AMX Switch RDM 2SWM User Manual

Installation Sheet  
RDM-2SWMDual Switch Module 20A  
Specifications  
The RDM-2SWM Dual Switch Module is a 20 A general-purpose relay  
module built for the economical switching of incandescent lamps, switched  
low-voltage transformers, switched fans, and small motors. It uses positive  
air gap relays. The RDM-2SWM is designed for use with the RDA series of  
enclosures, in an AMX Lighting™ modular digital dimming system. This  
module's 120, 240, and 277 VAC ratings are CE, UL, and C-UL approved.  
Dimensions (HW): 10.00" x 2.75" (25.40 cm x 6.99 cm)  
Non-phase dependant  
Use wires rated at 75°C (167°F)  
Torque terminals to 7 in-lbs. (0.8 N/M)  
Max. wire size: 10 AWG (4 mm²)  
Wire stripping length: 0.28" (7 mm)  
Weight: 0.75 lbs. (0.34 kg)  
Mounting  
points  
BTU/hr: 5 each, 10 total  
Control current: 85 mA per relay (170 mA total) @ 12 VDC  
Line in (hot)  
Caution: Pre-Installation Notes  
All Class 1 wiring must be connected to proper terminals.  
All control wiring must be connected to proper terminals.  
Disconnect power while installing or connecting the unit.  
Keep top and bottom air vents clear at all times.  
Test loads for shorts before connecting.  
Use low-voltage wires with a 300 volt rating or greater.  
Use field installed copper conductors.  
All electrical ratings are for continuous duty.  
High-voltage  
connections  
Load out  
Relay A  
Relay B  
For indoor use only.  
This module may require extra power from the AXlink connection or an  
external power supply connected to the control card.  
Connecting the RDM-2SWM to the AMX Lighting Master  
Pin 4 (GND)  
Pin 3 (RLY)  
Pin 2 (DIM)  
Pin 1 (+12 V)  
RDM-2SWM 4-pin module connector  
3 (-)  
Low-voltage control wiring:  
4-pin connection to AMX  
Lighting master controller  
1 (+)  
4-pin plug from RDM series module  
NOTE: The 4-pin plugs from the module connector to  
the 4-pin connector on the master (black plug cover facing up).  
FIG. 2 RDM-2SWM connections  
FIG. 1 RDM-2SWM Dual Switch Module  
RDM-2SWM UL and C-UL Ratings (per circuit)  
General purpose: 2400 W  
Resistive: 2400 W  
Ballast: 2400 W  
Motor: 277 VAC, 1 hp  
Suggested Switched Loads  
Incandescent  
Low-voltage  
Motors  
Switched outlets  
Fluorescent  
 

Agilent Technologies Stereo System N9030a User Manual
Agri Fab Lawn Aerator 45 0298 User Manual
Akai Flat Panel Television ALD1570 User Manual
Allied Telesis Switch x900 48 series User Manual
Altinex Switch MX2414RM User Manual
Apple MP3 Player MC903LL A User Manual
Atlona Cable Box AT COMP13 User Manual
Axis Communications Printer Axis NPS 550 User Manual
Axis Communications Security Camera P1343 User Manual
Bakers Pride Oven Gas Grill CG User Manual