Chauvet Automobile Electronics LR 1510 User Manual
LR-1510  
Scorpion™ R  
USER MANUAL  
CHAUVET, 3000 N 29th Ct, Hollywood, FL 33020 U.S.A  
(800) 762-1084 – (954) 929-1115  
FAX (954) 929-5560  
www.chauvetlighting.com  
 
BEFORE YOU BEGIN  
What is included  
¾
¾
1 x Scorpion™ R  
Warranty Card  
¾
¾
User Manual  
Power Adapter  
Unpacking Instructions  
Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that  
all parts are present, and have been received in good condition. Notify the shipper immediately and  
retain packing material for inspection if any parts appear damaged from shipping or the carton itself  
shows signs of mishandling. Save the carton and all packing materials. In the event that a fixture  
must be returned to the factory, it is important that the fixture be returned in the original factory box  
and packing.  
AC Power  
To determine the power requirements for a particular fixture, see the label affixed to the back plate of  
the fixture or refer to the fixture’s specifications chart. A fixture’s listed current rating is its average  
current draw under normal conditions. All fixtures must be powered directly off a switched circuit and  
cannot be run off a rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer  
channel is used solely for a 0% to 100% switch. Before applying power to a  
Figure 1 - AC Voltage Switch  
fixture, check that the source voltage matches the fixture’s requirement.  
Check the fixture or device carefully to make sure that if a voltage selection  
switch exists that it is set to the correct line voltage you will use.  
Warning!  
Verify that the power select switch on your unit matches the  
line voltage applied. All fixtures must be connected to circuits  
with a suitable Earth Ground.  
Not all fixtures have a voltage  
select switch. Please be sure to  
connect to the proper voltage.  
LR-1510 User Manual  
3
11/14/2007/18:54  
 
 
Introduction  
Safety Instructions  
Please read these instructions carefully, which  
includes important information about the installation,  
usage and maintenance?  
•
•
Please keep this User Guide for future consultation. If you sell the unit to another user, be sure that  
they also receive this instruction booklet.  
Always make sure that you are connecting to the proper voltage and that the line voltage you are  
connecting to is not higher than that stated on decal or rear panel of the fixture.  
•
•
This product is intended for indoor use only!  
To prevent risk of fire or shock, do not expose fixture to rain or moisture. Make sure there are no  
flammable materials close to the unit while operating.  
•
•
•
The unit must be installed in a location with adequate ventilation, at least 50cm from adjacent  
surfaces. Be sure that no ventilation slots are blocked.  
Always disconnect from power source before servicing or replacing lamp or fuse and be sure to  
replace with same lamp source.  
Secure fixture to fastening device using a safety chain. Never carry the fixture solely by its head. Use  
its carrying handles.  
•
•
Maximum ambient temperature is Ta: 40°. Do not operate fixture at temperatures higher than this.  
In the event of serious operating problem, stop using the unit immediately. Never try to repair the unit  
by yourself. Repairs carried out by unskilled people can lead to damage or malfunction. Please  
contact the nearest authorized technical assistance center. Always use the same type spare parts.  
•
•
•
•
Don’t connect the device to a dimmer pack.  
Make sure power cord is never crimped or damaged.  
Never disconnect power cord by pulling or tugging on the cord.  
Avoid direct eye exposure to lamp while it is on.  
Caution!  
There are no user serviceable parts inside the unit. Do not open the housing or  
attempt any repairs yourself. In the unlikely event your unit may require service,  
please contact CHAUVET.  
LR-1510 User Manual  
4
11/14/2007/18:54  
 
 
INTRODUCTION  
Thank you for purchasing this laser product. You can be assured that you have made an investment  
into the highest quality laser products available today. This product has been designed by the  
development team at CHAUVET.  
You can be confident that our quality and after sales service is equal to our status of being the global  
leader in entertainment lighting and laser products.  
Features  
•
Red laser  
•
•
•
•
16 preset patterns  
Sound activated mode  
Auto and Manual modes  
User selectable patterns and speed of rotation in manual mode  
Product Overview  
AC Power Connection:  
The unit is supplied with a power pack appropriate to its voltage and destination. It is imperative that  
the correct power pack suitable for this unit be used at all times. If any other type of supply is provide  
to this unit then it is likely to render the unit non-operational.  
General Instructions  
This lighting effect has been designed to function on a 9V DC power and has been supplied with a  
suitable AC power pack for use with your local voltage. Check the label on the unit and the power  
plug for the correct voltage. When connected to the mains power supply via the power pack and  
switched on the unit should illuminate and shoot a <4.95mW single laser. Warning: Do not aim  
towards eye.  
This unit provides three modes of operation accessible via the functions switch (Fig 1). The three  
modes are as follows: Sound Activation, Auto Mode and Manual. In the sound and automatic modes,  
the laser will change through sixteen preset patterns. In manual mode, the user can select the pattern  
and speed of rotation.  
LR-1510 User Manual  
5
11/14/2007/18:54  
 
 
COMPLIANCE STATEMENT  
Your LR-1510 has been designed to comply with FDA and IEC Standards for its classification. A  
special optic design regulates the output of the projector so that when properly used the output  
remains at levels government agencies have determined to be appropriate for the products function.  
Laser Safety and Compliance Information  
This product is manufactured to comply with the IEC 60825-1 and in accordance with U.S. Food and  
Drug Administrations (FDA) Standards listed under FDA Document 21 CFR 1040 and subsequent  
laser notices.  
Product Classification and Manufacturing Label Identification  
Laser Classification Class IIIa  
Laser Medium  
LB05R Semiconductor Diode 650nm  
Cooling  
Fan Cooled  
Output  
4.95mW  
Beam Divergence  
Optically adjusted for compliance  
There is only one  
laser aperture on  
this product.  
Non-Interlocked Housing Warning Labels. This unit  
CAUTION: AVOID EXPOSURE  
contains an embedded laser device that exceeds the output  
of the intended class internally. Exposure to unsafe levels  
of laser radiation when opened.  
TO BEAM: Avoid direct eye  
contact with laser light. Never  
intentionally expose your eyes or  
others to direct laser radiation.  
Additionally there are no user serviceable parts inside. Tampering or  
removing warranty seals will void your products limited warranty.  
LR-1510 User Manual  
6
11/14/2007/18:54  
 
 
Proper Usage  
This unit has been designed to be hung. It is recommended that, for safety  
purposes, your lighting effect are properly mounted using a suitable  
hanging clamp and safety cable. CHAUVET offers a range of items, which  
are ideal for safe mounting.  
It is the responsibility of the manufacturer to provide useful instruction on  
the proper use of this product.  
According to FDA Regulations you should operate the product in the  
fashion illustrated below.  
CAUTION: Use of controls, adjustments, or performance of  
procedures other than what is specified herein may result in  
hazardous radiation exposure  
APPENDIX  
General Maintenance  
To maintain optimum performance and minimize wear fixtures should be cleaned frequently. Usage  
and environment are contributing factors in determining frequency. As a general rule, fixtures should  
be cleaned at least twice a month. Dust build up reduces light output performance and can cause  
overheating. This can lead to reduced lamp life and increased mechanical wear. Be sure to power off  
fixture before conducting maintenance.  
Unplug fixture from power. Use a vacuum or air compressor and a soft brush to remove dust  
collected on external vents and internal components. Clean all glass when the fixture is cold with a  
mild solution of glass cleaner or Isopropyl Alcohol and a soft lint free cotton cloth or lens tissue. Apply  
solution to the cloth or tissue and drag dirt and grime to the outside of the lens. Gently polish optical  
surfaces until they are free of haze and lint.  
The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to  
optimize light output. Cleaning frequency depends on the environment in which the fixture operates:  
damp, smoky or particularly dirty surrounding can cause greater accumulation of dirt on the unit’s  
optics. Clean with soft cloth using normal glass cleaning fluid. - Always dry the parts carefully. - Clean  
the external optics at least every 20 days. Clean the internal optics at least every 30/60 days.  
LR-1510 User Manual  
7
11/14/2007/18:54  
 
 
Appendix  
Returns Procedure  
Returned merchandise must be sent prepaid and in the original packing, call tags will not be issued.  
Package must be clearly labeled with a Return Merchandise Authorization Number (RA #). Products  
returned without an RA # will be refused. Call CHAUVET and request RA # prior to shipping the  
fixture. Be prepared to provide the model number, serial number and a brief description of the cause  
for the return. Be sure to properly pack fixture, any shipping damage resulting from inadequate  
packaging is the customer’s responsibility. CHAUVET reserves the right to use its own discretion to  
repair or replace product(s). As a suggestion, proper UPS packing or double-boxing is always a safe  
method to use.  
Claims  
Damage incurred in shipping is the responsibility of the shipper; therefore the damage must be  
reported to the carrier upon receipt of merchandise. It is the customer's responsibility to notify and  
submit claims with the shipper in the event that a fixture is damaged due to shipping. Any other claim  
for items such as missing component/part, damage not related to shipping, and concealed damage,  
must be made within seven (7) days of receiving merchandise.  
Technical Specifications  
WEIGHT & DIMENSIONS  
Length........................................................................................................................... 143 mm (5.63 in)  
Width .............................................................................................................................. 188 mm (7.4 in)  
Height ........................................................................................................................... 131 mm (5.16 in)  
Weight ........................................................................................................................... 0.4 Kg (0.88 lbs)  
POWER  
Power adapter ...................................................................................................................DC 9V 800mA  
LASER  
Diode (LR-1510)............................................................................................... 1 x 4.8 ~ 5 mW red laser  
Wavelength...................................................................................................................................650 nm  
Part No ..................................................................................................................................4.9mW Red  
THERMAL  
Maximum ambient temperature.......................................................................................... 40°C (104° F)  
ORDERING INFORMATION  
Scorpion R..................................................................................................................................LR-1510  
LR-1510 User Manual  
8
11/14/2007/18:54  
 
 

Black Box Flat Panel Television LE003A UTP User Manual
Black Decker Microwave Oven MY30PGCS User Manual
Bradford White Corp Water Heater 238 42498 00J REV 10 06 User Manual
Briggs Stratton Automobile Parts MS 6445 01 03 User Manual
Briggs Stratton Welder 400700 User Manual
Brother All in One Printer DCP L2500D User Manual
Campbell Hausfeld Printer SM4M User Manual
Canon Security Camera 1867B001 User Manual
Chauvet Projector DMX5F User Manual
Cisco Systems Home Security System IPS4510K9 User Manual