MA1110-EA
Operation Guide 5267
• Your watch may differ somewhat from the one shown in the illustration.
Hour hand
Minute hand
To set the time
1. Pull the crown out to the
second click when the second
hand is at 12 o’clock position
and the second hand stops.
2. Set the hands by rotating the
crown. Rotate the crown to
move the hands clockwise.
Move the minute hand four or
five minutes past the time you
want to set, and then back it
up to the proper setting.
First click
(Setting Day)
ꢀꢁ
Second click
(Setting Time)
• Carefully set the time,
making sure to distinguish
between AM and PM.
3. Push the crown back in to the
normal position.
Crown
(Normal position)
Day
Second hand
To set the day
1. Pull the crown out to the first click.
2. Set the day by rotating the crown.
3. Push the crown back in to the normal position.
• Avoid changing the date setting while the current time is between 9:00 p.m. and
3:00 a.m.
Using the Stopwatch
Stopwatch minute hand
Stopwatch hour hand
ꢀꢁ
Stopwatch 1/5-second hand
The stopwatch lets you measure elapsed time up to 11 hours, 59 minutes, 59.80
seconds.
To measure elapsed times with the stopwatch
3TOP
2EꢀSTART
3TOP
#LEAR
3TART
■ For a watch with an elapsed time bezel
Rotate the elapsed time bezel to align the
minute hand.
mark with the
After certain amount of time elapsed, read the graduation on
the elapsed time bezel which the minute hand points to.
The elapsed time is indicated.
Elapsed time bezel
• Some water resistant models are equipped with a screw
lock crown.
• With such models, you must unscrew the crown in the
direction noted in the illustration to loosen it before you can
pull it out. Do not pull too forcibly on such crowns.
• Also note that such watches are not water resistant while
their crowns are loosened. Be sure to screw the crowns
back in as far as they will go after making any setting.
Specifications
Accuracy at normal temperature: 20 seconds a month
Display: 3 analog hands (timekeeping hour and minutes, stopwatch 1/5-second),
3 dials (timekeeping seconds, stopwatch hours and minutes), Day indicator
Stopwatch function: Measuring capacity: 11:59'59.80"
Measuring unit: 1/5-second
Measuring mode: Elapsed time
Battery: One silver oxide battery (Type: SR936SW)
Approximately 3 years on type SR936SW (assuming one stopwatch operation 60 min./
day)
1
|