Model PRO-9175FT4
Owner’s Manual
4 Channel Remote
Car Starter
FEATURES :
w2 Four Button Programmable RF Transmitters
wSeperate Lock And Unlock Transmitter Buttons
wFour Channel Receiver (capable of accepting 4 transmitters)
wAnti Code Grabbing Technology
wRemote Start Safety Control Switch
wSafe Start RF Control (Double Push Of RF Transmitter)
wSelectable Automatic Timed Start Mode
wNegative and Positive Keyless Entry Outputs
wOn-Board Start Relay
wOn-Board Accessory Relay
wOn-Board Ignition 1 Relay
wOn-Board Ignition 2 Relay
wOn-Board Parking Light Relay
wIgnition 2 Relay Selectable On or Off During Cranking
wIgnition 3 / Shock By-Pass / GM VAT Output (relay required)
wTach Signal Learning Circuit
wTwo Negative and Two Positive Safety Shutdown Circuits
wAlarm By-Pass Output
wChannel 3 Output for Remote Trunk Release (relay required)
wChannel 4 Output to Control Optional Accessories
wSelectable Steady or Flashing Parking Lights for Run Indication
wSelectable 5, 10, 15 or 20 Minute Run Time
wSelectable 1 Sec. 3.5 Sec. Or Double Pulse Door Lock Output
wOptional Illuminated Entry Output (Relay Required)
wExternal Activation Control Input
OPTIONS:
wRemote Power Window Control
wRemote Garage Door Interface
wMultiple Vehicle Capable
CAUTION! Be certain that the vehicle is outdoors before using this or any remote
vehicle starting device. A running engine produces dangerous carbon
monoxide fumes which can be harmful or fatal if prolonged exposure
occurs. DO NOT remote start the vehicle if it is garaged.
To remotely operate the device indicated, momentarily press, or press and hold the trans-
mitter button with the word "Option" on it.
SAFETY (Red Handled ) CONTROL SWITCH
The control switch allows you to temporarily disable the remote starting function of your
PRO-9175FT4. To disable the unit, move the red handled control switch to the off posi-
tion.
The control switch also allows you to select between 2 hour start up and 4 hour start up
when using the automatic start up timer mode. The factory preset start up time for this
mode is every 4 hours. To select between 2 or 4 hour start up timer:
1. Begin with the control switch in the on position
2. Turn the ignition switch on then off
3. Within 10 seconds, move the control switch off, on, off, on (2 switch cycles) to select a
2 hour start timer. After 10 seconds expire, the parking lights will flash 2 times confirm-
ing that the two hour start cycle is set. Or, within 10 seconds move the control switch
off, on, off, on, off, on, off, on (4 switch cycles) to select a 4 hour start timer. The
parking lights will flash 4 times confirming that the 4 hour start timer is set.
REMOTE STARTING THE VEHICLE
The PRO-9175FT4 WILL NOT start the vehicle if any one of the following conditions
exists:
1. The Vehicle Hood Is Opened.
2. The Gear Selector Is In Any Gear Other Then Park.
3. The Brake Is Depressed.
4.The Safety Control Switch Is In The Off Position.
CAUTION! Be certain that the vehicle is outdoors before using this or any remote vehicle
starting device. A running engine produces dangerous carbon monoxide fumes
which can be harmful or fatal if prolonged exposure occurs. DO NOT remote
start the vehicle if the car is garaged.
To Remote Start The Vehicle:
Press and release the transmitter button with the "Trunk/Key" symbol on it, two times within
2 seconds. The vehicle will start and remain running for the pre-programmed 5, 10, 15, or
20 minutes. As a visual indication, the parking lights will flash or turn on dependent on the
programming set up by your installation center.
When you arrive at your vehicle, unlock it with the key or by pressing and releasing the
unlock button of your keychain transmitter. Enter the vehicle and turn the ignition key to
the on position.
CAUTION! Do not turn the key to the start position. This will cause the starter motor to
engage with the already running engine which could result in damage. Step
on the brake pedal to disengage the remote start unit. The vehicle will con-
tinue to run but now on it's own power.
NOTE: The engine will stop running before the expiration of the pre-programmed run timer
if you complete any of the following:
1. Press and release the trunk/key button of your keychain transmitter two
times within 2 seconds.
2. Depress the brake pedal.
3. Open the hood.
Page 3
4. Move the red handled control switch to the off position.
5. Race the engine to above 4000 RPM.
OPERATING ON AUTOMATIC START UP TIMER MODE
The PRO-9175FT4 has the ability to automatically start the vehicle every 2 or 4 hours
over a 48 hour period. This feature is especially useful in cold climates where the only
means to keep the engine and engine fluids warm is to periodically start the engine.
CAUTION! Be certain that the vehicle is outdoors before using this or any remote vehicle
starting device. A running engine produces dangerous carbon monoxide fumes
which can be harmful or fatal if prolonged exposure occurs. DO NOT remote
start the vehicle if the car is garaged.
TO BEGIN THE AUTOMATIC START UP TIMER
1. Turn the ignition key on then off.
2. Within 10 seconds, activate the RF start command two times. (Push the trunk/key
button of your keychain transmitter 4 times).
The parking lights will flash 4 times indicating the timed start mode is activated.
The vehicle, on a 2 or 4 hour interval basis, will automatically start, run for the pre-
programmed time (5, 10, 15, or 20 minutes), and then shut off. This will continue for 48
hours.
NOTE: The automatic start up timer can also be initiated from the keychain transmitter.
To do this:
1. Start the vehicle using the keychain transmitter by pressing and releasing the
trunk/key transmitter button 2 times.
2. Shut off the vehicle using the keychain transmitter by pressing and releasing the
trunk/key transmitter button 2 times.
3. Within 10 seconds of step 2, activate the RF start command two times. (Push the
trunk/key button of your keychain transmitter 4 times).
The parking lights will flash 4 times indicating the timed start mode is activated.
CANCELING THE AUTOMATIC START UP TIMER
To cancel the automatic start up timer do one of the following;
1. Start the vehicle manually with the use of the ignition key and depress the brake pedal.
2. Remote start the vehicle using your keychain RF transmitter.
3. Shut off the vehicle using the keychain transmitter by pressing and releasing the
trunk/key transmitter button 2 times.
FUNCTION SETTING CHART
To be completed by installer
Door Lock Timer
Parking Lights
Run Time
o1 Sec.
oSteady
o5 Min
oOn
o3.5 Sec.
oPulsed
o10 Min
oOff
o1 Sec/Dbl 1 Sec.
o15 Min
o20 MIn
Accy Lock
Accy Unlock
oDr. Door
oAll Doors
oOff
Note: Two step unlock is an option and may not have been installed.
© 2000 Audiovox Electronics Corporation, Hauppauge, NY 11788
128-5880
|