PERFORMANCE MULTI-ROOM VIDEO
Warranty
7300 Series Camera
Multiplex Technology, Inc. warrants this product to be
free from defects in materials and workmanship for a
period of one year from the date of purchase or MTI will
repair, or at its option, replace the defective
product. To obtain warranty service, call MTI for a return
material authorization (RMA) number and return the
product prepaid to Multiplex Technology, Inc.,
3001 Enterprise Street, Brea, CA 92821, Attention:
Customer Service. Please put the RMA number on the
outside of the carton.
Any implied warranty arising from the sale of the
product including implied warranties of merchantability
and fitness for purpose are limited to the warranty
stated above. MTI shall not be responsible for losses or
damages or expenses, whether direct, consequential or
incidental arising from the use of or the inability to use
this product. Some states do not allow limitations on
how long the implied warranty lasts or the exclusions or
limitations or incidental or consequential damages, so
the above limitations and exclusions may not apply to
you. This warranty gives you specific legal rights, and
you may have other rights which may vary from state to
state.
Model 7311 B&W
Model 7320 Color
Model 7300 Universal Mounting System
714-996-4100 * 800-999-5225 * FAX 714-996-4900 * www.channelplus.com
600-104 REV B
© 1997 Multiplex Technology, Inc., Brea, CA 92821-6213
Assembling the Camera
Cover plate
vinyl gasket
camera mount
6-32 nuts
Locating the Camera
The camera ‘looks’ straight out from the cover plate. For a front door
application, place the camera lens 66 inches off the ground, adjacent to
the door.
1
Adding the DoorTel Front Door Intercom.
Start nuts on studs only.
Do not tighten nuts.
R
VIDEO DISTRIBUTION SYSTEM
Slide camera thru hole, as shown.
2
DUAL VIDEO MODULATOR
/
BROADBAND AMPLIFIER IR REPEATING SYSTEM
/
Dimple on mount should fall
into hole on locking clamp.
From telephone company
Align Camera Lens
to Center Hole
A ChannelPlus DoorTel system (model 9400) is an ideal addition
to this system. In this house, when the doorbell rings, the homeowner
changes the TV to the front door channel and picks up any phone in the
house. The homeowner can talk with and see the guest at the front door.
Locking Clamp
(Install Farside)
3
Slide locking clamp between
bracket and camera, as shown.
Locking Clamp
(Install Farside)
SIDE VIEW
6
3
Connecting the Camera
Assembling the Camera (cont.)
4
5
Power cable AWG 26 or larger
B) TIGHTEN BOTH NUTS TO SECURE ASSEMBLY.
A) ALIGN CAMERA LENS TO HOLE IN OUTSIDE COVER.
Monitor
BLOW-UP
CONNECT CAMERA WIRING
TO TERMINAL BLOCK AS SHOWN.
RG-59 or RG-6 coax
A long cable run (150ft or more) can noticeably
reduce the picture brightness and increases the
possibility of ground loop hum.
Video
Video Ground
+Vdc
Ground
Viewing the Camera From All TVs in a House
On a typical Camera:
Video is Yellow
+Vdc is Red
All other colors are ground.
ATTACH PC BOARD TO BRACKET
WITH 2 SCREWS, AS SHOWN.
Antenna
or cable
6
7
R
VIDEO DISTRIBUTION SYSTEM
DUAL VIDEO MODULATOR
/
BROADBAND AMPLIFIER IR REPEATING SYSTEM
/
Using an All in One Video Distribution System such as a
ADD GASKET
ChannelPlus model 3015, you may view the camera on an
unused UHF or cable channel. (For example, the front door camera
could be UHF channel 50. All antenna channels will appear normally.)
5
4
|