Fire Alarm Systems | FMM‑325A Series Analog Manual Stations
FMM‑325A Series Analog Manual Stations
Compatible with advanced digital communication
protocol
▶
Digital data communications and power provided over
two-wire circuit
▶
EEPROM addressing in module unit
▶
▶
Rugged die‑cast housing and corrosion resistant
construction
Single‑gang mounting
▶
▶
▶
▶
Latching alarm lever
UL listed for commercial fire applications
Meets Americans with Disabilities Act (ADA)
requirements
The FMM‑325A Series Analog Manual Stations are used in
the polling circuit of the Bosch Security Systems, Inc.'s
FPA‑1000‑UL, D9024, D8024, and D10024A Fire Alarm
Control Panels (FACP). They communicate with the control
panel (both power and data) over a two‑wire polling circuit.
Installation/Configuration Notes
Compatibility Information
The following products are compatible with the FMM‑325A
Series Analog Manual Stations:
Category
Product ID
Product Description
The manual station's address on the polling circuit is set by
programming an EEPROM microchip. The D5070 Analog
Device Programmer is required to set the address.
Control Panels:
FPA‑1000‑UL Compact Fire Panel
D8024
D9024
D10024A
D5070
Analog FACP
All commercial buildings use manual stations. These manual
stations allow people evacuating a building to initiate an
alarm. The FACP identifies the alarm point on the polling
circuit and the alarm lever latches in the pulled position.
Analog FACP
Analog FACP
Programmers:
Analog device programmer
Mounting Considerations
The FMM‑325A manual stations are for indoor use only.
The FMM‑325A Series Analog Manual Stations have die-cast
housings that flush mount on a single-gang back box. For
surface mounting, use an FMM‑100BB‑R Surface‑mount
Back Box.
Certifications and Approvals
Region
Certification
UL
USA
UNIU: Boxes, Non-Coded (UL38)
7150-1615: 122
CSFM
ADA
Complies with Americans with Disabilities
Act ADA 4.28.3
NFPA
Complies with National Fire Protection As-
sociation NFPA 72
|