™
/
Model 953CB 3-Button Security✚® Remote Control
OWNER’S MANUAL
For use with Security✚® garage door openers and light
WARNING
controls that have an orange “learn” button. The code
between the remote control and the receiver changes with
each use, randomly accessing over a billion new codes.
To prevent possible SERIOUS INJURY or DEATH from a moving
gate or garage door:
The additional push buttons can also activate other garage
door openers and/or light controls. (Instructions for
programming light products are included with those
accessories.)
• ALWAYS keep remote controls out of reach of children. NEVER
permit children to operate, or play with remote control
transmitters.
• Activate gate or door ONLY when it can be seen clearly, is properly
adjusted, and there are no obstructions to door travel.
Instructions Are Described and Illustrated Below
• ALWAYS keep gate or garage door in sight until completely closed.
NEVER permit anyone to cross path of moving gate or door.
9
1
9
1
To Control the Opener Lights
7
3
7
3
5
5
KG
KG
In addition to operating the door, you may program the remote
to operate the lights.
1. With the door closed, press and hold the remote button that
you want to control the light.
2. Press and hold the Light button on the door control.
3. Press and hold the Lock button on the door control.
4. After the opener lights flash, release all buttons.
Test by pressing the remote push button. The opener lights
should turn on or off but the door should not move.
1. Press and release the “learn” button on
the motor unit. The learn indicator light
will glow steadily for 30 seconds.
The Remote Control Batteries
2. Within 30 seconds, press and hold the
button on the hand-held remote.
WARNING
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
3. Release the button when the motor unit
light blinks. It has learned the code. If
light bulbs are not installed, two clicks will
be heard.
• If battery is swallowed, immediately notify doctor.
The lithium batteries should produce
power for up to 5 years. To replace,
pry open case with visor clip or
screwdriver, as shown. Insert
batteries positive side up (+).
Battery
To Erase All Codes From Motor Unit Memory
positive
side up (+)
To deactivate any unwanted remote, first erase all codes:
Press and hold the “learn” button on motor
unit until the learn indicator light goes out
(approximately 6 seconds). All previous
codes are now erased. Reprogram each
remote or keyless entry you wish to use.
Dispose of old batteries properly.
NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of
this receiver and/or transmitter are prohibited, except for changing the code setting or replacing
the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
Replacement Parts
3V2032 Lithium battery . . . . . . . . . . . . . . . . . . . . . . . . .10A20
Visor clip . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .29B137
Owner’s manual . . . . . . . . . . . . . . . . . . . . . . . . . . .114A2107
Owner’s manual - Spanish . . . . . . . . . . . . . . . . .114A2107SP
FOR SERVICE DIAL OUR TOLL FREE NUMBER:
1-800-528-9131
© 2006, Chamberlain Group Inc.
All Rights Reserved
114A2107E
|