EVERFOCUS
Color Dome Camera
Operation Instructions
Model No. ED300E/200E
Please read this manual first for correct installation and operation. This manual should be retained
for future reference. The information in this manual was current when published. The
manufacturer reserves the right to revise and improve its products. All specifications are therefore
subject to change without notice.
PRECAUTIONS
1. Do not have camera immersed in water.
2. Do not disassemble it or place it on an unstable base.
3. Do not touch the surface of CCD sensor by hand directly.
4. Never face the camera toward the sun.
5. Use proper power source otherwise the camera will not function correctly.
6. Use the camera at temperatures within 0℃ ~ 50℃/32℉~122℉ and humidity between 20%~
80%. The input power sources are 12VDC only and 12VDC/24VAC.
MAJOR PARTS NAMES AND FUNCTIONS
c
f
g
d
e
13
○
12
○
h
i
j
11
○
k
10
○
2
1
○ Camera Cover
This cover will protect the camera for avoiding dust and damage.
2
○ Lens
This vari-focal Lens allows users to adjust the Zoom and Focus manually.
Built-in fixed lens: 3.6; 4.3; 6.0 or 8.0 mm
3
○ Base
The camera unit sets in the dome base, when it is shipping from the factory.
4
○ Focus Ring (for vari-focal lens only)
To set the focus, and loosen the Focus ring knob, please turn the ring toward <F> or <N> if
necessary.
5
○ Zoom Ring (for vari-focal lens only)
If you like to adjust the viewing range, please loosen or tighten the Zoom ring. Turn the ring
towards <W> for Zoom out or <T> for Zoom in. When camera setting is finished, please
tighten the zoom ring knob.
6
○ Flickerless
The factory setting is FL OFF.
7
○ Mirror
The factory setting is Mirror OFF.
8
○ Auto Gain control on/off switch
The factory setting is AGC ON.
9
○ D/N
The factory setting is D/N OFF.
10
○ Monitor Test Pin
For monitor use. When setting up the camera, connect a monitor to this video output pin and
to the GROUND pin using alligator clip cables, then use the image displayed on the monitor,
set the surveillance angle.
11
○ Level Volume Control (for vari-focal lens only)
The iris level control for the lens.
3
12
○ Power input
Please connect the connector of camera to 12VDC or 24VAC power source.
13
○ Video Output BNC Connector
Please connect to the BNC connector of Monitor video in.
INSTALLATION
1. Remove the plastic dome cover.
2. Lossen the two screws of the supporting bracket to remove the camera body.
3. Use four screws to fix the camera base on the ceiling.
4. Put the camera body back to the supporting bracket, then tighten the two screws to
fix the camera.
5. Connect the BNC connector of the camera to a color monitor, or other video device
through a 75 ohm type coaxial cable with BNC female connector at cable
extension.
6. Connect the 12VDC or 24VAC power source to the power jack of camera.
NOTE: Please do not scratch or damage the lens while making any kind of setting.
4
LENS ADJUSTMENT (For Vari-Focal Lens only)
Zoom and focus adjustments
After the camera is installed, the zoom and focus
of the lens must to be adjusted.
1. Loosen the zoom ring knob, and turn
the ring towards <W> or <T> if necessary.
W side (Zoom out)
The viewing range will be wider and the target is smaller.
T side (Zoom in)
The viewing range will be smaller and the target is larger.
2. Loosen the focus ring knob, and turn the ring towards <F> or <N> if necessary.
Repeat steps 1 and 2 till the best image had been obtained. When lens setting is completed,
please tighten the zoom ring and focus ring knobs.
5
ADJUSTMENT
FL (Flickerless)
When picture flicker fiercely, turn FL on, then
the camera will stabilize the speed of electronic
shutter at 1/100(S)(NTSC) or 1/120(S)(PAL)
automatically, and reduce the flicker immediately.
The default setting is OFF.
Mirror
Mirror ON: Set a horizontal image inversion.
Mirror OFF: Disable the inversion.
Auto Gain Control Adjustment
AGC ON: The sensitivity increases automatically when the light is low.
AGC OFF: A-low-noise picture is obtained when camera is under a low light condition.
D/N (Day/Night)
D/N ON: When light environment is under 5 Lux, the camera will switch to black and white mode.
However, when light environment is over 10 Lux, the camera will switch to color mode.
Please be informed that any D/N switch will result a delay of 4~5 seconds.
D/N OFF: Camera stays in color mode.
Note: when AGC setting is OFF, then D/N function will be inactive.
Level Volume Control (for vari-focal lens only)
The iris level of lens can be adjusted by the level control. Turn the level control to the right
direction (H) and video images will become brighter. Turn the level control to the left direction (L)
and the video images will become darker.
6
SPECIFICATIONS
Type
ED200E
ED300E
Pickup Device
Video Format
1/3'' SONY Super HAD CCD
NTSC or PAL
NTSC: 525 TV lines, 60 fields/sec
PAL: 625 TV lines, 50 fields/sec.
Scanning System
Picture Elements
NTSC: 510(H) x 492(V);
NTSC: 768(H) x 494(V);
PAL: 752(H) x 582(V)
520 TV Lines
PAL: 500(H) x 582(V)
380 TV Lines
Horizontal Resolution
Sensitivity
0.3 Lux/F=1.2
0.4 Lux/F=1.2
S/N Ratio
Over 48dB (AGC off)
1/50(1/60)~1/100,000
Vari-focal lens,
Electronic Shutter
Vari-focal lens,
Auto Iris
Auto Iris
f=2.6~6mm
*Lens Type
Fixed
Fixed
f=2.6~6mm
f=3.7~12mm,F=1.2
f=9~22mm,F=1.6
Adjustable
f=3.7~12mm,F=1.2
f=9~22mm,F=1.6
Adjustable
Iris Level
Auto
No
Auto
No
Auto Gain Control
Flickerless
ON/OFF Switch
ON/OFF Switch
ON/OFF Switch
ON/OFF Switch
Yes
ON/OFF Switch
ON/OFF Switch
ON/OFF Switch
ON/OFF Switch
No
No
H-Mirror
Auto
Auto
Auto
Auto
Day/Night Mode
Auto White Balance
Gamma Correction
0.45
2 video outputs
BNC 1.0Vp-p, 75ohm
Video Output
Additional testing video output 1.0Vp-p, 75ohm
Internal sync
Sync. Mode
Power Source
2 types: 12VDC only & 12VDC/24VAC
12VDC: 2.5W max
Power Consumption
24VAC: 4.5VA max
Dimensions
108 mm (O.D.) x 80 mm (H) ; 4.3” (O.D.) x 3.2” (H)
0.3kg ; 0.7 lbs
Weight
Operating Temperature
Certifications
0°C~50°C ; 32°F~122°F (20%~80% Humidity)
FCC/CE
*Lens models and availability vary in different regions
7
EverFocus Electronics Corp.
Head Office:
Europe Office:
12F, No.79 Sec. 1 Shin-Tai Wu Road,
Hsi-Chih, Taipei, Taiwan
TEL: +886-2-26982334
FAX: +886-2-26982380
Albert-Einstein-Strasse 1
D-46446 Emmerich, Germany
TEL: 49-2822-9394-0
China Office:
Room B-05D-1, KESHI PLAZA , Shangdi
Information Industry Base,
Haidian District, Beijing China
100085
TEL: +86-10-62973336/37/38/39
FAX: +86-10-62971423
USA L.A. Office:
1801 Highland Ave. Unit A
Duarte, CA 91010, U.S.A.
TEL: +1-626-844-8888
FAX: +1-626-844-8838
USA N.Y. Office:
Japan Office:
415 Oser Avenue Unit S
Hauppauge, NY 11788
TEL: 631-436-5070
FAX: 631-436-5027
1809 WBG MARIBU East 18F,
2-6 Nakase.Mihama-ku.
Chiba city 261-7118, Japan
TEL: +81-43-212-8188
FAX: +81-43-297-0081
Your EverFocus product is designed and
manufactured with high quality materials and
components which can be recycled and
reused.
Ihr EverFocus Produkt wurde entwickelt und
hergestellt mit qualitativ hochwertigen
Materialien und Komponenten, die recycelt
und wieder verwendet werden können.
Dieses Symbol bedeutet, dass elektrische und
elektronische Geräte am Ende ihrer
Nutzungsdauer vom Hausmüll getrennt
entsorgt werden sollen.
This symbol means that electrical and
electronic equipment, at their end-of-life,
should be disposed of separately from your
household waste.
Please, dispose of this equipment at your
local community waste collection/recycling
centre.
Bitte entsorgen Sie dieses Gerät bei Ihrer
örtlichen kommunalen Sammelstelle oder im
Recycling Centre.
Helfen Sie uns bitte, die Umwelt zu erhalten, in
der wir leben!
In the European Union there are separate
collection systems for used electrical and
electronic product.
Please, help us to conserve the environment
we live in!
P/N: MED2G02000
8
|