Setup Like a Pro
FP2095 — Oilless Compressor
Use a wrench to
tighten threads when
connecting hose,
Compressor
When using the Nailer / Stapler,
Place 4 to 5 drops of nailer
oil in air inlet. Tip nailer back
to reduce spillage.
Pressure Regulator Knob
Regulator Outlet
Close pressure regulator,
Attach air hose
to regulator outlet.
Adjust regulator
knob so outlet
pressure is between
60 psi and 100 psi.
Use 90 psi to
coupler, and plug.
Inflation Nozzle
1
2
3
Turn on compressor and
Allow tank to reach
maximum pressure.
Male Plug
Adapter
Inflation Nozzle
Inflation Needle
100 psi for
nailing or
stapling.
Male Plug
Tire Chuck
Female Coupler
ON / OFF Switch
2 0 © 0 9 C a m p b e l l H a u s f e l d / S c o t t F e t z e r
V 7 / 0 9
I N 6 2 9 4 0 1 A
OIL: For
use with
Brad Nailer/
Stapler.
Recoil Air Hose
.
L i k e o j e a c t s P t r h o e i r p r
Pull back collar on
t o o l s t o o u r c u s t o m e r t h a t h e l p t h e m t o c o m p l e t e
IMPORTANT: Drain tank after each use. After tank is drained,
4
o v i d i n g
e d e e d a i c r a t e d t o o d p u r c t . W H a u s f e l d p r
c h a s e a C a m p b e l l T h a n k y o u f o r d e c i d i n g t o p u r
Brad Nailer / Stapler
coupler. Insert nailer plug
or plug with attached inflation
accessory.
tighten drain valve completely to help eliminate air leaks.
o d u p c r t s .
C a m p b e l l H a u s f e l d
e e a s i e r w o j i e t P h c r t s a r
E a s y S e t u p G
L i k e a S P e t r u o p
Tire Chuck, (2) Inflation Nozzles, Inflation Needle,
Recoil Air Hose
Part Number: MP268100AV
Brad Nailer / Stapler
Part Number: SB504099AV
Inflation Adapter, and Male Plugs
Part Number: FP204008AV
F P 2 0 9 5
C o m p r e s s o r K i t
2 G a l l o n A i r
. c o m
c h p o w i s e V i t r u s a t
Nailer Oil
Part Number: ST127012AV
Crown Staples
Part Number: FN258K00AV
Brad Nails
Part Number: FB180050AV
3 mm Allen Wrench
4 mm Allen Wrench
Female Coupler
Part Number: MP288300AV
|