Battery life* (approx. hours)
To check the program
Button/Switch and its Function/Operation
WARNING
(When the CD player is used on a flat and stable place.)
Playing time varies depending on how the CD player is used.
During programming, press ENTER/DISPLAY repeatedly
before step 5. Each time you press ENTER/DISPLAY, the
track number appears.
3-252-981-21 (1)
0
MODE
To prevent fire or shock hazard, do not expose the unit to
rain or moisture.
For CD player: Press repeatedly until the play mode
you want appears in the display.
No indication: Normal play
“1”: Single play
“SHUF”: Shuffle play
“PGM”: PGM (program) play
To repeat the play mode you selected, press and hold
until “ ” appears.
For radio: Press until “ST” disappears from the
display to improve the receiving condition on FM.
E•A•S•S E•A•S•S Radio
ON
Note
Do not install the appliance in a confined space, such as
a bookcase or built-in cabinet.
Two Sony alkaline 38
batteries LR6 (SG)
32
58
• When you finish entering the 24th track in step 3, the
first selected track appears in the display.
• During the PGM play, you cannot check the program.
(produced in Japan)
To prevent fire, do not cover the ventilation of the
apparatus with newspapers, tablecloths, curtains, etc. And
don’t place lighted candles on the apparatus.
TV/WB/FM/AM
Portable CD Player
*
Measured value by the standard of JEITA (Japan
Electronics and Information Technology Industries
Association).
To cancel PGM play
During programming or PGM play, press MODE once so
that “PGM” disappears.
To prevent fire or shock hazard, do not place objects filled
with liquids, such as vases, on the apparatus.
To check the remaining power of the
batteries
You can check it in the display.
! HOLD
Use to lock the controls to prevent accidental button
(Continue to the reverse side)
presses.
CAUTION
The use of optical instruments with this product will
increase eye hazard.
Operating Instructions
Replace the batteries when “
” flashes.
@ VOL+/–
Press to adjust the volume.
Lo batt*
Certain countries may regulate disposal of the battery used
to power this product. Please consult with your local
authority.
* If the sound is distorted when using the SOUND function,
turn down the volume.
* Beep sounds.
To protect against sound skipping
The E•A•S•S function has been developed to provide
excellent protection against sound skipping during many
active uses.
Notes
• The indicator sections of
remaining battery power. One section does not always
indicate one-fourth of the battery power.
• Depending on operating conditions, the indicator
CAUTION
roughly shows the
• INVISIBLE LASER RADIATION WHEN OPEN
• DO NOT STARE INTO BEAM OR VIEW DIRECTLY
WITH OPTICAL INSTRUMENT
XP-ER800N
1
2
3
Insert a disc and wait until the display goes off.
While holding MODE, press ca.
Sony Corporation ©2003 Printed in China
sections of
may increase or decrease.
The validity of the CE marking is restricted to only those
countries where it is legally enforced, mainly in the
countries EEA (European Economic Area).
Notes on using the dry batteries
• Be sure to remove the AC power adaptor.
• When the batteries are depleted, replace both batteries
with new ones.
Press MODE to select the E•A•S•S mode.
CD player (front)
When you select “E•A•S•S”, the E•A•S•S function is
enhanced compared to “E•A•S•S
”.
Owner’s Record
The model number and the serial number are located at the
rear of the CD player. Record the serial number in the
space provided below. Refer to these numbers whenever
you call upon your Aiwa dealer regarding this product.
Model No. XP-ER800N
To walk with the CD player and enjoy high quality
CD sound using the E•A•S•S function, select
Strap holes
Display
1ENTER/DISPLAY
Notes on the rechargeable batteries
• To keep the original battery capacity for a long time,
charge the batteries only when they are completely
depleted.
• If the battery is new or has not been used for a long
time, it may not be charged completely until you charge
and discharge it several times.
• When carrying the rechargeable batteries, use the
battery carrying case supplied with the rechargeable
batteries to prevent unexpected heat. If the rechargeable
batteries and the metallic objects get contacted, heat or
fire may occur due to a short circuit.
“E•A•S•S
”. While taking harder exercises, it is
2PRESET CALL UP/DOWN
3BAND
recommended that you set it to “E•A•S•S.”
4
Press ENTER/DISPLAY.
Serial No.
8r/t
SKIP/SEARCH
Note
Sound may skip:
– if the CD player receives stronger continuous shock than
expected,
– if a dirty or scratched CD is played or
– when using poor-quality CD-Rs/CD-RWs or if there is a
problem with the recording device or application software.
For the customers in the USA
9ca*
0MODE
4SOUND
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference
by one or more of the following measures:
567 s(stop)/OFF/CHARGE
Checking the remaining time on the CD
and the number of tracks left
You can check the remaining time on the CD and the
number of racks left using ENTER/DISPLAY.
When to replace the rechargeable
batteries
If the battery life becomes shorter by about half, replace
the batteries with new rechargeable batteries.
DC IN 4.5 V
(external power
input) jack
A
OPEN
\ (headphones)
jack
1
Press ENTER/DISPLAY.
To use the AC power adaptor (C)
Each time you press the button, the display changes as
follows:
!HOLD
1
Connect the commercially-available AC power
adaptor whose rated output is 4.5 V DC, 500 mA, to
an AC outlet.
Display
– Reorient or relocate the receiving antenna.
–
Increase the separation between the equipment and receiver.
@VOL +*/–
Normal play
Track number and
– Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV
technician for help.
*The button has a tactile dot.
elapsed playing time
Playing a CD
Press ENTER/DISPLAY once.
You are cautioned that any changes or modifications not
expressly approved in this manual could void your
authority to operate this equipment.
Display
Play mode
Track number/PRESET number
Sound mode
To insert a CD
Track number and
remaining time on the
current track.
1
Slide OPEN to open the lid (A).
2
Fit the CD to the pivot, then close the lid (D).
Remaining
Declaration of Conformity
Notes
Press ENTER/DISPLAY once again.
battery power
Trade Name:
Model No.:
AIWA
XP-ER800N
• This CD player can play discs recorded in the Compact
Disc Digital Audio (Audio CD) format.
Responsible Party: Sony Electronics Inc.
The number of tracks left
and remaining time on
the CD*
Address:
680 Kinderkamack Road,
Oradell, NJ 07649
USA
PRESET
VOL
CHG
• This CD player can play CD-Rs/CD-RWs recorded in
the Compact Disc Digital Audio (Audio CD) format,
but playback capability may vary depending on the
quality of the disc and the condition of the recording
device.
Telephone No.:
201-930-6973
*Not displayed during the Single play and Shuffle play.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
• This product is designed to play back discs that conform
to the Compact Disc (CD) standard.
To remove the CD
Remove the CD while pressing the pivot.
Recently, various music discs encoded with copyright
protection technologies are marketed by some record
companies. Please be aware that among those discs,
there are some that do not conform to the CD standard
and may not be playable by this product.
ST
Band
Playing time/
Frequency
E•A•S•S
To operate the CD player
Power Sources
Button/Switch and its Function/Operation
To use the batteries (B)
Use only the following batteries for your CD player:
1
ENTER/DISPLAY
Press to check the remaining time on the CD and the
number of tracks left. Also press to enter the selected
track for the PGM play.
Dry batteries
• LR6 (size AA) alkaline batteries (not supplied)
To turn off the operation beep
sound
You can turn off the beep sound that is heard from your
headphones when you operate your CD player.
B
C
2
3
PRESET CALL UP/DOWN
Press to select the preset station you want.
Rechargeable batteries
Charge the rechargeable batteries before using them for
the first time.
• Commercially-available size AA Ni-MH rechargeable
batteries of 1.2 V DC, 700 mAh
BAND
Press to turn on the radio. Press also to change the
band.
1
2
Remove the power source (AC power adaptor, dry
batteries) from the CD player, and wait for about 3
seconds.
4
SOUND
Use to emphasize the bass-boosted sound. Press
Connect the power source while pressing s/OFF/
CHARGE.
To insert the batteries
repeatedly to select
or
.
Open the battery compartment lid.
enhances more than
.*
1
Open the battery compartment lid on the rear of your CD
player.
Insert the ( end first (for both batteries).
To turn on the beep sound
Remove the power source, wait for about 3 seconds, and
then connect the power source without pressing s/OFF/
CHARGE.
5
6
7
8
s(stop)
Press to stop playing.
2
Insert two batteries by matching the ) to the diagram
in the battery compartment and close the lid until it
clicks into place.
OFF
Press to turn off the radio.
3
When using the rechargeable batteries, connect the
commercially-available AC power adaptor to the DC
IN 4.5V jack of your CD player and an AC outlet,
then press s/OFF/CHARGE while the CD player is
turned off to start charging.
CHARGE
Press to start charging.
Playing tracks in your
favorite order (PGM play)
You can program the CD player to play up to 24 tracks in
your favorite order.
D
to an AC outlet
r/t (skip/search)
For CD player: Press r or t once to find the
beginning of the current/next track.
Press r or t repeatedly to find the beginning
of the previous/ succeeding tracks.
Press and hold r or t to go backward/forward
quickly.
The CD player charges the batteries. The “CHG”
indicator turns on in the display and the the indicator
DC IN
4.5V
1
During playback, press MODE repeatedly until
“PGM” flashes.
AC power
adaptor
sections of
light up in succession. When the
Label side up
batteries are completely charged, the “CHG” and
indicators get turned off.
If you press s/OFF/CHARGE after the charge has
already been completed, the
and “Full” appears in the display.
2
3
Press r or t to select a track.
For radio: Press to tune in the station you want.
Press ENTER/DISPLAY to enter the selected track.
indicator flashes
9
ca (play/pause)
\
“00” appears and the playing order increases
by one.
Press to start play. Press again to pause play.
To play from the first track, press for 2 seconds or
more while the CD player is stopped.
4
Disconnect the AC power adaptor.
4
5
Repeat steps 2 and 3 to select the tracks in your
favorite order.
Press and hold ENTER/DISPLAY until the PGM play
starts.
Headphones
|