Boston Acoustics MP3 Player DJ030105 V1 User Manual

Connecting the Apple iPod

to your MicroSystem CD

1a. Connect iPod to Front Input

1b. Connect iPod to Rear Input

Using the required cable, connect the headphone output

on the iPod to the Front “AUX 3” input located on the

front right hand side of the MicroSystem CD.

Using the required cable, connect the headphone output

on the iPod to the Rear “AUX 1” input located on the

rear right hand side of the MicroSystem CD.

Required Cable: Stereo ⁄8-Inch to Stereo ⁄8-Inch Cable

Required Cable: Stereo ⁄8-Inch to Stereo RCA Cable

2. Turn On iPod and Set Volume

Turn on the iPod and set the volume to 50% to 70% of

total output.

Note: As there is no display on the iPod Shuffle , you

may need to re-adjust the volume on the iPod Shuffle to

better match the input’s sensitivity (after you complete

step 3) if the output level is not loud enough on the

Microsystem CD.

VOLUME

3. Select “Aux 1” Input on MicroSystem CD

If using the Front Input “Aux 3”:

Select “Aux 3” on the MicroSystem CD by pressing the “AUX”

button three times, the Microsystem CD display will read “AU-3”.

If using the Rear Input “Aux 1”:

Select “Aux 1” on the MicroSystem CD by pressing the “AUX”

button once, the Microsystem CD display will read “AU-1”.

Boston Acoustics, Inc.

300 Jubilee Drive

Peabody, MA 01960

Boston, Boston Acoustics, and the Boston Acoustics logo are registered

trademarks of Boston Acoustics, Inc. iPod, iPod Shuffle, and the iPod design

are registered trademarks of Apple Computers. Inc.

DJ030105-V1