®
NetVanta 56K/64K Network Interface Module (NIM)
P/N 1202861L1
Quick Start Guide
NetVanta modules should be installed only in
NetVanta Series products.
WAN-DDS (RJ-48C) CONNECTION PINOUTS
SPECIFICATIONS
Operating Mode
DDS Interface
Pin
1
Name
R1
T1
—
Description
Dedicated DDS (leased line)
Transmit data to Network–Ring 1
Transmit data to Network–Tip 1
Unused
Supported Standards: AT&T TR 62310
4-wire, full-duplex
Receiver Sensitivity: -45 dB, all rates
Data Rates: 56K, 64K, and auto
Connector: RJ-48C
2
3-6
7
T
Receive data from Network–Tip
Receive data from Network–Ring
8
R
Clock Source
Diagnostics
Compliance
Network, internal
CSU and DSU loopbacks
An optional Dial Backup Interface Module (DIM) is
required for dial backup applications.
For a description of the DBU pinouts, refer to the
Quick Start Guide included with your DIM
shipment.
FCC Part 15 Class A, EN 55022 Class A
ACTA/FCC Part 68
UL/CUL 60950, IC CS-03
Physical
Dimensions: 2.75-inch W x 4.25-inch D
Operating Temperature: 0°C to 50°C
Storage Temperature: -20°C to 70°C
Relative Humidity: Up to 95 percent, noncondensing
Important: For additional details on product
features, specifications, installation, and safety, refer
to the appropriate Hardware Installation Guide on
the ADTRAN OS System Documentation CD
shipped with the base unit and available online at
INSTALLATION INSTRUCTIONS
1. Remove power from the unit.
2. Slide the option module into the option slot until the module is firmly
seated against the chassis.
3. Secure the pins at both edges of the module.
4. Connect the cables to the associated device(s).
5. Complete the installation of the base unit.
6. Restore power to the unit.
For NetVanta modules with outside plant
connections, ensure that all cables are
removed from the module before installing
or removing it from the NetVanta chassis.
Quick Start Guide, 61200861L1-13E, July 2006
Technical Support 1-888-4ADTRAN (1-888-423-8726)
Copyright © 2006 ADTRAN, All Rights Reserved
|