SideKick™
Indirect Water Heater
Offering a cost-effective water heating alternative. These units use indirect
water-to-water heat transfer by circulating boiler-fed hot water through a coil
insidethe water tank. Idealfor applicationsthat use boilers for space heating.
Robust construction - Inner tank
is precision built from high quality
steel and repetitive pressure testing
assures the highest quality.
Factory installed T&Prelief valve - CSA
listed andASME rated.
1-1/2” coil diameter - larger diameter
results in higher recovery and less
pressure drop through the coil, smooth
surface on coil resists lime build up.
Durable exterior - All
steel construction with an
environmentally-friendly powder
coat finish providing a tough and
attractive exterior.
2” Non-CFC foam insulation -
reduces standby heat loss and
meets or exceeds federal and state
environmental requirements.
- cobalt-enriched
porcelain enamel glass lined tank
and coil are highly resistant to
aggressive water. Not susceptible
to damage due to the presence of
chloride in the water.
Two magnesium anode rods - inhibit
corrosion and maximize tank life.
Electrolysis attacks the anode rods, not
the tank.
Automatic controls - immersion
aquastat used in all models.
Factory installed dielectric nipples
on boiler connections - provides
greater insulating protection.
Factory installed brass drain valve -
accessible, tamper-proof.
Sediment reduction inlet - on 80SK
and 199SK models “swirls” incoming
water to reduce sediment buildup.
7-Year limited warranty on residential installations
3-Year limited warranty on commercial installations
|