MA0606-EA
Operation Guide 4755
Hour hand
Minute hand
• To set the time
1. Pull the crown out when the
second hand is at 12 o’clock
position and the second hand
Setting time
stops.
2. Set the hands by rotating the
crown. Rotate the crown to
move the hands. Move the
minute hand four or five minutes
past the time you want to set,
and then back it up to the
proper setting.
Crown
(Normal position)
Second hand
3. Push the crown back in to the
normal position.
Using the Stopwatch
Stopwatch minute hand
Stopwatch hour hand
Stopwatch second hand
The stopwatch lets you measure elapsed time up to 11 hours, 59 minutes, 59 seconds.
To measure times with the stopwatch
Elapsed Time
Stop
Re-start
Stop
Clear
Start
To adjust the positions of the stopwatch second hand
1. Press B to reset the stopwatch, and check the alignment of the stopwatch minute
hand and second hand.
2. Pull out the crown.
3. Press A to move the stopwatch second hand forward until it points to the 12
o’clock position.
4. Push the crown back in to its normal position.
I For a watch with an elapsed time bezel
Rotate the elapsed time bezel to align the
minute hand.
mark with the
10
0
5
2 0
After certain amount of time elapsed, read the graduation on
the elapsed time bezel which the minute hand points to.
The elapsed time is indicated.
4 0
3 0
Elapsed time bezel
• Some water resistant models are equipped with a screw lock
crown.
• With such models, you must unscrew the crown in the
direction noted in the illustration to loosen it before you can
pull it out. Do not pull too forcibly on such crowns.
• Also note that such watches are not water resistant while
their crowns are loosened. Be sure to screw the crowns
back in as far as they will go after making any setting.
1
|