Overview
2.5” form
factor bracket
Addonics
T E C H N O L O G I E S
CF Slot 1
Dual CF-SATA HDD Adapter
Model: AD2SAHDCF
CF Slot 2
User’s Guide
Version 1.0
Switch
SATA Power
Connector
SATA Data
Connector
FCC Warning Statement
USB Port
This equipment has been tested and found to comply with the limits for a class B digital
device pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy. If not installed and
used in accordance with the instructions, it may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If the equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment on and off, the user
is encouraged to try and correct the interference by one or more of the following
suggestions.
Note: The default setting for the RAID setting is
BIG. The switch has 3 settings. You slide the switch
from left to right to change RAID setting.
Reorient or relocate the receiving antenna
Increase the distance between the equipment and the receiver
Connect the equipment to a different power outlet other than the one where receiver is
connected
Consult a certified television or radio technician
Steps to configure a SAFE RAID set using USB connection (Windows XP)
Screenshot of Disk Management and 57xx SteelVine Manager showing CF card
status
1. Open the 57xx SteelVine Manager.
Initial unallocated
CF card capacity
Initial BIG RAID
Setting
2. Insert the 2 CF cards to the CF slots on the AD2SAHDCF.
3. Connect the USB cable to the AD2SAHDCF. The 57xx SteelVine Manager
detects the 2 CF cards in the AD2SAHDCF.
CF cards
CF cards
5. Unplug the USB cable.
6. Place the switch to SAFE mode.
7. Plug back the USB cable to confirm the SAFE RAID setting.
4. Open Disk Management to check that both CF cards are detected.
New unallocated CF
card capacity for
SAFE RAID setting
CF cards
New SAFE
RAID Setting
*You will see an unallocated or partition depending if the CF card had been used.
Delete the partition to make it into one BIG virtual disk.
8. To rebuild the SAFE RAID set, go to Action > Start Rebuild > Drive 1
Technical Support
If you need assistance to get your unit functioning properly, please call Addonics
Technical Support. Our technical staff will be happy to assist you, but they will
need your help to do so. Calling the technical support staff without all the proper
information can be both time consuming and frustrating. Here are some tips to
help you out:
MODEL NUMBER – Please have this number on hand.
SYSTEM INFORMATION – Type of computer, peripherals, etc.
OPERATING SYSTEM – What version of Windows
WHAT’S THE TROUBLE? – Give enough information
about your problem so that we can recreate and diagnose it.
FREE Software Drivers for all Addonics Technologies
Products are available 24 hours per day at the
Once Rebuild is done, this is the result.
Contact Information
Phone:
Fax:
408-433-3899
408-433-3898
New SAFE
Email:
Internet:
RAID Setting
TECHNICAL SUPPORT
Phone:
Hours:
Email:
408-433-3855
8:30 am - 6:00 pm PST
Note: The steps for creating BIG or FAST RAID set would be similar with
the steps on creating SAFE RAID set. Only select the correct
switch setting.
|