®
POWERSHRED HS-660
Please read these instructions before use.
Do not discard: keep for future reference.
Quality Office Products Since 1917
BASIC SET-UP
BASIC SHREDDING OPERATION
PAPER
SHREDDER SET-UP
5
2
4
1
3
3
1
2
4
or
R
R
Press ( ) ON to
activate
Ensure access
to a dedicated
15Amp, 120V
outlet
Feed paper
Open the door
When finished
shredding set to
( ) OFF
Place cutter head
into top of cabinet,
use 2 people
Make sure safety Plug in and make
Do nothing and
shredder will go
automatically to
sleep mode after
1 hour
straight into paper
entry and release
flap is securely
in place
sure door is closed
OILING SET-UP
1
2
3
4
5
6
7
8
R
R
Put oil tube into oil Place oil bottle
Close door. Plug Oil pump starts
Remove oil bottle
holder from
cabinet
Hook oil
Remove lid
from oil bottle
After changing oil
bottle and screw into oil holder on into socket-outlet automatically on
bottle holder
into side of
cabinet
bottle, press Reverse
(R) until Oil Indicator
stopper on
side if cabinet
first use. To stop Oil
Indicator ( ) from
blinking red, press
ON ( ) after 15
seconds
(
) no longer
blinks red
SHEET CAPACITY GAUGE
SLEEP MODE
Eliminates frustrating jams by preventing overloads.
Electronically measures paper thickness to prevent
paper jams:
WHEN IN SLEEP MODE
2
3
1
R
Up to RED: Too many sheets have been
inserted. Automatic reverse of paper.
To get out of sleep or
In sleep mode
insert paper
press ON ( )
Up to YELLOW: Maximum sheet capacity.
Up to GREEN: Normal sheet capacity
during shredding process.
R
TROUBLESHOOTING and PREVENTIVE MAINTENANCE
• Empty wastebasket when bin full indicator lights up.
• Shredder won’t run if the door is open, or bin needs to be emptied.
• Maintenance is an important part of protecting your investment. Don’t forget to purchase our oil (3505801) and shredder bags (3604101).
PAPER JAM
L
C
IMLE
P
A
IE
N
ZAIN
D
G
E LO
A
S
U
S
T
E
O
NS
-
O
S
R
T
E
A
S
R
IN
T
FRINAR
F
R
A
O
R
J
E
O
D
S D
S
E
E
I
N
NI
S
C
O
R
A
S
UTOMÁTICO
Set to Off ( ) and empty bin. Replace bin and follow the below
procedures.
Paper detection sensors are designed for maintenance free operation. However, on
rare occasions the sensors may become blocked by paper dust causing the motor to
run even if there is no paper present (Note: two paper detection sensors are located in the center
of the paper entry).
3
2
1
TO CLEAN THE SENSORS
1
2
3
4
Gently pull uncut
paper from
Shred One Sheet
Stops automatically
if too much paper
is inserted.
Automatic reverse
if paper jams
paper entry.
Machine runs for
a short time in
reverse. Repeat if
necessary
Turn off and
Use thin, long-handled
brush to clean sensors.
Make sure brush is
clean and dry
Locate Auto-start
infared sensor
Clean any
unplug shredder
contamination from
the paper sensors
2
®
POWERSHRED HS-660
WARRANTY
Limited Warranty: Fellowes, Inc. (“Fellowes”) warrants the parts of the machine to outside of the country where the shredder is initially sold. ANY IMPLIED WARRANTY,
be free of defects in material and workmanship and provides service and support for INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS
1 year from the date of purchase by the original consumer. Fellowes warrants the HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH
cutting blades of the machine to be free from defects in material and workmanship ABOVE. In no event shall Fellowes be liable for any consequential or incidental damages
for 1 year from the date of purchase by the original consumer. If any part is found to attributable to this product. This warranty gives you specific legal rights. The duration,
be defective during the warranty period, your sole and exclusive remedy will be repair terms, and conditions of this warranty are valid worldwide, except where different
or replacement, at Fellowes’ option and expense, of the defective part. This warranty limitations, restrictions, or conditions may be required by local law. For more details or
does not apply in cases of abuse, mishandling, or unauthorized repair. The user is to obtain service under this warranty, please contact us or your dealer.
responsible for any additional costs incurred by Fellowes in servicing the paper shredder
Questions or Concerns?
Customer Service & Support
Troubleshooting
Troubleshooting
Registration
Replacement parts
General questions
Manuals
Australia
Canada
Europe
Mexico
+1-800-33-11-77
+1-800-665-4339
00-800-1810-1810
+1-800-234-1185
+1-800-955-0959
United States
©2010 Fellowes, Inc. Part No. 404901
|