In sta lla tio n In stru ctio n s / Wa rra n ty
Mo n tre u x
16510XX1
Mo n tre u x
16803XX1
In sta lla tio n
1 6 5 1 0 XX1 o n ly : Place the pull rod assem-
bly in the center hole of the mounting surface.
Thread the friction washer, metal washer and
mounting nut to the shank.
Tighten the mounting nut by hand. Tighten the
tensioning screws.
1 6 8 0 3 XX1 & 1 6 5 1 0 XX1 : Place the fau-
cet assembly in the two valve holes.
3
Thread the friction washers, metal washers and
mounting nuts to the valve shanks.
Tighten the mounting nuts by hand. Tighten the
tensioning screws.
Install the spout, slide bushing and o-ring. Make
sure that the slide bushing is oriented correctly.
Tighten the set screw.
Lightly coat the handle o-rings with the en-
closed lubricant.
Install the index caps on the hot and cold
handles and pull rod assembly.
1 6 5 1 0 XX1 o n ly : Install the pop-up drain.
Ca u tio n : the hot water
riser may be hot!
4
1 6 5 1 0 XX1 & 1 6 8 0 3 XX1 : Connect the
supply lines to the stops with 3/ 8” compression
fittings (not included). Use two wrenches, as
shown in the diagram, to keep the supply hoses
from twisting.
Turn on the water and check all connections for
leaks.
In sta ll th e p o p -u p d ra in (1 6 5 1 0 XX1 o n ly )
Remove the plunger assembly.
plunger assembly
Unscrew the drain outlet flange from the tee.
height adjuster
outlet flange
Unscrew the tailpiece from the tee. Wrap the threads with
TeflonTM thread tape and replace.
Install the white, flexible sealing gasket to the flange.
Place it in the sink outlet.
pull rod
From under the sink, install the black mack gasket, white
friction ring , and retainer nut to the flange. Do not tighten
the nut against the bottom of the sink at this time.
sealing gasket
mack gasket
friction ring
retainer nut
Thread the tee and tailpiece to the flange. The pivot must
face the faucet. If necessary, turn the drain assembly.
Tighten the retainer nut.
Place the plunger assembly in the drain.
tee
pivot ball seal
pivot ball
pivot ball
nut
Install the horizontal rod so that the end goes through the
loop in the bottom of the height adjuster.
Install and hand tighten the pivot ball nut.
horizontal rod
swivel connector
Attach the swivel connector to the end of the horizontal
rod.
tailpiece
Attach the swivel connector to the end of the pull rod.
Position as desired, and tighten with a small, flathead
screwdriver.
5
Re p la ce m e n t Pa rts
1 6 8 0 3 XX1
5
4
2
1
11
13
3
6
11x2
12
2
9
10
1
2
3
4
5
6
7
8
9
handle
screw cover
sleeve
aerator cpl. 16510XXX
spout 16510XXX
hot cartridge
fixation set
pull rod
diverter knob
16597XXX
97987000
97993XXX
97991XXX
97990XXX
94009000
96078000
94067000
98619XXX
98620XXX
7
10 flange
11 spout large model 16803XXX 98616XXX
12 aerator cpl. 16803XXX
13 cold cartridge
14 supply hose 16510XXX
supply hose 16803XXX
98617XXX
94008000
89437000
14099001
8
14
XXX = Color
001 = Chrome
821 = Brushed Nickel
831 = Polished Nickel
6
Cle a n in g Re co m m e n d a tio n fo r Ha n sg ro h e Pro d u cts
Modern faucetry and shower products utilize a combination of materials to comply with the needs of the
market with regard to design and functionality.
To avoid damage, it is necessary to use some caution when cleaning. Damage caused by improper treatment
is not covered under the Hansgrohe warranty.
Cle a n in g Ma te ria ls fo r Fa u ce ts a n d Sh o w e rs
•
•
To remove lime scale, use only products made specifically for that purpose. Always follow the
manufacturer’s instructions when using.
Do not use cleaners that contain hydrochloric, formic, acetic, or phosphoric acids, as these will cause
considerable damage to finishes and to plastic components.
•
•
Never mix cleaning materials.
Never use cleaners containing abrasives. Do not use abrasive cleaning cloths, pads, or sponges.
Cle a n in g Pro ce d u re s
•
•
Clean your faucets and shower products as and when required. Regular cleaning will prevent scale
buildup and water spotting.
Follow the label instructions. Do not allow any cleaner to remain on the product for longer than
necessary.
•
•
When using spray cleaners, spray first onto a sponge or cloth – do not spray directly onto the product.
After cleaning, rinse thoroughly with clear water to remove any cleaner residue.
Im p o rta n t
•
•
Soap and shampoo residue can also cause damage to the product. Rinse well with clean water after use.
If the surface is already damaged, harsh cleaning materials will cause further damage.
Lim ite d Life tim e Co n su m e r Wa rra n ty
This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”). This warranty is limited to
Hansgrohe products which are purchased by a consumer in the United States after March 1, 1996, and installed in either the United States or
Canada.
WHO IS COVERED BY THE WARRANTY
This warranty extends to the original consumer purchaser only.
WHAT IS COVERED BY THE WARRANTY
This warranty covers only your Hansgrohe manufactured product. Hansgrohe warrants this product against defects in material or workmanship
as follows: Hansgrohe will repair at no charge for parts only or, at its option, replace any product or part of the product which proves defective
because of improper workmanship and/ or material, under normal installation, use, service and maintenance. If Hansgrohe is unable to provide a
replacement and repair is not practical or cannot be timely made, Hansgrohe may elect to refund the purchase price in exchange for the return of
the product.
LENGTH OF WARRANTY
Replacement or repaired parts of products will be covered for the term of this warranty as stated in the following two sentences. If you are a
consumer who purchased the product for use primarily for personal, family, or household purposes, this warranty extends for as long as you own
the product and the home in which the product is installed. If you purchased the product for use primarily for any other purpose, including, without
limitation, a commercial purpose, this warranty extends only (i) for 1 year, with respect to Interaktiv and Retroaktiv products, and (ii) for 5 years,
with respect to AXOR, ShowerPower and Pharo products.
7
THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR:
A.
B.
Conditions, malfunctions or damage not resulting from defects in material or workmanship.
Conditions, malfunctions or damage resulting from (1) improper installation, improper maintenance, misuse, abuse, negligence, accident
or alteration, or (2) the use of abrasive or caustic cleaning agents or “no rinse” cleaning products, or the use of the product in any manner
contrary to the product instructions.
C.
D.
Labor or other expenses for the disconnection or return of the product for warranty service, or for installation or reinstallation of the product.
Accessories or related products not manufactured by Hansgrohe.
TO OBTAIN WARRANTY SERVICE
Contact your Hansgrohe retailer, or write to Technical Service at:
Hansgrohe Inc.
1492 Bluegrass Lakes Parkway
Alpharetta GA 30004
Or, call Hansgrohe toll-free at (800) 334-0455.
In requesting warranty service, you will need to provide
1.
2.
3.
The sales receipt or other evidence of the date and place of purchase.
A description of the problem.
Delivery of the product or the defective part, postage prepaid and carefully packed and insured, to Hansgrohe Inc. 1492 Bluegrass Lakes
Parkway, Alpharetta, Georgia 30004, Attention: Technical Service, if required by Hansgrohe.
When warranty service is completed, any repaired or replacement product or part will be returned to you postage prepaid.
EXCLUSIONS AND LIMITATIONS
REPAIR OR REPLACEMENT (OR, IN LIMITED CIRCUMSTANCES, REFUND OF THE PURCHASE PRICE) AS PROVIDED UNDER THIS WARRANTY IS
THE EXCLUSIVE REMEDY OF THE PURCHASER. HANSGROHE NEITHER ASSUMES NOR AUTHORIZES ANY PERSON TO CREATE FOR IT ANY
OBLIGATION OR LIABILITY IN CONNECTION WITH THIS PRODUCT.
HANSGROHE SHALL NOT BE LIABLE TO PURCHASER OR ANY PERSON FOR ANY INCIDENTAL, SPECIAL, OR CONSEQUENTIAL DAMAGES,
ARISING OUT OF BREACH OF THIS WARRANTY OR ANY IMPLIED WARRANTY (INCLUDING MERCHANTABILITY).
Some States do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply
to you.
This warranty gives you specific legal rights, and you may have other rights which vary from State to State.
You may be required by law to give us a reasonable opportunity to correct or cure any failure to comply before you can bring any action in
court against us under the Magnuson-Moss Warranty Act.
PRODUCT INSTRUCTIONS AND QUESTIONS
Upon purchase or prior to installation, please carefully inspect your Hansgrohe product for any damage or visible defect. Prior to installing,
always carefully study the enclosed instructions on the proper installation and the care and maintenance of the product. If you have questions
at any time about the use, installation, or performance of your Hansgrohe product, or this warranty, please call or write to us at the toll-free
number and address printed above.
Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA 30004
Tel. 770 360-9880 • Fax 770 360 9887
w w w .h a n sg ro h e -USA.co m
|