Owner's Manual
®
STOP
DETHATCHER FOR SWEEPERS
DO NOT RETURN TO STORE
For Missing Parts or Assembly
Questions Call 1-866-576-8388
Model No. 486.24219
CAUTION:
• Safety
Before using this product, read
this manual and follow all Safety
Rules and
• Assembly
• Operation
• Maintenance
• Parts
Operating Instructions.
Sears, Roebuck and Co., Hoffman Estates, IL 60ꢀ79 U.S.A.
FORM NO. 48830 (REV. 6/06)
PRINTED IN U.S.A.
ꢀ
HARDWARE PACKAGE CONTENTS
SHOWN FULL SIZE
E
A
B
C
F
D
I
J
G
K
H
L
M
NOT SHOWN FULL SIZE
P
Q
N
O
REF. QTY.
DESCRIPTION
REF. QTY.
DESCRIPTION
Hex Nut, ꢀ/4"
Hex Nut, 5/ꢀ6"
Jam Nut, Plain ꢀ/ꢁ"
Jam Nut, Nylock ꢀ/ꢁ"
Vinyl Cap
Conduit Clamp
Keeper Bracket
Nylon Tie
J
K
L
4
7
ꢀ
ꢀ
ꢁ
ꢁ
ꢁ
ꢀ
A
B
C
D
E
F
G
H
I
ꢀ
7
ꢁ
ꢁ
ꢀ
ꢁ
ꢁ
ꢀ4
ꢁ
Hex Bolt, ꢀ/ꢁ" x 3-ꢀ/ꢁ"
Hex Bolt, 5/ꢀ6" x ꢀ-ꢀ/ꢁ"
Clevis Pin, 5/ꢀ6" x ꢀ-3/8"
U-Bolt
Transport Hook
Washer, 5/ꢀ6"
Washer, ꢀ/ꢁ"
Washer, 3/8"
Hair Cotter Pin, 3/3ꢁ"
M
N
O
P
Q
3
ASSEMBLY
CARTON CONTENTS
NOTE: On sweepers smaller than 42", use only five spring
tines.
ꢀ. Spring Tines (7)
ꢁ. Frame Assembly
3. Gauge Wheel
•
Assemble a vinyl cap onto each end of the frame tube.
See figure 1.
5/16" x 1-1/2"
HEX BOLT
VINYL CAP
3/8" WASHER
1
2
5/16" NYLOCK NUT
VINYL CAP
3
FIGURE 1
•
•
Assemble a ꢀ/ꢁ" washer, the wheel, another ꢀ/ꢁ"
washer and the ꢀ/ꢁ" plain jam nut onto the
1/2" x 3-1/2" hex bolt. See figure 2.
Insert the bolt through the welded bracket and
assemble the ꢀ/ꢁ" nylock jam nut onto the bolt. Adjust
the nuts so that there is no end play in the wheel and
then tighten the nuts securely against the welded
bracket. Make sure the wheel still turns freely. See
figure 2.
TOOLS REQUIRED FOR ASSEMBLY
(ꢀ)
(ꢁ)
(ꢁ)
(ꢀ)
7/ꢀ6" Wrench
ꢀ/ꢁ" Wrenches
3/4" or Adjustable Wrenches
Knife
Use this hole for
42" & 46" sweepers
Use this hole for
smaller sweepers
REMOVAL OF PARTS FROM CARTON
•
Remove all parts and hardware packages from the
carton. Lay out all parts and hardware and identify
using the illustrations on pages 3 and 4.
1/2" NYLOCK
JAM NUT
1/2" JAM NUT
1/2" WASHER
•
•
Turn the frame assembly as shown in figure 1.
Assemble seven spring tines to the top of the frame
tube. Use a 5/16" x 1-1/2" hex bolt, two 3/8" flat
washers and a 5/ꢀ6" nylock nut for each spring tine.
Place one 3/8" flat washer on top of the frame tube
and the second 3/8" flat washer on top of the spring
tine. See figure 1.
1/2" WASHER
1/2" x 3-1/2"
HEX BOLT
FIGURE 2
4
•
•
Assemble a conduit clamp onto each end of the
sweeper height adjustment tube so that the straight
part of the clamp is on top of the tube. See figure 3.
Remove the hitch brackets and the bolts, if present,
from the ends of the sweeper's hitch tubes. Slide the
transport hook onto the L.H. hitch tube as shown in
figure 3.
If you have a 30" sweeper, skip these steps.
•
Make sure the sweeper height adjustment handle is
still set to about the middle of it's adjustment range.
Center the dethatcher with the sweeper.
•
•
Assemble the keeper brackets (bend to the inside)
to the sweeper's hitch tube, outside of the conduit
clamps. Use a u-bolt and two ꢀ/4" nylock nuts per
bracket. Position the keeper brackets against the sides
of the conduit clamps, approximately perpendicular
to the ground. Tighten the nuts without bending the
keeper brackets. See figure 5.
•
Reassemble the hitch brackets and bolts to the hitch
tubes. Refer to your sweeper owner's manual.
KEEPER BRACKET
U-BOLT
TRANSPORT
HOOK
CONDUIT
CLAMP
FIGURE 3
•
Connect the sweeper to the tractor. Set the sweeper
height adjustment handle to about the middle of it's
adjustment range.
Place the dethatcher in front of the sweeper housing,
underneath the hitch tubes.
Connect the dethatcher to the conduit clamps using
two 5/ꢀ6" x ꢀ-3/8" clevis pins, 5/ꢀ6" washers and
3/32" hair cotter pins. See figure 4.
1/4" NYLOCK NUT
FIGURE 5
•
•
•
•
Lift the front of the dethatcher and secure it in
transport position using the transport hook. See figure
6.
To keep the transport hook from sliding back along
the hitch tube, you can fasten the supplied nylon tie
around the hitch tube behind the transport hook. See
figure 6.
HEIGHT ADJUSTMENT
MIDDLE SETTING
5/16" x 1-3/8"
CLEVIS PIN
NYLON TIE
5/16" WASHER
TRANSPORT HOOK
3/32" HAIR
COTTER PIN
FIGURE 4
FIGURE 6
5
OPERATION
USING THE DETHATCHER
HOW TO USE YOUR DETHATCHER
Regular removal of thatch is critical to the maintenance
of a healthy lawn. Thatch is layer of stems, clippings,
runners, roots and leaves that have not decayed.
Excessive thatch prevents air, water and fertilizer from
reaching the roots. The dethatcher will effectively dislodge
RAISING/LOWERING THE DETHATCHER
•
To raise the dethatcher for transport, lift up on the
front of the dethatcher and secure it with the transport
hook. Lower the dethatcher by releasing the transport
hook.
excessive thatch from your lawn.
•
Start with the tractor in low gear. Vary the forward
speed to determine the best speed for maximum
dethatcher performance.
SETTING THE OPERATING POSITION
•
The operating height of the dethatcher is controlled
by the gauge wheel at the front of the dethatcher
and is not adjustable. The correct wheel position
was determined in figure 2 when you assembled the
wheel.
•
•
Use a crisscross pattern to achieve the most even
removal of thatch.
On slopes, always operate in an up and down
direction only.
•
Set the sweeper to the desired operating height. (The
best height is usually with the brushes set about ꢀ/ꢁ"
down into the grass.) Refer to your sweeper owner's
manual for sweeper.
•
•
Avoid extremely sharp turns.
Avoid towing the dethatcher across sudden steep
dips in the ground while dethatching. Loss of ground
contact with the gauge wheel could cause the
dethatcher to be pulled back underneath the sweeper.
MAINTENANCE / STORAGE
CUSTOMER RESPONSIBILITIES
•
Read and follow the maintenance schedule and the maintenance procedures listed in this section.
MAINTENANCE SCHEDULE
Fill in dates as you
complete regular service.
Service Dates
Check for loose fasteners
Check for worn or damaged parts
Cleaning
X
X
X
X
X
•
•
Before each use, check all nuts and bolts for
tightness.
•
•
If rust appears on the spring tines, sand lightly and
coat with enamel paint.
Clean after each use to help prevent rust.
Always store in a dry area, and coat exposed metal
with light oil when not in use.
6
PARTS
REPAIR PARTS FOR MODEL 486.24219 DETHATCHER
4
6
19
2
16
6
15
9
20
1
8
5
7
17
9
14
13
15
12
19
3
12
18
10
11
20
REF.
NO.
PART
NO.
QTY.
DESCRIPTION
REF.
NO.
PART
NO.
QTY.
DESCRIPTION
ꢀꢁ Rꢀ9ꢀ7ꢀ6ꢀ6
ꢁ
ꢀ
ꢀ
ꢁ
4
ꢀ
ꢁ
ꢁ
ꢁ
ꢀ
Washer, ꢀ/ꢁ"
ꢀ
ꢁ
3
4
5
6
7
8
9
64650
4676ꢀ
48098
43085
4308ꢀ
43070
43083
488ꢀꢁ
474ꢀ3
43055
440ꢁ5
ꢀ
7
ꢀ
7
ꢁ
ꢀ4
7
ꢁ
ꢁ
ꢁ
Spring Mount Frame Assem.
Spring Tine
Gauge Wheel
Hex Bolt, 5/ꢀ6-ꢀ8 x ꢀ-ꢀ/ꢁ"
Washer, 5/ꢀ6"
Washer, 3/8"
Nylock Nut, 5/ꢀ6-ꢀ8
Clevis Pin, 5/ꢀ6" x ꢀ-3/8"
Clamp
Hair Cotter Pin, 3/3ꢁ"
Hex Bolt, ꢀ/ꢁ-ꢀ3 x 3-ꢀ/ꢁ"
ꢀ3
ꢀ4
ꢀ5
ꢀ6
ꢀ7
ꢀ8
ꢀ9
ꢁ0
430ꢀ9
48ꢀꢀ5
488ꢀ3
43ꢀ78
7ꢁ6-0ꢀ78
488ꢀꢀ
ꢁ5054
4448ꢀ
48830
Jam Nut, Plain ꢀ/ꢁ-ꢀ3
Jam Nut, Nylock ꢀ/ꢁ-ꢀ3
U-Bolt, ꢀ/4-ꢁ0
Nylock Nut, ꢀ/4-ꢁ0
Nylon Tie
Hook, Transport
Bracket, U-Bolt Clamp
Vinyl Cap
Owner's Manual
ꢀ0
ꢀꢀ
ꢀ
Get it fixed, at your home or ours!
Your Home
For repair–in your home–of all major brand appliances,
lawn and garden equipment, or heating and cooling systems,
no matter who made it, no matter who sold it!
For the replacement parts, accessories and
owner’s manuals that you need to do-it-yourself.
For Sears professional installation of home appliances
and items like garage door openers and water heaters.
1-800-4-MY-HOME® (1-800-469-4663)
Call anytime, day or night (U.S.A. and Canada)
Our Home
For repair of carry-in items like vacuums, lawn equipment,
and electronics, call or go on-line for the location of your nearest
Sears Parts & Repair Center.
1-800-488-1222
Call anytime, day or night (U.S.A. only)
To purchase a protection agreement (U.S.A.)
or maintenance agreement (Canada) on a product serviced by Sears:
1-800-827-6655 (U.S.A.)
1-800-361-6665 (Canada)
Para pedir servicio de reparación
Au Canada pour service en français:
a domicilio, y para ordenar piezas:
1-800-LE-FOYERMC
1-888-SU-HOGAR®
(1-800-533-6937)
(1-888-784-6427)
® Registered Trademark / TM Trademark / SM Service Mark of Sears Brands, LLC
® Marca Registrada / TM Marca de Fábrica / SM Marca de Servicio de Sears Brands, LLC
MC Marque de commerce / MD Marque déposée de Sears Brands, LLC
© Sears Brands, LLC
8
|