Any installation above 750mm will compromise the extraction
performance.
Please note product may vary slightly from the picture.
Please read the entire instructions before installing the canopy.
FILTER SURFACE
HOB TOP
•
•
INSTALLATION INSTRUCTIONS
•
The air outlet from the motor requires 150mm round ducting
which requires 170mm diameter hole in the ceiling.
CONTENTS
Contents of packaging
1 x canopy hood
Equipment required
Electric drill
Drill bits
Spirit level
Screwdriver
Jig saw
Ladder
Tape measure
Duct tape
Optional accessories
Light bulb
Chimney ext.(10’) SS
Chimney ext.(10’) IR
Charcoal filter
104467
A=600 min (electric cook top)
A=650 min (gas cook top)
2 x chimney pieces
8 x angle brackets
1 x installation instructions
4 x filters (part number 104660)
Installation kit (part number 104922)
4 x 12 x 40mm screw
30 x 6 x ¼” self tapping screw
(2 spare)
103821
1744
Recirculation kit
CONTROL PANEL
Delay switch: Canopy hood will remain on a
low, mid or high speed for five minutes to clear
away all residual cooking odours before
switching off automatically.
I
I I
I I I
Ducting
Fan On/Off
Mid Speed
High Speed
Delay Switch
Light On/Off
104923 issue A
ECN 06 037
|