ADDONICS TECHNOLOGIES
Model: ADSAIDE44
Installation Guide
Front View
2. Connect the converter board to the SATA connector of
the hard drive.
44-pin IDE Connector
3. (Optional) Connect the IDE ribbon cable to the 44-pin
connector on the converter. The red edge of the ribbon
cable needs to line up to pin 1 marker of the 44-pin
connector. The other end of the ribbon cable will be
connected to your motherboard’s 44-pin IDE channel.
SATA Power and
Data Connector
Master, Slave &
Cable Select
Jumpers
Pin 1 Marker
Jumper Settings
Master
Note:
Slave
Cable Select
To set the SATA hard drive as a Master Device
when connected to an IDE channel, you need to
short the top pins located on the converter by
placing a jumper. As a Slave Device short the
middle pins.
1. Locate the SATA connector of your 2.5” SATA drive.
TECHNICAL SUPPORT
15-pin SATA Power &
7-pin Data Connector
Email:
Internet:
Technical Support (8:30 am to 6:00 pm PST)
Phone:
Email:
408 573-8580
|