INSTALLATION GUIDE
AXIS M1025 Network Camera
turning the equipment off and on, the
user is encouraged to try to correct the
interference by one or more of the
following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an
outlet on a circuit different from
that to which the receiver is
connected.
• Low Voltage (LVD) Directive 2006/
• Restrictions of Hazardous
Substances (RoHS) Directive 2011/65/
A copy of the original declaration of
conformity may be obtained from
Axis Communications AB. See Contact
Electromagnetic Compatibility
(EMC)
• Consult the dealer or an experienced
radio/TV technician for help.
This equipment has been designed and
tested to fulfill applicable standards
for:
Canada - This Class B digital
apparatus complies with Canadian
ICES-003.
Europe - This digital equipment
fulfills the requirements for RF
emission according to the Class B limit
of EN 55022.
This product fulfills the requirements
for immunity according to EN 61000-
6-1 residential, commercial and light-
industrial environments.
This product fulfills the requirements
for immunity according to EN 61000-
6-2 industrial environments.
• Radio frequency emission when
installed according to the
instructions and used in its intended
environment.
• Immunity to electrical and
electromagnetic phenomena when
installed according to the
instructions and used in its intended
environment.
USA - This equipment has been
tested using a shielded network cable
(STP) and found to comply with the
limits for a Class B digital device,
pursuant to part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential
This product fulfills the requirements
for immunity according to EN 55024
residential and commercial
environments.
Australia/new Zealand
installation. This equipment generates,
uses and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful
This digital equipment fulfills the
requirements for RF emission
according to the Class B limit of AS/
NZS CISPR 22.
interference to radio or television
reception, which can be determined by
inform your local Axis office of any
inaccuracies or omissions. Axis
Communications AB cannot be held
responsible for any technical or
typographical errors and reserves the
right to make changes to the product
and documentation without prior
notice. Axis Communications AB
makes no warranty of any kind with
regard to the material contained
within this document, including, but
not limited to, the implied warranties
of merchantability and fitness for a
particular purpose. Axis
Communications AB shall not be liable
Japan - この装置は、クラスB 情
報技術装置です。
nor responsible for incidental or
この装置は、家庭環境で使用することを目 的として
いますが、この装置がラジオやテレビジョン受信
機
consequential damages in connection
に近接
して使用されると、 受信障害を引き起こすこ
with the furnishing, performance or
use of this material. This product is
only to be used for its intended
purpose.
とがあります。 取扱説明書に従って正しい取り扱い
をして下さい。
Safety
This product complies with IEC/EN/UL
60950-1, Safety of
Disposal and Recycling
When this product has reached the
end of its useful life, dispose of
it according to local raws and
regulations. For information about
your nearest designated collection
point, contact your local authority
responsible for waste disposal. In
accordance with local legislation,
penalties may be applicable for
incorrect disposal of this waste.
Information Technology Equipment.
The power supply used
with this product shall fulfill the
requirements for Safety
Extra Low Voltage (SELV) and Limited
Power Source (LPS)
according to IEC/EN/UL 60950-1. The
POE (Ethernet) cable should not be
routed to an outside power source
unless protectively earthed.
Equipment Modifications
This equipment must be installed and
used in strict accordance with the
instructions given in the user
Europe
This symbol means that the
product shall not be disposed
of together with household or
documentation. This equipment
contains no user-serviceable
commercial waste. Directive 2012/19/
EU on waste electrical and electronic
equipment (WEEE) is applicable in
the European Union member states. To
prevent potential harm to human
health and the environment, the
product must be disposed of in an
approved and environmentally safe
recycling process. For information
components. Unauthorized equipment
changes or modifications will
invalidate all applicable regulatory
certifications and approvals.
Liability
Every care has been taken in the
preparation of this document. Please
about your nearest designated
collection point, contact your local
authority responsible for waste
disposal. Businesses should contact
the product supplier for information
about how to dispose of this product
correctly.
This product complies with the
requirements of Directive 2011/65/EU
on the restriction of the use of certain
hazardous substances in
electrical and electronic equipment
(RoHS).
channels according to your AVHS
license agreement to ensure a rapid
response.
Learn More!
Visit Axis learning center
trainings,
webinars, tutorials and guides.
Warranty
China
This product complies with the
requirements of the legislative
act Administration on the
Control of Pollution Caused by
Electronic
Contact Information
Axis Communications AB
Emdalavägen 14
223 69 Lund
Information Products (ACPEIP).
Support
Should you require any technical
assistance, please contact your Axis
reseller. If your questions cannot be
answered immediately, your reseller
will forward your queries through the
appropriate channels to ensure a rapid
response. If you are connected to the
Internet, you can:
Sweden
Tel: +46 46 272 18 00
Fax: +46 46 13 61 30
Safeguards
Please read through this Installation
Guide carefully before installing the
Axis product. Keep the
Installation Guide for further
reference.
• download user documentation and
firmware updates
• find answers to resolved problems in
the FAQ database. Search by
product, category, or phrases
• report problems to Axis support by
logging in to your private support
area.
• chat with Axis support staff
(selected countries only)
techsup/
Should you require any technical
assistance, please contact appropriate
• Store the Axis product in a dry and
ventilated environment.
• Avoid exposing the Axis product to
vibration, shocks or heavy pressure.
Do not install the product on
unstable brackets, unstable or
vibrating surfaces or walls, since this
could cause damage to the product.
un fournisseur tiers.
• Only use applicable tools when
installing the Axis product; excessive
force could cause damage to the
product.
• Do not use chemicals, caustic agents,
or aerosol cleaners. Use a damp cloth
for cleaning.
• Utilisez uniquement des pièces de
rechange fournies ou recommandées
par Axis.
• Ne tentez pas de réparer le produit
vous-même, contactez Axis ou votre
revendeur Axis pour toute
réparation.
• Use only accessories that comply
with technical specification of the
product. These can be provided by
Axis or a third party.
• Use only spare parts provided by or
recommended by Axis.
Ce produit Axis doit être utilisé
conformément aux lois et
réglementations locales en vigueur.
• Do not attempt to repair the product
by yourself, contact Axis or your Axis
reseller for service matters.
• Lagern Sie das Axis-Produkt in einer
trockenen und belüfteten
Umgebung.
• Setzen Sie das Axis Produkt keinen
Vibrationen, Erschütterungen oder
starkem Druck aus. Installieren Sie
das Produkt nicht an instabilen
Halterungen oder instabilen oder
vibrierenden Oberflächen oder
Mauern, da dadurch das Produkt
beschädigt werden könnte.
• Verwenden Sie bei der Installation
des Axis Produkts nur geeignetes
Werkzeug; zu hoher Kraftaufwand
kann das Produkt beschädigen.
• Verwenden Sie keine chemischen,
ätzenden oder aerosolhaltigen
Reinigungsmittel.
• Verwenden Sie zur Reinigung ein
feuchtes Tuch.
• Verwenden Sie nur Zubehör, das den
technischen Spezifikationen des
Produkts entspricht. Dieses ist von
Axis oder Drittanbietern erhältlich.
• Verwenden Sie nur Ersatzteile, die
von Axis empfohlen bzw.
bereitgestellt wurden.
• This Axis product shall be used in
compliance with local laws and
regulations.
• Conservez le produit Axis dans un
environnement sec et aéré.
• Évitez d'exposer le produit Axis aux
vibrations, aux chocs ou à une forte
pression. N'installez pas le produit
sur un support instable, ou des
surfaces ou des murs instables ou
vibrants, car cela pourrait
l'endommager.
• N'utilisez que les outils applicables
pour installer le produit Axis ; une
force excessive pourrait
endommager le produit.
• Pour le nettoyage, n’utilisez ni
produits chimiques, ni substances
caustiques ou aérosols. Utilisez un
chiffon humide pour le nettoyage.
• N’utilisez que des accessoires
conformes aux caractéristiques
techniques du produit. Ceuxci
peuvent être fournis par Axis ou par
• Versuchen Sie nicht, das Produkt
selbst zu reparieren. Wenden Sie sich
bei Service- Angelegenheiten an Axis
oderanIhrenAxis-Händler.
• Guarde el producto Axis en un
entorno seco y ventilado.
• Evite exponer el producto Axis a
vibraciones, golpes o presiones
excesivas. No instale el producto en
soportes inestables ni en superficies
o paredes inestables o con
vibraciones, ya que esto podría
dañarlo.
Verwenden Sie dieses Axis-Produkt
unter Beachtung der vor Ort geltenden
rechtlichen Bestimmungen.
• Utilice solo las herramientas
apropiadas para instalar el producto
Axis; una fuerza excesiva podría
dañarlo.
• No utilice productos químicos,
agentes cáusticos ni limpiadores en
aerosol. Límpielo con un paño
húmedo.
• Utilice solo accesorios que cumplan
las especificaciones técnicas del
producto. Puede obtenerlos de Axis o
de un tercero.
• Utilice solo piezas de recambio
suministradas o recomendadas por
Axis.
• Conservare il prodotto Axis in un
ambiente asciutto e ben ventilato.
• Evitare di esporre il prodotto Axis
alle vibrazioni, agli urti o a forte
pressione. Non installare il prodotto
su staffe instabili, superfici o pareti
instabili o vibranti, poiché ciò
potrebbe danneggiare il prodotto.
• Utilizzare solo strumenti idonei
quando si installa il prodotto Axis.
Una forza eccessiva potrebbe
danneggiare il prodotto.
• Non utilizzare sostanze chimiche,
agenti caustici o detergenti spray.
Utilizzare un panno umido per la
pulizia.
• Utilizzare solo accessori conformi
con le specifiche tecniche del
prodotto. Queste possono essere
fornite da Axis o da terze parti.
• No intente reparar el producto usted
mismo, póngase en contacto con
Axis o con el distribuidor de Axis
para los temas de servicio técnico.
• Utilizzare solo parti di ricambio
fornite o raccomandate da Axis.
• Non tentare di riparare il prodotto da
soli, contattare Axis o il rivenditore
di zona Axis per assistenza.
Este producto Axis se utilizará de
conformidad con la legislación y
normativas locales.
Battery
This Axis product uses a ML614R
rechargable cell as the power supply
for its internal real-time
clock (RTC). Under normal conditions
this battery will last for a minimum of
2 weeks.
Questo prodotto Axis deve essere
utilizzato in conformità alle leggi e alle
disposizioni locali.
Dispose of used batteries according to
the manufacturer's instructions.
Jetez les piles usagées conformément
aux consignes du fabricant.
Verbrauchte Batterien sind gemäß den
Herstelleranweisungen zu entsorgen.
Smaltire le batterie usate secondo le
istruzioni del produttore.
AXIS M1025
Page 9
1x
1x
1x
1x
1x
1x
Camera owner authentication key
The authentication key on this label is used authenticate the owner/administrator of this Axis
to
camera. The key is associated with the camera’s uniqeuserial number (S/N), as shown at the top of the
label. The authentication key is used for registerintghe camera with an AVHS service provider for hosted
video. For more information and help to find local AVHS Service Provider, go to:
a
Please retain this document for future reference.
Label here
©2006-2010 Axis Communications AB.
Axis is registered trademark. All other company names and products are
trademarks or registered trademarks of their respective companies. We
reserve the right to introduce modifications without notice.
a
Part No. 38655
1x
2x
4x
4x
1x
1x
AXIS M1025
Page 11
1
PoE IEEE 802.3af/802.3at Type 1 Class1
Max 3.5 W
Page 12
AXIS M1025
2
720p (HDMI)
@ 30/25 fps
AXIS M1025
Page 13
17
3
4
Page 14
AXIS M1025
5
6
AXIS M1025
Page 15
7
Page 16
AXIS M1025
8
AXIS M1025
Page 17
Installation Guide
Ver.1.3
Printed: May 2014
Part No. 57737
AXIS M1025 Network Camera
© Axis Communications AB, 2014
|