Dual Alarm Clock Radio
For iPod
The Gold Technical Support Line: 1902 215 259
Personal Product Support
(Charges will apply at $2.95 per minute)
BCR002IP
BCR002IP
Dual Alarm Clock Radio For iPod
Universal dock connector
1
4
2
dimmer
down
alarm1/alarm2
up
time set
vol-
function
vol+
3
7
5
8
6
Snooze/Nap/Sleep
9
① Dimmer: backlight adjusting
② Alarm1/Alarm2: alarm on/off
⑥ UP: tune radio station, time setting &
alarm clock setting
③ Time set: alarm setting /time setting
④ Function: aux-radio-iPod and power on/off
⑤ Down: tune radio station, time setting &
alarm clock setting
⑦ Vol-: volume down
⑧ Vol+: volume up
⑨
Snooze/Nap/Sleep
pm indicator
time
working mode
indicator
snooze indicator
sleep indicator
alarm indicator
speaker
nap indicator
BACK PANEL
DC
iPod radio buzzer
LINE IN
slide here to select the alarm mode
BATTERY COMPARTMENT COVER
DC JACK
LINE IN
3
BCR002IP
Dual Alarm Clock Radio For iPod
BATTERY INSTALLTION FOR PLAY AND TIME MEMORY
1. Remove the battery cover before operation
2. Put 6x1.5V(aa-size) battery into the compartment
Noted: ensure that (+) and (-) symbol are respected
3. Put the battery compartment cover back in position
FUNCTION
1. To switch on the unit, press and release the function button
2. To turn off the unit, press & hold the function button for 2 seconds, then release it
3. Without iPod on the dock, the default play mode order is: aux-radio
4. With the iPod on the dock, the default play mode order is: aux-radio-iPod
iPod OPERATION
1. Put the iPod into the dock
2. Press the function button to reach iPod mode
3. Press the “Vol-” and “Vol+” buttons to decrease/increase the volume sound
4. Press the down or up button to select the desired song
RADIO OPERATION
1. Press function button to select the radio mode
2. To press the down or up button for 2 seconds, the unit will automatically scan
and store radio station
3. Press the down or up button to fine tune radio station
ALARM SETTING
1. To enter Alarm1, press the Alarm1/Alarm2 button once, Alarm1 appears on the display
2. To set Alarm1, press the Time Set button once the alarm hour flashes
3. Press the up or down button until you reach the desired hour
4. To confirm and enter Alarm Minutes mode, press the Time Set button again. The alarm minutes will flash on the display
5. Press the up or down button until you reach the desired minute
6. To confirm, press the Alarm Set button
7. To enter Alarm2, press the Alarm1/Alarm2 button again. Alarm2 will appear on the display
8. To set Alarm2, repeat steps 2-6
9. Please find the different Alarm mode (iPod, radio, buzzer) at the back of the unit
SETTING THE CLOCK
1. To enter hour mode, press the time set button for 2 seconds, the hour flashes on the display
2. To set the hour, press the up or down button until you reach the desired time
3. To confirm and enter minute mode, press the time set button again, the minute will flash on the display
4. To set minutes, press the up or down button until you reach the desired time
5. To confirm and exit, press the Time Set button again
SNOOZE NAP SLEEP SETTING
1. Snooze/nap/sleep button have 3 functions
2. Snooze: to activate the snooze function, press the snooze/nap/sleep button when the alarm sounds. The alarm turns off
and snooze appears on the display, the alarm sounds again after 9 minutes
3. Nap: to select a nap period of 15,30,45,60 minutes when the power is off, press the snooze/nap/sleep button 1,2,3,4 times,
respectively. The alarm sounds automatically at the time selected. To switch off the nap function, press the
snooze/nap/sleeep/button again
4. Sleep: to select a sleep period of 15,30,45 or 60 minutes, press the snooze/nap/sleep button 1,2,3,4 times, respectively.
The music playing turns off automatically at the time selected
CHARGING iPod BATTERY
1. Connect the iPod to Dock connector and plug the AC adapter
CONNECT TO YOUR MP3 OR MP4
1. Press the FUNCTION button to the AUX mode
2. Put one end of the AUX Jack cable into the MP3 or MP4
Frequency: FM87.5-108MHz
Antenna FM: Wire Antenna
Power required: DC 9V, 6x1.5V AA/UM3 battery for play and time memory
Adapter: DC9V 1000mA
Max Power Outpower: 1.6W
10% THD Power Outpower: 1.5W
4
BCR002IP
Dual Alarm Clock Radio For iPod
Troubleshooting
SYMPTOM
CAUSE
REMEDY
The adapter plug may be loose
on the unit or the outlet
Unplug the adapter and re-plug to
the AC outlet
No electricity
Power button not working
properly or incorrect operation
Use the remote control to start the
unit or read the user manual again
Start the unit
Check if the audio source is mute.
Check the audio source's wire
connection
The audio source may be mute
or not connected properly
No sounds when playing
The iPod may be not docked
properly
Unplug the iPod and then dock the
iPod again
iPod cannot be charged
Adjust the volume level or
use another audio source
Poor audio source or strong
audio signal interference
Distortion
Remote control does
not function properly
Remote range out of receiving
range or battery power is low
Replace the battery or reduce the
distance between the remote control
and main unit
5
BCR002IP
Dual Alarm Clock Radio For iPod
Warranty
Please keep your receipt as proof of purchase. This product is under warranty for any
defects in materials or workmanship for one year after the original date of purchase.
This product is for normal domestic and office use only. This warranty does not
cover damage from misuse or neglect, accidental damage, vermin infestation,
excessive voltages such as lightning, power surges or any alterations that affects
the performance or reliability of the product.
In the unlikely event that your product fails to work normally, please contact the
Bush Warranty Helpline 1800 509 394 (Australia) or 0800 450 259 (New Zealand)
and have your receipt of purchase on hand.
This guarantee is subject to the following provisions:
• It is only valid within boundaries of the country of purchase
• The product must be correctly assembled and operated in accordance with the
instructions contained in this manual
• This product must be used solely for domestic purposes
• This guarantee does not cover accidental damage
• This guarantee will be rendered invalid if the product is resold or has been
damaged by inexpert repair
• The manufacturer disclaims any liability for incidental or consequential
damaged
This guarantee is in addition to, and does not diminish, your statutory or
legal rights.
PO BOX 6287
Silverwater NSW 1811
Bush Warranty: 1800 509 394 Australia
Bush Warranty: 0800 450 259 New Zealand
6
|