Beko Speaker System HPS 100 User Manual

Model No: HPS-100  
HOME THEATRE SPEAKER SET  
 
liquids, such as vases, should be placed on the apparatus.  
Safety Warnings  
Leave 15cm for ventilation.  
Do not block the pipe of the subwoofer.  
Do not open the cover and do not repair yourself. Do not function the system when liquid  
Refer servicing to qualified personnel.  
gets into the subwoofer.  
Do not climb on this system.  
Pull out the plug while smoke,  
particular smell or noise inside.  
 
Front panel operation  
1. Remote sensor  
2. Power LED light  
3. Power On/ Off Button  
Rear panel setting  
1.Front Left and Right Input terminal  
2.Center Input terminal  
3.Subwoofer Input terminal  
4.Rear Left and Right Input terminal  
5. Front Right channel speaker input terminal  
6. Front Left channel speaker input terminal  
7. Rear right channel speaker input terminal  
8. Center channel speaker input terminal  
FUSE  
AC POWER  
 
9. Rear left channel speaker input terminal  
Connections with sound source and satellites  
1. Connection with sound source equipment  
2. Connection with satellite speakers  
FUSE  
AC POWER  
 
Operation instructions  
1. Stereo / 5.1 Mode Selection  
For stereo mode, please connect the sound source with Front L and Front R input terminal.  
This unit is AC-3 and DTS compatible. For 5.1 sound effect, please connect it with 5.1 input  
terminals.  
2. Power On  
Front panel operation  
Press the Power button and once LED light flickers, this product is connected with power.  
3. Master and Woofer Volume adjust  
Remote control operation  
①. Press button of “Master ” or “Master ” to increase or decrease the volume of whole  
speaker system.  
.Press button of “Woofer ” or “Woofer ” to increase or decrease the volume of whole  
speaker system.  
4. Power off  
Front Panel Operation  
Press the Power button again and once LED light diminishes, this product is disconnected  
from power.  
 
Trouble Shooting  
Problem  
Cause  
Solution  
z
z
Improper connection of  
speaker terminal.  
z
z
Ensure that the equipment  
is connected properly.  
Improper connection of  
sound frequency  
terminal.  
Ensure that the sound  
frequency is connected  
properly.  
No sound  
z
z
z
Improper connection of  
AC plug and the socket.  
Volume is too low.  
z
z
z
Insert the AC plug securely  
into the AC outlet.  
Increase the volume with  
volume controlling button.  
Cut off power, reconnect  
the speaker, then start the  
power again.  
The speaker terminal is  
short-circuited  
z
z
z
Improper connection of  
amplifier input terminal.  
z
z
z
Ensure that the input  
terminal is connected  
properly.  
Lower the volume with  
volume controlling button.  
Sound distortion  
The volume is too high.  
Improper connection of  
amplifier input terminal  
Ensure that the input  
terminal is connected  
properly  
Adjust the woofer and  
master volume properly  
Replace with new  
batteries.  
Sound only from  
one channel  
z
z
Input level is too high  
z
z
The battery has gone  
off.  
Remote control  
fails to work  
z
Interference by strong  
and direct sunlight.  
z
Keep the sensor away  
from sunlight.  
 
z
Obstacle in front of the  
sensor.  
z
Remove the obstacle.  
Technical Data  
Model No.:  
Power/Frequency:  
230 V ~50Hz  
Watts:  
Subwoofer: 30W  
Satellite: 15WX5  
 

Abocom Network Card H Disk User Manual
Abocom Network Router EFM56CC User Manual
Accusplit Fitness Electronics 998 299B User Manual
Agilent Technologies Computer Hardware E1300B User Manual
Aleratec Computer Accessories 350117 User Manual
Amana Microwave Oven RCS10DA User Manual
American Standard Hot Tub 015 0225 User Manual
Axis Communications Printer NPS 530 User Manual
axis international marketing Camcorder 2130R PTZ User Manual
Beko Refrigerator CH 146121 DE User Manual